The performance of the circuit-based surface-GKP bosonic quantum error correction code under noise due to finite squeezing of the GKP states and photon losses is investigated. The authors show under what conditions fault-tolerant quantum error correction is possible with the surface-GKP code.
Fault-tolerant quantum error correction is essential for implementing quantum algorithms of significant practical importance.In this work, we propose a highly effective use of the surface Gottesman-Kitaev-Preskill (GKP) code, i.e., the surface code consisting of bosonic GKP qubits instead of bare two-level qubits.In our proposal, we use error-corrected two-qubit gates between GKP qubits and introduce a maximum-likelihood decoding strategy for correcting shift errors in the two-GKP-qubit gates.Our proposed decoding reduces the total CNOT failure rate of the GKP qubits, e.g., from 0.87% to 0.36% at a GKP squeezing of 12 dB, compared to the case where the simple closest-integer decoding is used.Then, by concatenating the GKP code with the surface code, we find that the threshold GKP squeezing is given by 9.9 dB under the the assumption that finite squeezing of the GKP states is the dominant noise source.More importantly, we show that a low logical failure rate p L < 10 -7 can be achieved with moderate hardware requirements, e.g., 291 modes and 97 qubits at a GKP squeezing of 12 dB as opposed to 1457 bare qubits for the standard rotated surface code at an equivalent noise level (i.e., p = 0.36%).Such a low failure rate of our surface-GKP code is possible through the use of space-time correlated edges in the matching graphs of the surface-code decoder.Further, all edge weights in the matching graphs are computed dynamically based on analog information from the GKP error correction using the full history of all syndrome measurement rounds.We also show that a highly squeezed GKP state of GKP squeezing 12 dB can be experimentally realized by using a dissipative stabilization method, namely, the big-small-big method, with fairly conservative experimental parameters.Lastly, we introduce a three-level ancilla scheme to mitigate ancilla decay errors during a GKP state preparation.
Bosonic codes provide an alternative option for quantum error correction. An important category of bosonic codes called the Gottesman-Kitaev-Preskill (GKP) code has aroused much interest recently. Theoretically, the error correction ability of the GKP code is limited since it can only correct small shift errors in position and momentum quadratures. A natural approach to promote the GKP error correction for large-scale, fault-tolerant quantum computation is concatenating encoded GKP states with a stabilizer code. The performance of the XZZX surface-GKP code, i.e., the single-mode GKP code concatenated with the XZZX surface code is investigated in this paper under two different noise models. Firstly, in the code-capacity noise model, the asymmetric rectangular GKP code with parameter $\ensuremath{\lambda}$ is introduced. Using the minimum weight perfect matching decoder combined with the continuous-variable GKP information, the optimal threshold of the XZZX-surface GKP code reaches $\ensuremath{\sigma}\ensuremath{\approx}0.67$ when $\ensuremath{\lambda}=2.1$, compared with the threshold $\ensuremath{\sigma}\ensuremath{\approx}0.60$ of the standard surface-GKP code. Secondly, we analyze the shift errors of two-qubit gates in the actual implementation and build the full circuit-level noise model. By setting the appropriate bias parameters, the logical error rate is reduced by several times in some cases. These results indicate the XZZX surface-GKP codes are more suitable for asymmetric concatenation under the general noise models. We also estimate the overhead of the XZZX-surface GKP code which uses about 291 GKP states with the noise parameter 18.5 dB ($\ensuremath{\kappa}/g\ensuremath{\approx}0.71%$) to encode a logical qubit with the error rate $2.53\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}7}$, compared with the qubit-based surface code using 3041 qubits to achieve almost the same logical error rate.
