Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1805.09364 · Quantum

Anomalous Weak Values Without Post-Selection

Alastair A. Abbott, Ralph Silva, Julian Wechs, Nicolas Brunner, Cyril Branciard

Published Oct 14, 2019• 14 citations
arXivHTMLPDF

Abstract

A weak measurement performed on a pre- and post-selected quantum system can result in an average value that lies outside of the observable's spectrum. This effect, usually referred to as an ``anomalous weak value'', is generally believed to be possible only when a non-trivial post-selection is performed, i.e., when only a particular subset of the data is considered. Here we show, however, that this is not the case in general: in scenarios in which several weak measurements are sequentially performed, an anomalous weak value can be obtained without post-selection, i.e., without discarding any data. We discuss several questions that this raises about the subtle relation between weak values and pointer positions for sequential weak measurements. Finally, we consider some implications of our results for the problem of distinguishing different causal structures.

DOI
10.22331/q-2019-10-14-194

Related papers

Experimental observation of an anomalous weak value without post-selection

Mu Yang, Qiang Li, Zhenghao Liu +5 more

Weak measurement has been shown to play important roles in the investigation of both fundamental and practical problems. Anomalous weak values are generally believed to be observed only when post-selection is performed, i.e., only a particular subset of the data is considered. Here, we experimentally demonstrate that an anomalous weak value can be obtained without discarding any data by performing a sequential weak measurement on a single-qubit system. By controlling the blazing density of the hologram on a spatial light modulator, the measurement strength can be conveniently controlled. Such an anomalous phenomenon disappears when the measurement strength of the first observable becomes strong. Moreover, we find that the anomalous weak value cannot be observed without post-selection when the sequential measurement is performed on each of the components of a two-qubit system, which confirms that the observed anomalous weak value is based on sequential weak measurement of two noncommutative operators.

arXiv:1911.10958•Photonics Research•Jul 7, 2020•3 citations

Transition between weak and strong measurements in the presence of post-selection

Shogo Hanashiro, Holger F. Hofmann

In the weak measurement regime, post-selection can result in the observation of anomalous weak values, seemingly contradicting the eigenvalue statistics observed when the measurement interaction is strong. Here, we investigate the dependence of meter statistics on measurement strength in a post-selected measurement. We find that the meter statistics in the intermediate regime between weak and strong measurements is nearly independent of measurement strength and show that, in this regime, the system performs a measurement of momentum on the meter. Our results show that post-selection is extremely sensitive to the action of the meter on the system, highlighting the difference between the weak measurement regime where this back-action is negligible and the average meter position is a valid measurement result, and the intermediate regime where the meter statistics should not be misinterpreted as a measurement outcome. The transition between weak values and eigenvalues is facilitated by a reversal of the roles of the system and the meter, where the post-selection acts as a readout of information about the meter. The intermediate measurement regime thus reveals that the apparent contradictions between anomalous weak values and eigenvalues originate from the non-classical effects of back-action on the post-selected meter statistics.

quant-pharXiv:2609.04812•Sep 7, 2026•0 citations

Conditions for Anomalous Weak Value

Arun Kumar Pati, Junde Wu

We show that the weak value of any observable in pre- and post-selected states can be expressed as the sum of the average of the observable in the pre-selected state and an anomalous part. We argue that at a fundamental level the anomalous nature of the weak values arises due to the interference between the post-selected state and another quantum state which is orthogonal to the pre-selected state. This provides a necessary and sufficient condition for the anomalous nature of the weak value of a quantum observable. Furthermore, we prove that for two non-commuting observables the product of their anomalous parts cannot be arbitrarily large.

arXiv:1410.5221•Oct 20, 2014•10 citations

Pre- and post-selection, weak values and contextuality

Jeff Tollaksen

By analysing the concept of contextuality (Bell–Kochen–Specker) in terms of pre- and post-selection, it is possible to assign definite values to observables in a new and surprising way. Physical reasons are presented for restrictions on these assignments. When measurements are performed which do not disturb the pre- and post-selection (i.e. weak measurements), then novel experimental aspects of contextuality can be demonstrated. We also prove that every PPS-paradox with definite predictions directly implies 'quantum contextuality' which is introduced as the analogue of contextuality at the level of quantum mechanics rather than at the level of hidden variable theories. Finally, we argue that certain results of these measurements (e.g. eccentric weak values outside the eigenvalue spectrum) cannot be explained by a 'classical-like' hidden variable theory.

arXiv:quant-ph/0602226•Journal of Physics A Mathematical and Theoretical•Jul 12, 2007•64 citations

Order Symmetry of Weak Measurements

Lars M. Johansen, Pier A. Mello

Weak values are usually associated with weak measurements of an observable on a pre- and post-selected ensemble. We show that more generally, weak values are proportional to the correlation between two pointers in a successive measurement. We show that this generalized concept of weak measurements displays a symmetry under reversal of measurement order. We show that the conditions for order symmetry are the same as in classical mechanics. We also find that the imaginary part of the weak value has a counterpart in classical mechanics. This scheme suggests new experimental possibilities.

arXiv:0907.5437•Jul 30, 2009•0 citations

Experimental realization of robust weak measurements

Enrico Rebufello, Fabrizio Piacentini, Alessio Avella +7 more

Despite being very influential on both foundations and applications of quantum mechanics, weak values are still somewhat controversial. Although there are some indications that weak values are physical properties of a single quantum system, the common way weak values are presented is statistical: it is commonly believed that for measuring weak values one has to perform many weak measurements over a large ensemble of pre- and postselected particles. Other debates surround the anomalous nature of weak value and even their quantumness. To address these issues, we present some preliminary data showing that anomalous weak values can be measured using just a single detection, i.e. with no statistics. In our experiment, a single click of a detector indicates the weak value as a single photon property, which moreover lies well beyond the range of eigenvelues of the measured operator. Importantly, the uncertainty with which the weak values is measured is smaller than the difference between the weak value and the closet eigenvalue. This is the first experimental realization of robust weak measurements.

