Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1610.01034 · Journal of Experimental and Theoretical Physics

Dependence of the maximal superconducting current on the resonance frequency in a shunted Josephson junction

Yu. M. Shukrinov, I. R. Rahmonov, Giovanni Filatrella

Published Nov 1, 2017• 7 citations
arXivHTMLPDF

Abstract

We have analyzed the phase dynamics and current–voltage characteristics of a Josephson junction shunted by an LC circuit. When the Josephson frequency ω J becomes equal to the natural frequency ωrc of the formed resonance circuit, the I–V curve acquires additional branches. We have studied the features of the rc branch and the superconducting circuit for different values of the resonance frequency. It is shown that the maximal superconducting current through the Josephson junction on the rc-branch depends on the resonance frequency and is determined by the closeness of the end point of the rc branch to the critical current. We have determined the dependence of the maximal superconducting current on the resonance frequency for different values of the dissipation parameters. The limiting value of the maximal superconducting current is independent (to within 1%) of the parameters of the system.

DOI
10.1134/s1063776117100156

Related papers

Effects of LC shunting on the Shapiro steps features of Josephson junction

Yu. M. Shukrinov, I. R. Rahmonov, K. V. Kulikov +1 more

We study an effect of external radiation on the dynamics of Josephson junction shunted by an LC circuit. When the Josephson frequency is equal to the frequency of the circuit, additional stable resonant circuit branches appear in the IV -characteristic of the junction. The branches occur on the stable side of a narrow resonance peak, while the other peak side has a negative slope and is unstable. We show that the amplitude dependence of the Shapiro step width crucially changes when the Shapiro step is on the resonant circuit branch. These effects might give very important advantages for methods and technologies that exploit the response of Josephson junctions to microwave fields.

arXiv:1405.3898•Europhysics Letters (EPL)•May 1, 2015•18 citations

Dynamics of a LC Shunted ${\rm YBa}_{2}{\rm Cu}_{3}{\rm O}_{7{\hbox {-}}\delta}$ Josephson Junction

Floriana Lombardi, Thilo Bauch, G. Rotoli +5 more

We have measured the energy level separation from the ground state to the first excited state in a high critical temperature superconductor d-wave Josephson junction. We observe that the bias current dependence of the energy level separation is strongly affected by the large shunt capacitance and inductance of the junction electrodes. In order to describe the effect of a shunt capacitance and shunt inductance on the junction dynamics we derive the equation of motion of the total system. In general such a circuit displays two resonance frequencies corresponding to two different energy scales. We discuss various limits for the values of the shunt inductor and capacitor.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•5 citations

High-Frequency Response of Josephson Point Contacts

Helmut Kanter, F. L. Vernon

For a current-driven Josephson junction shunted by an Ohmic resistance, the dc voltage response and impedance to external high-frequency currents is calculated with a second-order perturbation method based on the unperturbed solution for the time evolution of the voltage as given by Aslamazov and Larkin. The response is proportional to signal power and has three characteristic-frequency regions depending on whether the internal self-generated Josephson frequency, ω0, is larger than, equal to, or smaller than the signal frequency, ω. For ω0< or >ω the response could be expressed by easily observable parameters of the dc voltage-current characteristics. This permits comparison of the predictions with experimental results obtained on point-contact junctions whose dc characteristics were only approximately represented by the simple model chosen for analysis. For ω0≪ω the response is found to be proportional to (i) the slope of the dc characteristic, (ii) the inverse square of the applied frequency, (iii) the inverse battery current in terms of the critical current, and (iv) the voltage amplitude of the inherent Josephson oscillations. For ω0≫ω ``classical'' detection proportional to curvature is obtained. For ω0∼ω resonance detection occurs, which depends to a considerable degree on fluctuations of the average contact voltage. These predictions are in reasonable agreement with experiments in which point-contact junctions were illuminated with klystron radiation at 10 and 90 GHz. Evidence is presented that the voltage fluctuations limiting the resonance response are the result of noise generated in the junction. Comparison of the noise-equivalent power expected from the simple model with measured results suggests that parasitic elements, such as shunt capacity, are not negligible at 90 GHz.

