We present an in-depth analysis regarding the error resistance and optimization of our all-optical Bell measurement and ultrafast long-distance quantum communication scheme proposed by Ewert, Bergmann, and van Loock [Phys. Rev. Lett. 117, 210501 (2016)]. In order to promote our previous proposal from loss to fault tolerance, we introduce a general and compact formalism that can also be applied to other related schemes {including non-all-optical ones such as that of Muralidharan et al. [Phys. Rev. Lett. 112, 250501 (2014)]}. With the help of this new representation we show that our communication protocol does not only counteract the inevitable photon loss during channel transmission, but is also able to resist common experimental errors such as Pauli-type errors (bit and phase flips) and detector inefficiencies (losses and dark counts). Furthermore, we demonstrate that on the physical level of photonic qubits the choice of the standard linear optical Bell measurement with its limited efficiency is optimal for our setting in the sense that, apart from their potential use in state preparation, more advanced Bell measurements yield only a small decrease in resource consumption. We devise two state generation schemes that provide the required ancillary encoded Bell states (quasi-)on-demand at every station. The schemes are either based on nonlinear optics or on linear optics with multiplexing and exhibit resource costs that scale linearly or less than quadratic with the number of photons per encoded qubit, respectively. Finally, we show that it is possible to operate our communication scheme with on-off detectors instead of employing photon-number-resolving detectors.
We present an in-depth analysis regarding the error resistance and optimization of our all-optical Bell measurement and ultrafast long-distance quantum communication scheme proposed by Ewert, Bergmann, and van Loock [Phys. Rev. Lett. 117, 210501 (2016)]. In order to promote our previous proposal from loss to fault tolerance, we introduce a general and compact formalism that can also be applied to other related schemes {including non-all-optical ones such as that of Muralidharan et al. [Phys. Rev. Lett. 112, 250501 (2014)]}. With the help of this new representation we show that our communication protocol does not only counteract the inevitable photon loss during channel transmission, but is also able to resist common experimental errors such as Pauli-type errors (bit and phase flips) and detector inefficiencies (losses and dark counts). Furthermore, we demonstrate that on the physical level of photonic qubits the choice of the standard linear optical Bell measurement with its limited efficiency is optimal for our setting in the sense that, apart from their potential use in state preparation, more advanced Bell measurements yield only a small decrease in resource consumption. We devise two state generation schemes that provide the required ancillary encoded Bell states (quasi-)on-demand at every station. The schemes are either based on nonlinear optics or on linear optics with multiplexing and exhibit resource costs that scale linearly or less than quadratic with the number of photons per encoded qubit, respectively. Finally, we show that it is possible to operate our communication scheme with on-off detectors instead of employing photon-number-resolving detectors.
We propose a projection measurement onto encoded Bell states with a static network of linear optical elements. By increasing the size of the quantum error correction code, both Bell measurement efficiency and photon-loss tolerance can be made arbitrarily high at the same time. As a main application, we show that all-optical quantum communication over large distances with communication rates similar to those of classical communication is possible solely based on local state teleportations using optical sources of encoded Bell states, fixed arrays of beam splitters, and photon detectors. As another application, generalizing state teleportation to gate teleportation for quantum computation, we find that in order to achieve universality the intrinsic loss tolerance must be sacrificed and a minimal amount of feedforward has to be added.
Quantum communication utilizes the quantum state as information carrier. The transmission of quantum states is therefore a precondition for various quantum communication protocols. Photons play a central role in quantum communication since they are fast, cheap, easy to control and interact weakly with the environment. However, the widely used polarization degree of freedom of photons is vulnerable to the noise during the transmission. In this article, we review two main methods to deal with the channel noise, i.e., the quantum error rejection scheme and fault tolerant quantum communication. To transmit an arbitrary single-photon state, Li and Deng proposed two faithful state transmission schemes only by resorting to passive linear optics. The success probability can be (2N+1-1)/2N+1 by introducing a wave splitter composed of N unbalance interferometers. Compared with other quantum error rejection schemes, these two scheme are practical both in maneuverability and resource consumption. They are not only suitable for single-photon pure state transmission but also able to be used for transmitting mixed state, which makes them useful for one-way quantum communication. The success probability of error rejection is usually less than 100% since some error cases are rejected. To realize complete fault tolerant quantum communication, decoherence free subspace can be used to encode quantum information. In 2008, Li et al. proposed two efficient quantum key distribution schemes over two different collective-noise channels. The noiseless subspaces are made up of two Bell states and the spatial degree of freedom is introduced to form two nonorthogonal bases. Although entangled states are employed, only single-photon measurements are required to read the information. Later, the scheme is generalized to an efficient one which transmits n-1 bits information via n Einstein-Podolsky-Rosen pairs and many fault tolerant quantum communication schemes were proposed. We compare the practicality of different anti-noise schemes based on maneuverability and resource consumption and a perspective of these two research directions is given in the last section.