Optical and Quantum Sensing and Precision Metrology II•Feb 25, 2020•0 citations
A weak measurement performed on a pre- and post-selected quantum system can result in an average value that lies outside of the observable's spectrum. This effect, usually referred to as an ``anomalous weak value'', is generally believed to be possible only when a non-trivial post-selection is performed, i.e., when only a particular subset of the data is considered. Here we show, however, that this is not the case in general: in scenarios in which several weak measurements are sequentially performed, an anomalous weak value can be obtained without post-selection, i.e., without discarding any data. We discuss several questions that this raises about the subtle relation between weak values and pointer positions for sequential weak measurements. Finally, we consider some implications of our results for the problem of distinguishing different causal structures.
Weak measurement has been shown to play important roles in the investigation of both fundamental and practical problems. Anomalous weak values are generally believed to be observed only when post-selection is performed, i.e., only a particular subset of the data is considered. Here, we experimentally demonstrate that an anomalous weak value can be obtained without discarding any data by performing a sequential weak measurement on a single-qubit system. By controlling the blazing density of the hologram on a spatial light modulator, the measurement strength can be conveniently controlled. Such an anomalous phenomenon disappears when the measurement strength of the first observable becomes strong. Moreover, we find that the anomalous weak value cannot be observed without post-selection when the sequential measurement is performed on each of the components of a two-qubit system, which confirms that the observed anomalous weak value is based on sequential weak measurement of two noncommutative operators.
In the weak measurement regime, post-selection can result in the observation of anomalous weak values, seemingly contradicting the eigenvalue statistics observed when the measurement interaction is strong. Here, we investigate the dependence of meter statistics on measurement strength in a post-selected measurement. We find that the meter statistics in the intermediate regime between weak and strong measurements is nearly independent of measurement strength and show that, in this regime, the system performs a measurement of momentum on the meter. Our results show that post-selection is extremely sensitive to the action of the meter on the system, highlighting the difference between the weak measurement regime where this back-action is negligible and the average meter position is a valid measurement result, and the intermediate regime where the meter statistics should not be misinterpreted as a measurement outcome. The transition between weak values and eigenvalues is facilitated by a reversal of the roles of the system and the meter, where the post-selection acts as a readout of information about the meter. The intermediate measurement regime thus reveals that the apparent contradictions between anomalous weak values and eigenvalues originate from the non-classical effects of back-action on the post-selected meter statistics.
We show that the weak value of any observable in pre- and post-selected states can be expressed as the sum of the average of the observable in the pre-selected state and an anomalous part. We argue that at a fundamental level the anomalous nature of the weak values arises due to the interference between the post-selected state and another quantum state which is orthogonal to the pre-selected state. This provides a necessary and sufficient condition for the anomalous nature of the weak value of a quantum observable. Furthermore, we prove that for two non-commuting observables the product of their anomalous parts cannot be arbitrarily large.
By analysing the concept of contextuality (Bell–Kochen–Specker) in terms of pre- and post-selection, it is possible to assign definite values to observables in a new and surprising way. Physical reasons are presented for restrictions on these assignments. When measurements are performed which do not disturb the pre- and post-selection (i.e. weak measurements), then novel experimental aspects of contextuality can be demonstrated. We also prove that every PPS-paradox with definite predictions directly implies 'quantum contextuality' which is introduced as the analogue of contextuality at the level of quantum mechanics rather than at the level of hidden variable theories. Finally, we argue that certain results of these measurements (e.g. eccentric weak values outside the eigenvalue spectrum) cannot be explained by a 'classical-like' hidden variable theory.
Weak values are usually associated with weak measurements of an observable on a pre- and post-selected ensemble. We show that more generally, weak values are proportional to the correlation between two pointers in a successive measurement. We show that this generalized concept of weak measurements displays a symmetry under reversal of measurement order. We show that the conditions for order symmetry are the same as in classical mechanics. We also find that the imaginary part of the weak value has a counterpart in classical mechanics. This scheme suggests new experimental possibilities.
Despite being very influential on both foundations and applications of quantum mechanics, weak values are still somewhat controversial. Although there are some indications that weak values are physical properties of a single quantum system, the common way weak values are presented is statistical: it is commonly believed that for measuring weak values one has to perform many weak measurements over a large ensemble of pre- and postselected particles. Other debates surround the anomalous nature of weak value and even their quantumness. To address these issues, we present some preliminary data showing that anomalous weak values can be measured using just a single detection, i.e. with no statistics. In our experiment, a single click of a detector indicates the weak value as a single photon property, which moreover lies well beyond the range of eigenvelues of the measured operator. Importantly, the uncertainty with which the weak values is measured is smaller than the difference between the weak value and the closet eigenvalue. This is the first experimental realization of robust weak measurements.