Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1801.00467 · Physical Review Letters

Distinguishing Coherent and Thermal Photon Noise in a Circuit Quantum Electrodynamical System

Fei Yan, Dan Campbell, Philip Krantz, Morten Kjærgaard, David K. Kim, Jonilyn Yoder, David J. Hover, Adam Sears, Andrew J. Kerman, Terry P. Orlando, Simon Gustavsson, William D. Oliver

Published Jun 29, 2018• 117 citations
arXivHTMLPDF

Abstract

In the cavity-QED architecture, photon number fluctuations from residual cavity photons cause qubit dephasing due to the ac Stark effect. These unwanted photons originate from a variety of sources, such as thermal radiation, leftover measurement photons, and cross talk. Using a capacitively shunted flux qubit coupled to a transmission line cavity, we demonstrate a method that identifies and distinguishes coherent and thermal photons based on noise-spectral reconstruction from time-domain spin-locking relaxometry. Using these measurements, we attribute the limiting dephasing source in our system to thermal photons rather than coherent photons. By improving the cryogenic attenuation on lines leading to the cavity, we successfully suppress residual thermal photons and achieve T_{1}-limited spin-echo decay time. The spin-locking noise-spectroscopy technique allows broad frequency access and readily applies to other qubit modalities for identifying general asymmetric nonclassical noise spectra.

DOI
10.1103/physrevlett.120.260504

Related papers

Two-Qubit Spectroscopy of Spatiotemporally Correlated Quantum Noise in Superconducting Qubits

Uwe von Lüpke, Félix Beaudoin, Leigh Norris +9 more

Noise that exhibits significant temporal and spatial correlations across multiple qubits can be especially harmful to both fault-tolerant quantum computation and quantum-enhanced metrology.However, a complete spectral characterization of the noise environment of even a two-qubit system has not been reported thus far.We propose and experimentally demonstrate a protocol for two-qubit dephasing noise spectroscopy based on continuous-control modulation.By combining ideas from spin-locking relaxometry with a statistically motivated robust estimation approach, our protocol allows for the simultaneous reconstruction of all the single-qubit and two-qubit cross-correlation spectra, including access to their distinctive nonclassical features.Only single-qubit control manipulations and state-tomography measurements are employed, with no need for entangled-state preparation or readout of two-qubit observables.While our experimental demonstration uses two superconducting qubits coupled to a shared, colored engineered noise source, our methodology is portable to a variety of dephasing-dominated qubit architectures.By pushing quantum noise spectroscopy beyond the single-qubit setting, our work heralds the characterization of spatiotemporal correlations in both engineered and naturally occurring noise environments.

arXiv:1912.04982•PRX Quantum•Sep 3, 2020•103 citations

Qubit-photon interactions in a cavity: Measurement-induced dephasing and number splitting

Jay Gambetta, Alexandre Blais, David Schuster +6 more

We theoretically study measurement-induced dephasing of a superconducting qubit in the circuit QED architecture and compare the results to those obtained experimentally by Schuster et al. [Phys. Rev. Lett. 94, 123602 (2005)]. Strong coupling of the qubit to the resonator leads to a significant ac Stark shift of the qubit transition frequency. As a result, quantum fluctuations in the photon number populating the resonator cause dephasing of the qubit. We find good agreement between the predicted line shape of the qubit spectrum and the experimental results. Furthermore, in the strongly dispersive limit, where the Stark shift per photon is large compared to the cavity decay rate and the qubit linewidth, we predict that the qubit spectrum will be split into multiple peaks, with each peak corresponding to a different number of photons in the cavity.

arXiv:cond-mat/0602322•Physical Review A•Oct 17, 2006•445 citations

Qubit Noise Sensing via Induced Photon Loss in a Superconducting Cavity

Nitzan Kahn, Dror Garti, Uri Goldblatt +3 more

Characterizing noise in superconducting qubits is essential for improving coherence and gate performance. Conventional noise-sensing methods typically use the qubit itself as the sensor, which limits both accessible bandwidth and applicability during driven operation. Here, we measure qubit frequency noise by detecting the photon loss it induces in a coupled high-Q superconducting cavity. We use repeated mid-circuit qubit measurements with post-selection to separate this induced loss from intrinsic cavity decay. We validate the protocol using injected noise and show that the extracted loss scales as expected with the applied noise strength. We place an upper bound of $0.70\times10^3\,\mathrm{rad}^2/\mathrm{s}$ on the intrinsic qubit frequency-noise power spectral density at the cavity-qubit detuning of 508 MHz. The protocol opens access to a higher-frequency spectral window than standard qubit-based spectroscopy and may enable noise characterization during strong driving.

