We provide an experimental demonstration of a direct fiber-optic link for RF transmission (“radio-over-fiber”) using a sensitive optical antenna based on a rubidium vapor cell. The scheme relies on measuring the transmission of laser light at an electromagnetically induced transparency resonance that involves highly excited Rydberg states. By dressing pairs of Rydberg states using microwave fields that act as local oscillators, we encoded RF signals in the optical frequency domain. The light carrying the information is linked via a virtually lossless optical fiber to a photodetector where the signal is retrieved. We demonstrate a signal bandwidth in excess of 1 MHz limited by the available coupling laser power and atomic optical density. Our sensitive, non-metallic and readily scalable optical antenna for microwaves allows extremely low-levels of optical power (∼1 μW) throughput in the fiber-optic link. It offers a promising future platform for emerging wireless network infrastructures.
We provide an experimental demonstration of a direct fiber-optic link for RF transmission (“radio-over-fiber”) using a sensitive optical antenna based on a rubidium vapor cell. The scheme relies on measuring the transmission of laser light at an electromagnetically induced transparency resonance that involves highly excited Rydberg states. By dressing pairs of Rydberg states using microwave fields that act as local oscillators, we encoded RF signals in the optical frequency domain. The light carrying the information is linked via a virtually lossless optical fiber to a photodetector where the signal is retrieved. We demonstrate a signal bandwidth in excess of 1 MHz limited by the available coupling laser power and atomic optical density. Our sensitive, non-metallic and readily scalable optical antenna for microwaves allows extremely low-levels of optical power (∼1 μW) throughput in the fiber-optic link. It offers a promising future platform for emerging wireless network infrastructures.
Significant progress has been made in recent years demonstrating an all-optical high sensitivity Radio Frequency (RF) sensor exploiting the Electromagnetically Induced Transparency (EIT) effect in an atomic vapor. Rydberg RF sensors have previously been shown to exhibit excellent lab-based performance in measuring electric field properties. As a commercial network operator we wish to exploit these capabilities to produce a rugged high-sensitivity receiver for 5G signals, so we seek simple planning rules applicable to readily available low cost components. We present a simple analytic model for the operation of a sensitive Rydberg RF receiver to predict the optical modulation in response to an RF signal. We focus on maximizing the contrast in the optical response to a modulated RF signal rather than to a constant RF field. We show that the optical modulation depth can be maximized using an optimum coupling intensity. The optical modulation depth drops off rapidly as the RF source is detuned away from resonance. By detuning the coupling frequency to compensate for the RF detuning we demonstrate that the useful RF bandwidth of the receiver can be significantly extended. We measure this variation in optical response using a Rubidium vapor at a 15 GHz RF carrier frequency. Using readily available optical components we obtain good agreement with our model. This convenient analytic approach will simplify the design and operation of Rydberg RF receivers as sensitive components in future 5G mobile communications, particularly for the power-limited uplink from mobile device to base-station.
Rydberg atoms, with one highly excited, nearly ionized electron, have extreme sensitivity to electric fields, including microwave fields ranging from 100 MHz to over 1 THz. Here, we show that room-temperature Rydberg atoms can be used as sensitive, high bandwidth, microwave communication antennas. We demonstrate near photon-shot-noise limited readout of data encoded in amplitude-modulated 17 GHz microwaves, using an electromagnetically induced-transparency (EIT) probing scheme. We measure a photon-shot-noise limited channel capacity of up to 8.2 Mbit s−1 and implement an 8-state phase-shift-keying digital communication protocol. The bandwidth of the EIT probing scheme is found to be limited by the available coupling laser power and the natural linewidth of the rubidium D2 transition. We discuss how atomic communication receivers offer several opportunities to surpass the capabilities of classical antennas.
A highly excited Rydberg atom via electromagnetically induced transparency with two color cascading lasers has extreme sensitivity to electric fields of microwave ranging from 100 MHz to over 1 THz. It can be used as susceptible atom-based microwave communication antennas where the carrier wave usually works exactly resonant to the transition between a pair of adjacent Rydberg states with large electric dipole moment. A technique of superheterodyne with a strong on-resonant local microwave oscillator is employed to induce considerable Autler-Townes splitting where the antennas has a highest dynamic response to another weak target signal microwave carrier. To further improve the sensitivity of atomic antenna in communication, we detune the carrier microwave frequency off resonance forming an asymmetrically optical splitting and fix the coupling laser frequency at the shoulder of the stronger one, and optimize the local field strength simultaneously. It gives a sensitivity of 12.50(04) nVcm−1⋅Hz−1/2. Its enhancement mechanism of sensitivity is also proved by a theoretical simulation.