Journal of Applied Physics•Jul 1, 1972•101 citations

Influence and evaluation of parasitic inductance in shunted Josephson junctions

A. B. Cawthorne, C. B. Whan, Christopher J. Lobb

The shunt resistors used in many Josephson junction circuits contain an inductive component that can significantly degrade high-frequency performance. Numerical simulations reveal complex dynamical behaviour, including relaxation oscillations, period-doubling sequences, and chaos, all of which are serious problems for applications as high-frequency sources and detectors. This complex AC behaviour creates features in the simulated DC current-voltage characteristics. Since these simulations closely match experimental data, they can be used to investigate the high-frequency AC behaviour of real junctions. Thus, we are able to use simple DC measurements to observe evidence of complex high-frequency dynamics. The inductance of the shunt branch can be accurately determined by comparing simulations to measurements. Simulations also allow us to map regions of the parameter space which exhibit complicated behaviour. These regions should be avoided when a nearly sinusoidal voltage waveform is desired, as is the case for Josephson junction-based oscillators.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•8 citations

Quantum phase dynamics in an LC shunted Josephson junction

Ch. Kaiser, Thilo Bauch, Floriana Lombardi +1 more

We have studied both theoretically and experimentally how an LC series circuit connected in parallel to a Josephson junction influences the Josephson dynamics. The presence of the shell circuit introduces two energy scales, which in specific cases, can strongly differ from the plasma frequency of the isolated junction. Josephson junctions were manufactured using the Nb/Al-AlOx/Nb fabrication technology with various on-chip LC shunt circuits. Spectroscopic measurements in the quantum limit show excellent agreement with theory taking into account the shunt inductance and capacitance in the resistively and capacitively shunted junction model. The results clearly show that the dynamics of the system are two-dimensional, resulting in two resonant modes of the system. These findings have important implications for the design and operation of Josephson junction based quantum bits.

arXiv:1010.4713•Journal of Applied Physics•May 1, 2011•6 citations

Complex dynamics of resistively and inductively shunted Josephson junctions

A. B. Cawthorne, C. B. Whan, Christopher J. Lobb

We have measured Nb–AlOx–Nb Josephson tunnel junctions which have resistive shunts with different parasitic inductances. Numerical simulations reveal that specific features in the experimental current–voltage (I–V) characteristics of these devices are dc signatures of complex ac behavior. Depending on the inductance of the shunt loop and the capacitance of the junction, these features may either appear or disappear as the temperature of the device is increased. Examination of the simulated voltage waveforms allows us to map regions of the parameter space which exhibit complicated behavior. These regions should be avoided when a nearly sinusoidal voltage waveform is desired, as is the case for Josephson junction-based oscillators. The agreement of the experimental and simulated I–V curves also enables us to accurately determine the inductance of the shunts and the capacitance of the junctions.

