Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1811.01698 · physica status solidi (b)

An Experimental Proposal to Study Collapse of the Wave Function in Traveling‐Wave Parametric Amplifiers

Thomas H. A. van der Reep, Louk Rademaker, Xavier G. A. Le Large, Ruben H. Guis, Tjerk H. Oosterkamp

Published Dec 17, 2020• 2 citations
arXivHTMLPDF

Abstract

The readout of a microwave qubit state occurs using an amplification chain that enlarges the quantum state to a signal detectable with a classical measurement apparatus. However, at what point in this process is the quantum state really “measured”? To investigate whether the “measurement” takes place in the amplification chain, in which a parametric amplifier is often chosen as the first amplifier, it is proposed to construct a microwave interferometer that has such an amplifier added to each of its arms. Feeding the interferometer with single photons, the interference visibility depends on the gain of the amplifiers and whether a measurement collapse has taken place during the amplification process. The visibility as given by standard quantum mechanics is calculated as a function of gain, insertion loss, and temperature. A visibility of is found in the limit of large gain without considering losses, which is reduced to in case the insertion loss of the amplifiers is at a temperature of . It is shown that if the wave function collapses within the interferometer, the measured visibility is reduced compared with its magnitude predicted by standard quantum mechanics once this collapse process sets in.

DOI
10.1002/pssb.202000567

Related papers

An Experimental Proposal to Study Collapse of the Wave Function in Traveling‐Wave Parametric Amplifiers

Thomas H. A. van der Reep, Louk Rademaker, Xavier G. A. Le Large +2 more

During the process of measurement, quantum signals are amplified to human proportions. The question arises whether this amplification stage is responsible for the reduction of the state vector (also known as collapse of the wave function) during measurement. The cover image shows an artist’s impression of the experiment proposed by Tjerk H. Oosterkamp and co-workers (article number 2000567) to test this hypothesis. A single photon, indicated with sinusoids with a well-determined amplitude, but unknown phase, is amplified within an interferometer. At some gain of the amplifiers the state might collapse unto a state with a well-defined phase. The authors study how they can observe whether a collapse took place within the interferometer, or not.

physica status solidi (b)•Apr 1, 2021•0 citations

Smoothly breaking unitarity : studying spontaneous collapse using two entangled, tuneable, coherent amplifiers

van der Reep

The Copenhagen interpretation of quantum mechanics states that a measurement collapses a wavefunction onto an eigenstate of the corresponding measurement operator. This causes a quantum mechanical wavefunction to break its unitary evolution described by the Schrodinger equation and is the source of the quantum measurement problem. In this thesis we take the first steps to an experiment that might shed light on this century-old problem. We envision a single-microwave-photon interferometer that has a travelling-wave parametric amplifier (TWPA) added to each of its arms. We wonder if the process of amplification of the quantum state causes the wavefunction to collapse, as it might turn into a detector while smoothly increasing the amplifier's gain. To this end we introduce necessary concepts from the field of microwave engineering. Then, we develop a quantum theory to describe TWPAs. This is followed by preliminary calculations on the expected interference visibility of the envisioned interferometer as a function of amplifier gain and losses. Furthermore, we describe how wavefunction collapse might reveal itself in the experimental results. Finally, the thesis describes our efforts to develop a low-loss TWPA based on Josephson junctions.

•Jun 13, 2019•0 citations

Perspective on traveling wave microwave parametric amplifiers

Martina Esposito, Arpit Ranadive, Luca Planat +1 more

Quantum-limited microwave parametric amplifiers are genuine key pillars for rising quantum technologies and, in general, for applications that rely on the successful readout of weak microwave signals by adding only the minimum amount of noise allowed by quantum mechanics. In this Perspective, after providing a brief overview on the different families of parametric microwave amplifiers, we focus on traveling wave parametric amplifiers, underlining the key achievements of the last few years and the present open challenges. We also discuss possible new research directions beyond amplification such as exploring these devices as a platform for multi-mode entanglement generation and for the development of single photon detectors.

arXiv:2107.13033•Applied Physics Letters•Sep 20, 2021•117 citations

Interferometric measurement of quantum noise in a Raman amplifier

R. C. Swanson, Philip R. Battle, John L. Carlsten

How large must the input signal to an amplifier be to dominate the quantum noise introduced during amplification? We attempt to answer this question for a Raman amplifier with an experiment that utilizes a modified Mach-Zender interferometer with an amplifier placed in each leg. The quantum noise added by the amplifiers manifests itself by degrading the visibility of the output fringes from the interferometer. Only an average of a few photons per mode were necessary to achieve good visibility.

Physical Review Letters•Jul 1, 1991•15 citations

Amplification and the wave-particle duality

R. C. Swanson, John L. Carlsten

By utilizing amplifiers in a modified interferometer, both particlelike and wavelike characteristics of single input photons are analyzed theoretically. Quantum theory predicts that proposed measurements on the amplified field will indicate that the single input photon exhibits extremes of both wavelike and particlelike characteristics. The evidence for wavelike behavior is fringe visibility at the output of the interferometer. Anticorrelation between the outputs of the two legs of the interferometer provides the evidence for particlelike behavior. Although quantum noise degrades both the particle-sensitive and the wave-sensitive measurement, no trade-off between the wavelike and the particlelike characteristics takes place. Complementarity, however, is maintained by the quantum noise added during amplification.