Up to now, the measurement of radio-frequency (RF) electric field achieved using the electromagnetically-induced transparency (EIT) of Rydberg atoms has proved to be of high-sensitivity and shows a potential to produce a promising atomic RF receiver at resonance between two chosen Rydberg states. In this paper, we study the extension of the feasibility of digital communication via this quantum-based antenna over a continuously tunable RF-carrier at off-resonance. Our experiment shows that the digital communication at a rate of 500 kbps can be performed reliably within a tunable bandwidth of 200 MHz near a 10.22 GHz carrier. Outside of this range, the bit error rate (BER) increases, rising to, for example, 15% at an RF-detuning of ±150 MHz. In the measurement, the time-varying RF field is retrieved by detecting the optical power of the probe laser at the center frequency of RF-induced symmetric or asymmetric Autler-Townes splitting in EIT. Prior to the digital test, we studied the RF-reception quality as a function of various parameters including the RF detuning and found that a choice of linear gain response to the RF-amplitude can suppress the signal distortion. The modulating signal can be decoded at speeds up to 500 kHz in the tunable bandwidth. Our test consolidates the physical basis for reliable communication and spectral sensing over a wider broadband RF-carrier, which paves a way for the concurrent multi-channel communications founded on the same pair of Rydberg states.
Rydberg atom based sensors allow for SI traceable measurements and show promise for applications in the field of communication and radar technologies. In this article, we investigate the bandwidth and sensitivity of a Rydberg atom-based sensor in a rubidium vapor cell using Rydberg electromagnetically induced transparency (EIT) spectroscopy. We employ a radio-frequency (RF) heterodyne measurement technique in combination with an optical homodyne setup to extend the achievable range between sensitivity and bandwidth in a Rydberg sensor. While the bandwidth of Rydberg sensors are limited by the transit time of atoms and the Rabi frequency of the coupling field, achieving higher bandwidth through smaller beam sizes is thought to compromise sensitivity due to reduced EIT signal strength. Using optical homodyne detection, we demonstrate that sensitivity is preserved while achieving a response bandwidth of 8 MHz. In addition, using the Rydberg sensor, we receive digital communication signals and present error vector magnitude (EVM) measurements as a function of varying symbol rates and bandwidth of the Rydberg sensor. Furthermore, the sensor's performance is compared with a conventional RF mixer. We establish that the bandwidth of a Rydberg sensor when receiving a pure tone is not the same as the bandwidth of the sensor when receiving a modulated signal. This difference results from the spreading of symbols in the frequency domain, leading to a reduction of the signal to noise ratio (SNR) and an accumulation of noise over the total span of the modulated signal.
Significant progress has been made in atom-based measurements of length, time, gravity and electromagnetic fields in recently years. Rydberg atom-based microwave electric field measurement, using electromagnetically induced transparency (EIT) in room temperature alkali-metal vapors, has been extensively investigated and aroused the broad interest. This approach may establish a new standard for the measurements of microwave (MW) and radio frequency (RF) electric fields.In this review, we describe the work on a new method of measuring electric fields based on quantum interference by using either cesium or rubidium atoms contained in a dielectric vapor cell. Rydberg atoms with principal quantum number n >>1 have large direct current (DC) polarizabilities and microwave transition dipole moments, thereby making them extremely sensitive to external electric fields. Using the Rydberg three-level EIT to detect the level splitting and shift that is induced by the external field, we can realize a rapid and robust self-calibration method of measuring the electric field in a frequency range from 0.01 GHz to 1000 GHz. For the MW electric field (frequency range > 1 GHz), the MW field causes the Rydberg states to split, known as an Autler-Townes splitting (A-T) effect when the applied microwave can resonate with adjacent Rydberg states. The MW coupled A-T splitting is proportional to the applied electric field strength, from which the field strength is measured. Using the EIT window, a high sensitivity of 3 μV·cm-1·Hz-1/2 and small electric field of 1 μV/cm are expected to be achieved with a modest setup, and the limitations of the sensitivity are also addressed in the review. For the RF field at frequency mj EIT lines, and avoided crossings formed with the fine-structure levels of equal mj and different J's, which is used to calibrate and measure the RF field amplitude. On the other hand, the dependence of the EIT-line strength on the RF field polarization provides a fast and robust polarization measurement of RF fields based on matching experimental data with a theoretical simulation. The measurements of minimum strengths and sensitivity of RF fields based on Rydberg atoms are one order magnitude below the values obtained by traditional antenna methods. The atom-based field measurement paves the way for determining fields through calibration-free, invariable atomic properties and miniaturization. We also propose its various potential applications in the future.