We present a detailed theoretical analysis of the implementation of shortcut-to-adiabaticity protocols for the fast transport of neutral atoms with atom chips.The objective is to engineer transport ramps with durations not exceeding a few hundred milliseconds to provide metrologically relevant input states for an atomic sensor.Aided by numerical simulations of the classical and quantum dynamics, we study the behavior of a Bose-Einstein condensate in an atom chip setup with realistic anharmonic trapping.We detail the implementation of fast and controlled transports over large distances of several millimeters, i.e. distances 1000 times larger than the size of the atomic cloud.A subsequent optimized release and collimation step demonstrates the capability of our transport method to generate ensembles of quantum gases with expansion speeds in the picokelvin regime.The performance of this procedure is analyzed in terms of collective excitations reflected in residual center of mass and size oscillations of the condensate.We further evaluate the robustness of the protocol against experimental imperfections.
We present a detailed theoretical analysis of the implementation of shortcut-to-adiabaticity protocols for the fast transport of neutral atoms with atom chips.The objective is to engineer transport ramps with durations not exceeding a few hundred milliseconds to provide metrologically relevant input states for an atomic sensor.Aided by numerical simulations of the classical and quantum dynamics, we study the behavior of a Bose-Einstein condensate in an atom chip setup with realistic anharmonic trapping.We detail the implementation of fast and controlled transports over large distances of several millimeters, i.e. distances 1000 times larger than the size of the atomic cloud.A subsequent optimized release and collimation step demonstrates the capability of our transport method to generate ensembles of quantum gases with expansion speeds in the picokelvin regime.The performance of this procedure is analyzed in terms of collective excitations reflected in residual center of mass and size oscillations of the condensate.We further evaluate the robustness of the protocol against experimental imperfections.
Using Optimal Control Theory (OCT), we design fast ramps for the controlled transport of Bose-Einstein condensates with atom chips' magnetic traps. These ramps are engineered in the context of precision atom interferometry experiments and support transport over large distances, typically of the order of 1 mm, i.e. about 1,000 times the size of the atomic clouds, yet with durations not exceeding 200 ms. We show that with such transport durations of the order of the trap period, one can recover the ground state of the final trap at the end of the transport. The performance of the OCT procedure is compared to that of a Shortcut-To-Adiabaticity (STA) protocol and the respective advantages/disadvantages of the OCT treatment over the STA one are discussed.
We numerically study the fast spatial transport of a trapped Bose-Einstein condensate (BEC) using shortcuts-to-adiabaticity (STA) by counterdiabatic driving (CD). The trapping potential and the required auxiliary potential were simulated as painted potentials. We compared STA transport to transport that follows a constant-acceleration scheme (CA). Experimentally feasible values of trap depth and atom number were used in the 2D Gross-Pitaevskii equation (GPE) simulations. Different transport times, trap depths, and trap lengths were investigated. In all simulations, there exists a minimum amount of time necessary for fast transport, which is consistent with previous results from quantum speed limit studies.
We present a method to transport Bose-Einstein condensates (BECs) in anharmonic traps and in the presence of atom-atom interactions in short times without residual excitation. Using a combination of a variational approach and inverse engineering methods, we derive a set of Ermakov-like equations that take into account the coupling between the centre of mass motion and the breathing mode. By an appropriate inverse engineering strategy of those equations, we then design the trap trajectory to achieve the desired boundary conditions. Numerical examples for cubic or quartic anharmonicities are provided for fast and high-fidelity transport of BECs. Potential applications are atom interferometry and quantum information processing. This article is part of the theme issue 'Shortcuts to adiabaticity: theoretical, experimental and interdisciplinary perspectives'.