Physical Review A•Mar 1, 1993•0 citations

Quantum tomography enhanced through parametric amplification

E. Knyazev, K Yu Spasibko, M V Chekhova +1 more

Quantum tomography is the standard method of reconstructing the Wigner function of quantum states of light by means of balanced homodyne detection. The reconstruction quality strongly depends on the photodetectors quantum efficiency and other losses in the measurement setup. In this article we analyze in detail a protocol of enhanced quantum tomography, proposed by Leonhardt and Paul [ 1 ] which allows one to reduce the degrading effect of detection losses. It is based on phase-sensitive parametric amplification, with the phase of the amplified quadrature being scanned synchronously with the local oscillator phase. Although with sufficiently strong amplification the protocol enables overcoming any detection inefficiency, it was so far not implemented in the experiment, probably due to the losses in the amplifier. Here we discuss a possible proof-of-principle experiment with a traveling-wave parametric amplifier. We show that with the state-of-the-art optical elements, the protocol enables high fidelity tomographic reconstruction of bright non-classical states of light. We consider two examples: bright squeezed vacuum and squeezed single-photon state, with the latter being a non-Gaussian state and both strongly affected by the losses.

arXiv:1708.03820•New Journal of Physics•Nov 10, 2017•26 citations
The readout of a microwave qubit state occurs using an amplification chain that enlarges the quantum state to a signal detectable with a classical measurement apparatus. However, at what point in this process is the quantum state really “measured”? To investigate whether the “measurement” takes place in the amplification chain, in which a parametric amplifier is often chosen as the first amplifier, it is proposed to construct a microwave interferometer that has such an amplifier added to each of its arms. Feeding the interferometer with single photons, the interference visibility depends on the gain of the amplifiers and whether a measurement collapse has taken place during the amplification process. The visibility as given by standard quantum mechanics is calculated as a function of gain, insertion loss, and temperature. A visibility of is found in the limit of large gain without considering losses, which is reduced to in case the insertion loss of the amplifiers is at a temperature of . It is shown that if the wave function collapses within the interferometer, the measured visibility is reduced compared with its magnitude predicted by standard quantum mechanics once this collapse process sets in.
During the process of measurement, quantum signals are amplified to human proportions. The question arises whether this amplification stage is responsible for the reduction of the state vector (also known as collapse of the wave function) during measurement. The cover image shows an artist’s impression of the experiment proposed by Tjerk H. Oosterkamp and co-workers (article number 2000567) to test this hypothesis. A single photon, indicated with sinusoids with a well-determined amplitude, but unknown phase, is amplified within an interferometer. At some gain of the amplifiers the state might collapse unto a state with a well-defined phase. The authors study how they can observe whether a collapse took place within the interferometer, or not.
The Copenhagen interpretation of quantum mechanics states that a measurement collapses a wavefunction onto an eigenstate of the corresponding measurement operator. This causes a quantum mechanical wavefunction to break its unitary evolution described by the Schrodinger equation and is the source of the quantum measurement problem. In this thesis we take the first steps to an experiment that might shed light on this century-old problem. We envision a single-microwave-photon interferometer that has a travelling-wave parametric amplifier (TWPA) added to each of its arms. We wonder if the process of amplification of the quantum state causes the wavefunction to collapse, as it might turn into a detector while smoothly increasing the amplifier's gain. To this end we introduce necessary concepts from the field of microwave engineering. Then, we develop a quantum theory to describe TWPAs. This is followed by preliminary calculations on the expected interference visibility of the envisioned interferometer as a function of amplifier gain and losses. Furthermore, we describe how wavefunction collapse might reveal itself in the experimental results. Finally, the thesis describes our efforts to develop a low-loss TWPA based on Josephson junctions.
Quantum-limited microwave parametric amplifiers are genuine key pillars for rising quantum technologies and, in general, for applications that rely on the successful readout of weak microwave signals by adding only the minimum amount of noise allowed by quantum mechanics. In this Perspective, after providing a brief overview on the different families of parametric microwave amplifiers, we focus on traveling wave parametric amplifiers, underlining the key achievements of the last few years and the present open challenges. We also discuss possible new research directions beyond amplification such as exploring these devices as a platform for multi-mode entanglement generation and for the development of single photon detectors.
By utilizing amplifiers in a modified interferometer, both particlelike and wavelike characteristics of single input photons are analyzed theoretically. Quantum theory predicts that proposed measurements on the amplified field will indicate that the single input photon exhibits extremes of both wavelike and particlelike characteristics. The evidence for wavelike behavior is fringe visibility at the output of the interferometer. Anticorrelation between the outputs of the two legs of the interferometer provides the evidence for particlelike behavior. Although quantum noise degrades both the particle-sensitive and the wave-sensitive measurement, no trade-off between the wavelike and the particlelike characteristics takes place. Complementarity, however, is maintained by the quantum noise added during amplification.
Quantum tomography is the standard method of reconstructing the Wigner function of quantum states of light by means of balanced homodyne detection. The reconstruction quality strongly depends on the photodetectors quantum efficiency and other losses in the measurement setup. In this article we analyze in detail a protocol of enhanced quantum tomography, proposed by Leonhardt and Paul [ 1 ] which allows one to reduce the degrading effect of detection losses. It is based on phase-sensitive parametric amplification, with the phase of the amplified quadrature being scanned synchronously with the local oscillator phase. Although with sufficiently strong amplification the protocol enables overcoming any detection inefficiency, it was so far not implemented in the experiment, probably due to the losses in the amplifier. Here we discuss a possible proof-of-principle experiment with a traveling-wave parametric amplifier. We show that with the state-of-the-art optical elements, the protocol enables high fidelity tomographic reconstruction of bright non-classical states of light. We consider two examples: bright squeezed vacuum and squeezed single-photon state, with the latter being a non-Gaussian state and both strongly affected by the losses.