Journal of Applied Physics•Jul 15, 1998•84 citations
We have analyzed the phase dynamics and current–voltage characteristics of a Josephson junction shunted by an LC circuit. When the Josephson frequency ω J becomes equal to the natural frequency ωrc of the formed resonance circuit, the I–V curve acquires additional branches. We have studied the features of the rc branch and the superconducting circuit for different values of the resonance frequency. It is shown that the maximal superconducting current through the Josephson junction on the rc-branch depends on the resonance frequency and is determined by the closeness of the end point of the rc branch to the critical current. We have determined the dependence of the maximal superconducting current on the resonance frequency for different values of the dissipation parameters. The limiting value of the maximal superconducting current is independent (to within 1%) of the parameters of the system.
We study an effect of external radiation on the dynamics of Josephson junction shunted by an LC circuit. When the Josephson frequency is equal to the frequency of the circuit, additional stable resonant circuit branches appear in the IV -characteristic of the junction. The branches occur on the stable side of a narrow resonance peak, while the other peak side has a negative slope and is unstable. We show that the amplitude dependence of the Shapiro step width crucially changes when the Shapiro step is on the resonant circuit branch. These effects might give very important advantages for methods and technologies that exploit the response of Josephson junctions to microwave fields.
Dynamics of a LC Shunted YBa2Cu3O7-δ{\rm YBa}_{2}{\rm Cu}_{3}{\rm O}_{7{\hbox {-}}\delta}YBa2​Cu3​O7-δ​ Josephson Junction
We have measured the energy level separation from the ground state to the first excited state in a high critical temperature superconductor d-wave Josephson junction. We observe that the bias current dependence of the energy level separation is strongly affected by the large shunt capacitance and inductance of the junction electrodes. In order to describe the effect of a shunt capacitance and shunt inductance on the junction dynamics we derive the equation of motion of the total system. In general such a circuit displays two resonance frequencies corresponding to two different energy scales. We discuss various limits for the values of the shunt inductor and capacitor.
For a current-driven Josephson junction shunted by an Ohmic resistance, the dc voltage response and impedance to external high-frequency currents is calculated with a second-order perturbation method based on the unperturbed solution for the time evolution of the voltage as given by Aslamazov and Larkin. The response is proportional to signal power and has three characteristic-frequency regions depending on whether the internal self-generated Josephson frequency, ω0, is larger than, equal to, or smaller than the signal frequency, ω. For ω0< or >ω the response could be expressed by easily observable parameters of the dc voltage-current characteristics. This permits comparison of the predictions with experimental results obtained on point-contact junctions whose dc characteristics were only approximately represented by the simple model chosen for analysis. For ω0≪ω the response is found to be proportional to (i) the slope of the dc characteristic, (ii) the inverse square of the applied frequency, (iii) the inverse battery current in terms of the critical current, and (iv) the voltage amplitude of the inherent Josephson oscillations. For ω0≫ω ``classical'' detection proportional to curvature is obtained. For ω0∼ω resonance detection occurs, which depends to a considerable degree on fluctuations of the average contact voltage. These predictions are in reasonable agreement with experiments in which point-contact junctions were illuminated with klystron radiation at 10 and 90 GHz. Evidence is presented that the voltage fluctuations limiting the resonance response are the result of noise generated in the junction. Comparison of the noise-equivalent power expected from the simple model with measured results suggests that parasitic elements, such as shunt capacity, are not negligible at 90 GHz.
The shunt resistors used in many Josephson junction circuits contain an inductive component that can significantly degrade high-frequency performance. Numerical simulations reveal complex dynamical behaviour, including relaxation oscillations, period-doubling sequences, and chaos, all of which are serious problems for applications as high-frequency sources and detectors. This complex AC behaviour creates features in the simulated DC current-voltage characteristics. Since these simulations closely match experimental data, they can be used to investigate the high-frequency AC behaviour of real junctions. Thus, we are able to use simple DC measurements to observe evidence of complex high-frequency dynamics. The inductance of the shunt branch can be accurately determined by comparing simulations to measurements. Simulations also allow us to map regions of the parameter space which exhibit complicated behaviour. These regions should be avoided when a nearly sinusoidal voltage waveform is desired, as is the case for Josephson junction-based oscillators.
We have studied both theoretically and experimentally how an LC series circuit connected in parallel to a Josephson junction influences the Josephson dynamics. The presence of the shell circuit introduces two energy scales, which in specific cases, can strongly differ from the plasma frequency of the isolated junction. Josephson junctions were manufactured using the Nb/Al-AlOx/Nb fabrication technology with various on-chip LC shunt circuits. Spectroscopic measurements in the quantum limit show excellent agreement with theory taking into account the shunt inductance and capacitance in the resistively and capacitively shunted junction model. The results clearly show that the dynamics of the system are two-dimensional, resulting in two resonant modes of the system. These findings have important implications for the design and operation of Josephson junction based quantum bits.
We have measured Nb–AlOx–Nb Josephson tunnel junctions which have resistive shunts with different parasitic inductances. Numerical simulations reveal that specific features in the experimental current–voltage (I–V) characteristics of these devices are dc signatures of complex ac behavior. Depending on the inductance of the shunt loop and the capacitance of the junction, these features may either appear or disappear as the temperature of the device is increased. Examination of the simulated voltage waveforms allows us to map regions of the parameter space which exhibit complicated behavior. These regions should be avoided when a nearly sinusoidal voltage waveform is desired, as is the case for Josephson junction-based oscillators. The agreement of the experimental and simulated I–V curves also enables us to accurately determine the inductance of the shunts and the capacitance of the junctions.