Fault tolerance is essential for scalable quantum technologies and is enabled by quantum error-correction codes. Bell-state measurements (BSMs) are a fundamental building block for modern quantum technologies such as measurement-based quantum computation and fusion-based quantum computation, as well as quantum networks. Therefore, performing BSMs on error-corrected qubits is a necessary step for achieving fault tolerance in these applications. In this work, we realise a logical BSM using linear optics, based on a two-qubit repetition code, an instance of a quantum parity code that allows detection of bit-flip errors, and experimentally achieve a mean success probability of (70.8 +/- 0.4)%. While standard linear-optical BSMs are fundamentally limited to a maximum success probability of 50%, this increased success probability enables higher secure key rates in quantum communication and facilitates the generation of large graph states for quantum computation. Since fault-tolerant schemes require error-correction codes regardless, this improvement comes at no additional resource overhead. Our results demonstrate that error-correction codes can be used to surpass the linear-optics limit of BSMs, which is an important step towards practical, fault-tolerant, and scalable photonic quantum technologies.
Quantum computing promises a new paradigm of computation where information is processed in a way that has no classical analogue. There are a number of physical platforms conducive to quantum computation, each with a number of advantages and challenges. Single photons, manipulated using integrated linear optics, constitute a promising platform for universal quantum computation. Their low decoherence rates make them particularly favourable, however the inability to perform deterministic two-qubit gates and the issue of photon loss are challenges that need to be overcome. In this thesis we explore the construction of a linear optical quantum computer based on the cluster state model. We identify the different necessary stages: state preparation, cluster state construction and implementation of quantum error correcting codes, and address the challenges that arise in each of these stages. For the state preparation, we propose a series of linear optical circuits for the generation of small entangled states, assessing their performance under different scenarios. For the cluster state construction, we introduce a ballistic scheme which not only consumes an order of magnitude fewer resources than previously proposed schemes, but also benefits from a natural loss tolerance. Based on this scheme, we propose a full architectural blueprint with fixed physical depth. We make investigations into the resource efficiency of this architecture and propose a new multiplexing scheme which optimises the use of resources. Finally, we study the integration of quantum error-correcting codes in the linear optical scheme proposed and suggest three ways in which the linear optical scheme can be made fault-tolerant.
We present a detailed analysis of the Bell measurement scheme proposed in Lee et al. [Phys. Rev. Lett. 114, 113603 (2015)] based on a logical qubit using Greenberger-Horne-Zeilinger entanglement of photons. The success probability of the proposed Bell measurement can be made arbitrarily high using only linear optics as the number of photons in a logical qubit increases. We compare our scheme with all the other proposals, using single-photon qubits, coherent-state qubits, or hybrid qubits, suggested to enhance the efficiency of the Bell measurement. As a remarkable advantage, our scheme requires only photon on-off measurements, while photon number resolving detectors are necessary for all the other proposals. We find that the scheme based on coherent-state qubits shows the best performance with respect to the attained success probability in terms of the average number of photons used in the process, while our scheme outperforms the schemes using single-photon qubits. We finally show that efficient quantum communication and fault-tolerant quantum computation can be realized using our approach.
The coherent-state qubit is a promising candidate for optical quantum information processing due to its nearly deterministic nature of the Bell-state measurement (BSM). However, its nonorthogonality incurs difficulties such as the failure of the BSM. One may use a large amplitude $(\ensuremath{\alpha})$ for the coherent state to minimize the failure probability, but the qubit then becomes more vulnerable to dephasing by photon loss. We propose a hardware-efficient concatenated BSM (CBSM) scheme with modified parity encoding using coherent states with reasonably small amplitudes $(|\ensuremath{\alpha}|⪅2)$, which simultaneously suppresses both failures and dephasing in the BSM procedure. We numerically show that the CBSM scheme achieves a success probability arbitrarily close to unity for appropriate values of $\ensuremath{\alpha}$ and sufficiently low photon loss rates (e.g., ⪅5). Furthermore, we verify that the quantum repeater scheme exploiting the CBSM scheme for quantum error correction enables one to carry out efficient long-range quantum communication over 1000 km. We show that the performance is comparable to those of other up-to-date methods and even exceeds them in some cases. Finally, we present methods to prepare logical qubits under modified parity encoding, and we implement elementary logical operations, which consist of several physical-level ingredients such as generation of superpositions of coherent states (SCSs) and elementary gates under the coherent-state basis. We then estimate the effects of imperfect physical-level elements on the performance of the scheme. Our work demonstrates that the encoded coherent-state qubits in free-propagating fields provide an alternative route to fault-tolerant information processing, especially to long-range quantum communication.