Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1703.08371 · Physical Review Letters

Quantum Zeno Effects from Measurement Controlled Qubit-Bath Interactions

P. M. Harrington, Jonathan Monroe, K. W. Murch

Published Jun 14, 2017• 72 citations
arXivHTMLPDF

Abstract

The Zeno and anti-Zeno effects are features of measurement-driven quantum evolution where frequent measurement inhibits or accelerates the decay of a quantum state. Either type of evolution can emerge depending on the system-environment interaction and measurement method. In this experiment, we use a superconducting qubit to map out both types of Zeno effect in the presence of structured noise baths and variable measurement rates. We observe both the suppression and acceleration of qubit decay as repeated measurements are used to modulate the qubit spectrum causing the qubit to sample different portions of the bath. We compare the Zeno effects arising from dispersive energy measurements and purely dephasing "quasimeasurements," showing energy measurements are not necessary to accelerate or suppress the decay process.

DOI
10.1103/physrevlett.118.240401

Related papers

Real measurements and the quantum Zeno effect

Julius Ruseckas, B. Kaulakys

In 1977, Mishra and Sudarshan [J. Math. Phys. 18, 756 (1977)] showed that an unstable particle would never be found decayed while it was continuously observed. They called this effect the quantum Zeno effect (or paradox). Later it was realized that the frequent measurements could also accelerate the decay (quantum anti-Zeno effect). In this paper, we investigate the quantum Zeno effect using the definite model of the measurement. We take into account the finite duration and the finite accuracy of the measurement. A general equation for the jump probability during the measurement is derived. We find that the measurements can cause inhibition (quantum Zeno effect) or acceleration (quantum anti-Zeno effect) of the evolution, depending on the strength of the interaction with the measuring device and on the properties of the system. However, the evolution cannot be fully stopped.

arXiv:quant-ph/0105138•Physical Review A•May 8, 2001•20 citations

Dephasing of Quantum Evolution: Is It Useful?

Abraham G. Kofman, Gershon Kurizki

It is shown that the quantum Zeno effect, i.e., inhibition of spontaneous decay by frequent dephasing (measurements), is observable only in spectrally finite reservoirs, e.g., in cavities, using a sequence of evolution-interrupting pulses or randomly-modulated CW fields. By contrast, non-destructive measurements can only accelerate decay in free space, via the anti-Zeno effect.

Fortschritte der Physik•May 1, 2000•0 citations

Free dynamics and quantum Zeno effect of qubit coupled to a single mode field in dissipation environment

Shan Wu, Hai‐Chao Li, Jiying Zhang +2 more

Abstract We investigate the long time evolution of a qubit coupled to an intrinsic bath and a single mode field which is coupled with a cavity bath, with and without repetitive measurements. We also analyze the measurement-modified decay rate, which shows that the free decay rate does not necessarily exist in some systems. The free decay rate is widely used to distinguish the quantum Zeno effect and anti-Zeno effect (AZE). It indicates that one cannot always make that clear if a decay of a system is accelerated. Our model confirms this conclusion; it shows that the AZE is not a universal concept.

Journal of Physics B Atomic Molecular and Optical Physics•Feb 2, 2017•0 citations

Quantum Zeno dynamics of qubits in a squeezed reservoir: effect of measurement selectivity

Md. Manirul Ali, Po‐Wen Chen, Alec Maassen van den Brink +1 more

A complete suppression of the exponential decay in a qubit (interacting with a squeezed vacuum reservoir) can be achieved by frequent measurements of adequately chosen observables. The observables and initial states (Zeno subspace) for which the effect occurs depend on the squeezing parameters of the bath. We show these_quantum Zeno dynamics_ to be substantially different for selective and non-selective measurements. In either case, the approach to the Zeno limit for a finite number of measurements is also studied numerically. The calculation is extended from one to two qubits, where we see both Zeno and anti-Zeno effects depending on the initial state. The reason for the striking differences with the situation in closed systems is discussed.

arXiv:1302.2477•Feb 11, 2013•0 citations

The Zeno and anti-Zeno effects on decay in dissipative quantum systems

Abraham G. Kofman, Gershon Kurizki

We point out that the quantum Zeno effect, i.e., inhibition of spontaneous decay by frequent measurements, is observable only in spectrally finite reservoirs, i.e., in cavities and waveguides, using a sequence of evolution-interrupting pulses or randomly-modulated CW fields. By contrast, such measurements can only accelerate decay in free space.

arXiv:quant-ph/9912077•Dec 16, 1999•0 citations

Dynamics and quantum Zeno effect for a qubit in either a low- or high-frequency bath beyond the rotating-wave approximation