quant-pharXiv:2603.06848•Physical Review Letters•Mar 10, 2026•1 citation

Multiqubit spectroscopy of Gaussian quantum noise

Gerardo A. Paz-Silva, Leigh Norris, Lorenza Viola

We introduce multipulse quantum noise spectroscopy protocols for spectral estimation of the noise affecting multiple qubits coupled to Gaussian dephasing environments including both classical and quantum sources. Our protocols are capable of reconstructing all the noise auto- and cross-correlation spectra entering the multiqubit dynamics, providing access, in particular, to the asymmetric spectra associated with nonclassical environments. Our result relies on (i) an exact analytic solution for the reduced multiqubit dynamics that holds in the presence of an arbitrary Gaussian environment and dephasing-preserving control; (ii) the use of specific timing symmetries, which allow for a frequency comb to be engineered for all filter functions of interest, and for the spectra to be related to experimentally accessible observables. We show that quantum spectra have distinctive dynamical signatures, which we explore in two paradigmatic open-system models describing spin and charge qubits coupled to bosonic environments. Complete noise spectroscopy is demonstrated numerically in a realistic setting consisting of two-exciton qubits coupled to a phonon bath. The estimated spectra allow us to accurately predict the exciton dynamics as well as extract the temperature and spectral density of the quantum environment.

arXiv:1609.01792•Physical Review A•Feb 23, 2017•127 citations

Dephasing of a Superconducting Qubit Induced by Photon Noise

Patrice Bertet, I. Chiorescu, Guido Burkard +4 more

We have studied the dephasing of a superconducting flux qubit coupled to a dc-SQUID based oscillator. By varying the bias conditions of both circuits we were able to tune their effective coupling strength. This allowed us to measure the effect of such a controllable and well-characterized environment on the qubit coherence. We can quantitatively account for our data with a simple model in which thermal fluctuations of the photon number in the oscillator are the limiting factor. In particular, we observe a strong reduction of the dephasing rate whenever the coupling is tuned to zero. At the optimal point we find a large spin-echo decay time of .

arXiv:cond-mat/0512428•Physical Review Letters•Dec 13, 2005•316 citations

Photon shot noise dephasing in the strong-dispersive limit of circuit QED

Adam Sears, Andrei Petrenko, Gianluigi Catelani +7 more

We study the photon shot noise dephasing of a superconducting transmon qubit in the strong-dispersive limit, due to the coupling of the qubit to its readout cavity. As each random arrival or departure of a photon is expected to completely dephase the qubit, we can control the rate at which the qubit experiences dephasing events by varying in situ the cavity mode population and decay rate. This allows us to verify a pure dephasing mechanism that matches theoretical predictions, and in fact explains the increased dephasing seen in recent transmon experiments as a function of cryostat temperature. We observe large increases in coherence times as the cavity is decoupled from the environment, and after implementing filtering find that the intrinsic coherence of small Josephson junctions when corrected with a single Hahn echo is greater than several hundred microseconds. Similar filtering and thermalization may be important for other qubit designs in order to prevent photon shot noise from becoming the dominant source of dephasing.