Atom chips are an excellent tool for studying ultracold degenerate quantum gases, due to the high degree of controllability afforded by the precise potentials generated from the current-carrying microfabricated wires on the chip surface. The geometries of the trapping potentials are inherently capable of realising extreme aspect ratios, and therefore creating model systems with effectively reduced dimensionality, particularly the theoretically-tractable one-dimensional Bose gas. In addition, the temporal tunability makes it possible to impart non-adiabatic changes on the trapping potentials, allowing experimental investigation of samples which have been brought out of equilibrium - a situation which is not fully theoretically understood. This thesis describes the implementation, development and characterisation of an experimental system for producing the first Bose-Einstein condensates of atomic rubidium 87 gas trapped on the surface of an atom chip in Nottingham. Such an apparatus is very complex and requires careful characterisation in order to run in a stable and reliable way. Details of the experimental setup are thoroughly outlined, including the vacuum system, lasers, electronics, computer control and timing, and the optical imaging system. A newly installed compact two-dimensional magneto-optical trap provides an loading rate of 5e7 atoms per second for loading a three-dimensional mirror-magneto-optical trap with 1.5e8 atoms, at a temperature of 300uK within 10s. The cloud is then sub-Doppler cooled to 50uK, and spin-polarised with 96% purity into the |F=2,mF=+2> ground state within 5ms, in preparation for loading a purely magnetic trap. A millimeter sized copper Z-shaped conductor located beneath the atom chip surface creates a Ioffe-Pritchard magnetic trap, into which the laser cooled cloud is loaded with 70% efficiency, and can be held with a vacuum-limited lifetime of 40s. Evaporative cooling then pre-cools the sample to below 20uK within 10s, to allow the subsequent loading into potentials created by the atom chip with 100% efficiency. A final evaporation stage then cools the cloud below the phase transition temperature of 800nK, resulting finally in pure BECs with 105 atoms confined using the atom chip. Key measurements of various properties of the trapped condensates are presented, which are important in order to characterise the system fully, and to compare with theoretical expectations. In particular, included are the variation of condensate fraction with temperature, the BEC expansion dynamics, and the condensate lifetime in the trap, for example. Finally, it is demonstrated how BECs can be produced on the atom chip without the use of external macroscopic coils, achieved by using novel, integrated sheet structures located beneath the chip surface - unique to this experimental system - to create the necessary bias fields.
Ultracold atomic gases have proven to be an excellent tool for research in quantum systems. A Bose gas can be trapped on an atom chip using very well defined and tunable spatially-dependent potentials. The proximity of the atoms to the chip permits the use of low currents allowing for highly accurate temporal changes. Excellent experimental apparatus is needed to achieve Bose-Einstein condensation with a sufficient atom number to study low-dimensional physics. The setup described in this document utilises a set of current-carrying structures on top of which an atom chip sits. For improved atom loading rate, a two-dimensional loading stage was added, extending the lifetime of the magnetic trap. From this loading stage to the atom chip, Bose-Einstein condensation of 105 Rubidium-87 atoms was achieved in less than 30 s, allowing for a large rate of experimental cycles. The high spatial and temporal tunability of this setup results in the ability to split the atomic cloud and quench the trapping potential geometry. Maximising the ratio between trapping frequencies for different spatial directions leads to the system presenting features of a one-dimensional gas. Manipulating the coherence dynamics of a one-dimensional Bose-Einstein condensate creates fluctuations in the phase properties of the wavefunction. These fluctuations are observed as atom density perturbations after releasing the trapping potentials, and are a tool for temperature measurements. When the cloud of atoms is positioned at a few tens of micrometres from the surface of the atom chip, corrugations in the microstructures of the chip affect the trapping potentials at very low temperatures 1 µK. This effect is simulated and quantified in the thesis, with the aim of improving future setups. Additionally, the effect is explored for microscopy purposes. The behaviour of a Bose-Einstein condensate, especially the expansion rate, has long been studied. In this thesis, the Gross-Pitaevskii Equation is introduced, finding its numerical solutions to the two-dimensional and three-dimensional forms, using the Split-Step Fourier Method. The results show very good agreement with the experimental results, as well as with other well- established theories of condensates. The creation of such a toolbox opens up the opportunity to further investigate the coherence dynamics of low-dimensional systems.
By definition, quantum adiabatic process means a slow process which allows the state to follow the instantaneous eigenstates of time-dependent Hamiltonian. For some reasons, for example, to avoid the decoherence effects, or to implement large-scale quantum information processing, we may want to speed up the adiabatic process, that is, to achieve the adiabatic-like control but in very short time. In this talk, we present new methods to speeded-up expansion and transport of cold atoms in a harmonic trap. Such shortcuts to adiabaticity provide the fast expansion or transport, in which the final atomic state is the same as in the adiabatic process, but in arbitrarily short time, keeping the same populations of vibrational levels in the initial and final trap. These methods can also be generalized to Bose-Einstein Condensates. Moreover, we present shortcuts to adiabatic passage from one internal atomic state to another in twoor three-level atoms. In detail, we can apply Berry’s transitionless quantum driving method and invariant-based inverse engineering method to accelerate the Rapid Adiabatic Passage (RAP) and Stimulated Raman Adiabatic Passage (STIRAP) in twoand three-level atomic systems, respectively. We also examine and compare the stability of different schemes concerning different types of noise and system errors. Finally, we show that the technique of shortcuts to adiabaticity in two-level system can be applied in fast and robust spin flip in a quantum dot, to avoid the decoherent effects.