Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1905.00131 · MRS Advances

Improving the Time Stability of Superconducting Planar Resonators

Muhammad Shaeer Moeed, C. T. Earnest, J. H. Béjanin, A. S. Sharafeldin, M. Mariantoni

Published Jun 10, 2019• 7 citations
arXivHTMLPDF
DOI
10.1557/adv.2019.262

Related papers

Anomalous Behavior of High Quality Factor Planar Superconducting Resonators

A. Megrant, Zijun Chen, B. Chiaro +19 more

Bulletin of the American Physical Society•Mar 5, 2014•0 citations

All-metal superconducting planar microwave resonator

M. Horsley, Sergey Pereverzev, Jonathon Dubois +8 more

Bulletin of the American Physical Society•Mar 17, 2016•0 citations

Degradation of Quality Factor of Superconducting Resonators by Remaining Metallic Film and Improved Fabrication Process Using Caldera Planarization

Tomoya Irimatsugawa, Hirotake Yamamori, Fuminori Hirayama +9 more

An important figure of merit in microwave superconducting quantum interference device multiplexer (MW-MUX) is the quality factor of superconducting resonators. In advanced industrial science and technology (AIST), the intrinsic quality factor Qi of the resonators in the MW-MUX chips degraded significantly compared to those in the resonator-only chips owing to something during the fabrication process. In this study, we have investigated the damage process by conducting controlled experiments and an SEM-EDX analysis. As a result, we have confirmed that the metallic layers (Pd and Nb) were not removed completely and remained along the edge of the resonator, which resulted in the degradation of Qi. Further, we have invented a new process to overcome this imperfection during the removal of Pd layer using so called “caldera planarization”. The metal line that remained along the edge was not observed in the MW-MUX chips fabricated using this improved process. Finally, we have achieved Qi as high as that of resonator-only chips using the improved process.

IEEE Transactions on Applied Superconductivity•Mar 18, 2019•1 citation

Oscillators utilizing superconducting resonators

Jack L. Stone, WILLIAM H. HARTWIG

•Jan 1, 1967•1 citation

Efficient Measurement of Superconducting Resonators

S. Sendelbach, M. J. A. Stoutimore, Josh Strong +3 more

Bulletin of the American Physical Society•Mar 5, 2014•0 citations

Low-loss millimeter-wave resonators with an improved coupling structure

Alexander Anferov, Shannon P. Harvey, Fanghui Wan +3 more

Abstract Millimeter-wave superconducting resonators are a useful tool for studying quantum device coherence in a new frequency domain. However, improving resonators is difficult without a robust and reliable method for coupling millimeter-wave signals to 2D structures. We develop and characterize a tapered transition structure coupling a rectangular waveguide to a planar slotline waveguide with better than 0.5 dB efficiency over 14 GHz, and use it to measure ground-shielded resonators in the W band (75–110 GHz). Having decoupled the resonators from radiative losses, we consistently achieve single-photon quality factors above 10 5 , with a two-level-system loss limit above 10 6 , and verify the effectiveness of oxide removal treatments to reduce loss. These values are 4–5 times higher than those previously reported in the W band, and much closer to typical planar microwave resonators. The improved losses demonstrated by these on-chip millimeter-wave devices shed new light on quantum decoherence in a different frequency regime, offer increased selectivity for high-frequency detectors, and enables new possibilities for hybrid quantum experiments integrating millimeter-wave frequencies.

arXiv:2311.01670•Superconductor Science and Technology•Jan 26, 2024•7 citations
An important figure of merit in microwave superconducting quantum interference device multiplexer (MW-MUX) is the quality factor of superconducting resonators. In advanced industrial science and technology (AIST), the intrinsic quality factor Qi of the resonators in the MW-MUX chips degraded significantly compared to those in the resonator-only chips owing to something during the fabrication process. In this study, we have investigated the damage process by conducting controlled experiments and an SEM-EDX analysis. As a result, we have confirmed that the metallic layers (Pd and Nb) were not removed completely and remained along the edge of the resonator, which resulted in the degradation of Qi. Further, we have invented a new process to overcome this imperfection during the removal of Pd layer using so called “caldera planarization”. The metal line that remained along the edge was not observed in the MW-MUX chips fabricated using this improved process. Finally, we have achieved Qi as high as that of resonator-only chips using the improved process.
Abstract Millimeter-wave superconducting resonators are a useful tool for studying quantum device coherence in a new frequency domain. However, improving resonators is difficult without a robust and reliable method for coupling millimeter-wave signals to 2D structures. We develop and characterize a tapered transition structure coupling a rectangular waveguide to a planar slotline waveguide with better than 0.5 dB efficiency over 14 GHz, and use it to measure ground-shielded resonators in the W band (75–110 GHz). Having decoupled the resonators from radiative losses, we consistently achieve single-photon quality factors above 10 5 , with a two-level-system loss limit above 10 6 , and verify the effectiveness of oxide removal treatments to reduce loss. These values are 4–5 times higher than those previously reported in the W band, and much closer to typical planar microwave resonators. The improved losses demonstrated by these on-chip millimeter-wave devices shed new light on quantum decoherence in a different frequency regime, offer increased selectivity for high-frequency detectors, and enables new possibilities for hybrid quantum experiments integrating millimeter-wave frequencies.