arXiv:1206.1265•Physical Review B•Nov 12, 2012•157 citations
In the cavity-QED architecture, photon number fluctuations from residual cavity photons cause qubit dephasing due to the ac Stark effect. These unwanted photons originate from a variety of sources, such as thermal radiation, leftover measurement photons, and cross talk. Using a capacitively shunted flux qubit coupled to a transmission line cavity, we demonstrate a method that identifies and distinguishes coherent and thermal photons based on noise-spectral reconstruction from time-domain spin-locking relaxometry. Using these measurements, we attribute the limiting dephasing source in our system to thermal photons rather than coherent photons. By improving the cryogenic attenuation on lines leading to the cavity, we successfully suppress residual thermal photons and achieve T_{1}-limited spin-echo decay time. The spin-locking noise-spectroscopy technique allows broad frequency access and readily applies to other qubit modalities for identifying general asymmetric nonclassical noise spectra.
Noise that exhibits significant temporal and spatial correlations across multiple qubits can be especially harmful to both fault-tolerant quantum computation and quantum-enhanced metrology.However, a complete spectral characterization of the noise environment of even a two-qubit system has not been reported thus far.We propose and experimentally demonstrate a protocol for two-qubit dephasing noise spectroscopy based on continuous-control modulation.By combining ideas from spin-locking relaxometry with a statistically motivated robust estimation approach, our protocol allows for the simultaneous reconstruction of all the single-qubit and two-qubit cross-correlation spectra, including access to their distinctive nonclassical features.Only single-qubit control manipulations and state-tomography measurements are employed, with no need for entangled-state preparation or readout of two-qubit observables.While our experimental demonstration uses two superconducting qubits coupled to a shared, colored engineered noise source, our methodology is portable to a variety of dephasing-dominated qubit architectures.By pushing quantum noise spectroscopy beyond the single-qubit setting, our work heralds the characterization of spatiotemporal correlations in both engineered and naturally occurring noise environments.
We theoretically study measurement-induced dephasing of a superconducting qubit in the circuit QED architecture and compare the results to those obtained experimentally by Schuster et al. [Phys. Rev. Lett. 94, 123602 (2005)]. Strong coupling of the qubit to the resonator leads to a significant ac Stark shift of the qubit transition frequency. As a result, quantum fluctuations in the photon number populating the resonator cause dephasing of the qubit. We find good agreement between the predicted line shape of the qubit spectrum and the experimental results. Furthermore, in the strongly dispersive limit, where the Stark shift per photon is large compared to the cavity decay rate and the qubit linewidth, we predict that the qubit spectrum will be split into multiple peaks, with each peak corresponding to a different number of photons in the cavity.
Characterizing noise in superconducting qubits is essential for improving coherence and gate performance. Conventional noise-sensing methods typically use the qubit itself as the sensor, which limits both accessible bandwidth and applicability during driven operation. Here, we measure qubit frequency noise by detecting the photon loss it induces in a coupled high-Q superconducting cavity. We use repeated mid-circuit qubit measurements with post-selection to separate this induced loss from intrinsic cavity decay. We validate the protocol using injected noise and show that the extracted loss scales as expected with the applied noise strength. We place an upper bound of 0.70×103 rad2/s0.70\times10^3\,\mathrm{rad}^2/\mathrm{s}0.70×103rad2/s on the intrinsic qubit frequency-noise power spectral density at the cavity-qubit detuning of 508 MHz. The protocol opens access to a higher-frequency spectral window than standard qubit-based spectroscopy and may enable noise characterization during strong driving.
We introduce multipulse quantum noise spectroscopy protocols for spectral estimation of the noise affecting multiple qubits coupled to Gaussian dephasing environments including both classical and quantum sources. Our protocols are capable of reconstructing all the noise auto- and cross-correlation spectra entering the multiqubit dynamics, providing access, in particular, to the asymmetric spectra associated with nonclassical environments. Our result relies on (i) an exact analytic solution for the reduced multiqubit dynamics that holds in the presence of an arbitrary Gaussian environment and dephasing-preserving control; (ii) the use of specific timing symmetries, which allow for a frequency comb to be engineered for all filter functions of interest, and for the spectra to be related to experimentally accessible observables. We show that quantum spectra have distinctive dynamical signatures, which we explore in two paradigmatic open-system models describing spin and charge qubits coupled to bosonic environments. Complete noise spectroscopy is demonstrated numerically in a realistic setting consisting of two-exciton qubits coupled to a phonon bath. The estimated spectra allow us to accurately predict the exciton dynamics as well as extract the temperature and spectral density of the quantum environment.
We have studied the dephasing of a superconducting flux qubit coupled to a dc-SQUID based oscillator. By varying the bias conditions of both circuits we were able to tune their effective coupling strength. This allowed us to measure the effect of such a controllable and well-characterized environment on the qubit coherence. We can quantitatively account for our data with a simple model in which thermal fluctuations of the photon number in the oscillator are the limiting factor. In particular, we observe a strong reduction of the dephasing rate whenever the coupling is tuned to zero. At the optimal point we find a large spin-echo decay time of .
We study the photon shot noise dephasing of a superconducting transmon qubit in the strong-dispersive limit, due to the coupling of the qubit to its readout cavity. As each random arrival or departure of a photon is expected to completely dephase the qubit, we can control the rate at which the qubit experiences dephasing events by varying in situ the cavity mode population and decay rate. This allows us to verify a pure dephasing mechanism that matches theoretical predictions, and in fact explains the increased dephasing seen in recent transmon experiments as a function of cryostat temperature. We observe large increases in coherence times as the cavity is decoupled from the environment, and after implementing filtering find that the intrinsic coherence of small Josephson junctions when corrected with a single Hahn echo is greater than several hundred microseconds. Similar filtering and thermalization may be important for other qubit designs in order to prevent photon shot noise from becoming the dominant source of dephasing.