Photon loss somewhat limits fault-tolerant photonic quantum computing. We investigate its effect on finite-energy Gottesman--Kitaev--Preskill (GKP) states by modeling the pure-loss channel directly. We obtain photon-loss threshold estimates for the surface-GKP code using nearest-lattice-point inner GKP decoding and minimum-weight perfect matching for the outer surface code. For GKP states with ε=0.01 and ε=0.05, corresponding to GKP squeezing of 20 and 13dB, the estimated thresholds are γ∗=5.5% (0.24dB) and γ∗=5.9% (0.26dB), respectively. We then introduce an anti-photon-loss inner decoder that compensates for the contraction of the measured quadrature. It increases the corresponding threshold estimates to γ∗=9.8% (0.45dB) and γ∗=6.3% (0.28dB). Our results highlight the importance of accounting for loss-induced lattice contraction in inner decoding and demonstrate that quadrature compensation enhances the photon-loss tolerance of surface-GKP codes for both high- and moderate-quality GKP states, providing a route toward more photon-loss-robust optical quantum computing.
We study the code obtained by concatenating the standard single-mode Gottesman-Kitaev-Preskill (GKP) code with the surface code. We show that the noise tolerance of this surface--GKP code with respect to (Gaussian) displacement errors improves when a single-mode squeezing unitary is applied to each mode, assuming that the identification of quadratures with logical Pauli operators is suitably modified. We observe noise-tolerance thresholds of up to $\ensuremath{\sigma}\ensuremath{\approx}0.58$ shift-error standard deviation when the surface code is decoded without using GKP syndrome information. In contrast, prior results by K. Fukui, A. Tomita, A. Okamoto, and K. Fujii, High-Threshold Fault-Tolerant Quantum Computation with Analog Quantum Error Correction, Phys. Rev. X 8, 021054 (2018) and C. Vuillot, H. Asasi, Y. Wang, L. P. Pryadko, and B. M. Terhal, Quantum error correction with the toric Gottesman-Kitaev-Preskill code, Phys. Rev. A 99, 032344 (2019) report a threshold between $\ensuremath{\sigma}\ensuremath{\approx}0.54$ and $\ensuremath{\sigma}\ensuremath{\approx}0.55$ for the standard (toric, respectively) surface--GKP code. The modified surface--GKP code effectively renders the mode-level physical noise asymmetric, biasing the logical-level noise on the GKP qubits. The code can thus benefit from the resilience of the surface code against biased noise. We use the approximate maximum likelihood decoding algorithm of S. Bravyi, M. Suchara, and A. Vargo, Efficient algorithms for maximum likelihood decoding in the surface code, Phys. Rev. A 90, 032326 (2014) to obtain our threshold estimates. Throughout, we consider an idealized scenario where measurements are noiseless and GKP states are ideal. Our paper demonstrates that Gaussian encodings of individual modes can enhance concatenated codes.
In order to solve practical problems on a quantum computer, it is necessary to use fault-tolerant quantum error correction schemes to overcome noise: the errors arising from imperfections in physical components. The Gottesman-Kitaev-Preskill (GKP) code aims at achieving this in a hardware efficient manner by encoding finite-dimensional logical subspaces in the Hilbert space of one or more continuous variable modes. In near term implementations, however, it is not feasible to eliminate errors entirely, so it is natural to also employ alternative error mitigation techniques together with error correction. In this work, we study a quantum error mitigation method known as probabilistic error cancellation in the context of the GKP code. We compare Steane-type and teleportation-based GKP error correction, and calculate the sampling overheads associated with the technique for square and hexagonal GKP codes. We employ the stabilizer subsystem decomposition for GKP codes to obtain an effective logical channel for noisy operations that is used to express the ideal one of a target logical unitary. We consider noise from finite squeezing on the data and the two ancilla modes, needed for error correction, and examine the relationship between the sampling overhead and the noise for different decoding methods. Our results are calculated for single- and two-qubit GKP Clifford gates and one round of error correction, and show the nontrivial combination of error correction and mitigation in continuous variable codes.
The Gottesman-Kitaev-Preskill (GKP) encoding of a qubit within an oscillator is particularly appealing for fault-tolerant quantum computing with bosons because Gaussian operations on encoded Pauli eigenstates enable Clifford quantum computing with error correction. We show that applying GKP error correction to Gaussian input states, such as vacuum, produces distillable magic states, achieving universality without additional non-Gaussian elements. Fault tolerance is possible with sufficient squeezing and low enough external noise. Thus, Gaussian operations are sufficient for fault-tolerant, universal quantum computing given a supply of GKP-encoded Pauli eigenstates.