Xiufeng Cao, J. Q. You, H. Zheng +2 more

We use a non-Markovian approach to study the decoherence dynamics of a qubit in either a low- or high-frequency bath modeling the qubit environment. This is done for two separate cases: either with measurements or without them. This approach is based on a unitary transformation and does not require the rotating-wave approximation. In the case without measurement, we show that, for low-frequency noise, the bath shifts the qubit energy toward higher energies (blue shift), while the ordinary high-frequency cutoff Ohmic bath shifts the qubit energy toward lower energies (red shift). In order to preserve the coherence of the qubit, we also investigate the dynamics of the qubit subject to measurements (quantum Zeno regime) in two cases: low- and high-frequency baths. For very frequent projective measurements, the low-frequency bath gives rise to the quantum anti-Zeno effect on the qubit. The quantum Zeno effect only occurs in the high-frequency-cutoff Ohmic bath, after counterrotating terms are considered. In the condition that the decay rate due to the two kinds of baths are equal under the Wigner-Weisskopf approximation, we find that without the approximation, for a high-frequency environment, the decay rate should be faster (without measurements) or slower (with frequent measurements, in the Zeno regime), compared to the low-frequency bath case. The experimental implementation of our results here could distinguish the type of bath (either a low- or high-frequency one) and protect the coherence of the qubit by modulating the dominant frequency of its environment.

arXiv:1001.4831•Physical Review A•Aug 30, 2010•83 citations
The Zeno and anti-Zeno effects are features of measurement-driven quantum evolution where frequent measurement inhibits or accelerates the decay of a quantum state. Either type of evolution can emerge depending on the system-environment interaction and measurement method. In this experiment, we use a superconducting qubit to map out both types of Zeno effect in the presence of structured noise baths and variable measurement rates. We observe both the suppression and acceleration of qubit decay as repeated measurements are used to modulate the qubit spectrum causing the qubit to sample different portions of the bath. We compare the Zeno effects arising from dispersive energy measurements and purely dephasing "quasimeasurements," showing energy measurements are not necessary to accelerate or suppress the decay process.
In 1977, Mishra and Sudarshan [J. Math. Phys. 18, 756 (1977)] showed that an unstable particle would never be found decayed while it was continuously observed. They called this effect the quantum Zeno effect (or paradox). Later it was realized that the frequent measurements could also accelerate the decay (quantum anti-Zeno effect). In this paper, we investigate the quantum Zeno effect using the definite model of the measurement. We take into account the finite duration and the finite accuracy of the measurement. A general equation for the jump probability during the measurement is derived. We find that the measurements can cause inhibition (quantum Zeno effect) or acceleration (quantum anti-Zeno effect) of the evolution, depending on the strength of the interaction with the measuring device and on the properties of the system. However, the evolution cannot be fully stopped.
Abstract We investigate the long time evolution of a qubit coupled to an intrinsic bath and a single mode field which is coupled with a cavity bath, with and without repetitive measurements. We also analyze the measurement-modified decay rate, which shows that the free decay rate does not necessarily exist in some systems. The free decay rate is widely used to distinguish the quantum Zeno effect and anti-Zeno effect (AZE). It indicates that one cannot always make that clear if a decay of a system is accelerated. Our model confirms this conclusion; it shows that the AZE is not a universal concept.
A complete suppression of the exponential decay in a qubit (interacting with a squeezed vacuum reservoir) can be achieved by frequent measurements of adequately chosen observables. The observables and initial states (Zeno subspace) for which the effect occurs depend on the squeezing parameters of the bath. We show these_quantum Zeno dynamics_ to be substantially different for selective and non-selective measurements. In either case, the approach to the Zeno limit for a finite number of measurements is also studied numerically. The calculation is extended from one to two qubits, where we see both Zeno and anti-Zeno effects depending on the initial state. The reason for the striking differences with the situation in closed systems is discussed.
We use a non-Markovian approach to study the decoherence dynamics of a qubit in either a low- or high-frequency bath modeling the qubit environment. This is done for two separate cases: either with measurements or without them. This approach is based on a unitary transformation and does not require the rotating-wave approximation. In the case without measurement, we show that, for low-frequency noise, the bath shifts the qubit energy toward higher energies (blue shift), while the ordinary high-frequency cutoff Ohmic bath shifts the qubit energy toward lower energies (red shift). In order to preserve the coherence of the qubit, we also investigate the dynamics of the qubit subject to measurements (quantum Zeno regime) in two cases: low- and high-frequency baths. For very frequent projective measurements, the low-frequency bath gives rise to the quantum anti-Zeno effect on the qubit. The quantum Zeno effect only occurs in the high-frequency-cutoff Ohmic bath, after counterrotating terms are considered. In the condition that the decay rate due to the two kinds of baths are equal under the Wigner-Weisskopf approximation, we find that without the approximation, for a high-frequency environment, the decay rate should be faster (without measurements) or slower (with frequent measurements, in the Zeno regime), compared to the low-frequency bath case. The experimental implementation of our results here could distinguish the type of bath (either a low- or high-frequency one) and protect the coherence of the qubit by modulating the dominant frequency of its environment.