Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1606.04258 · The European Physical Journal Special Topics

Inhomogeneous Josephson junction chains: a superconducting meta-material for superinductance optimization

D. V. Nguyen, D. M. Basko

Published May 1, 2017• 7 citations
arXivHTMLPDF

Abstract

We report a theoretical study of the low-frequency impedance of a Josephson junction chain whose parameters vary in space. Our goal is to find the optimal spatial profile which maximizes the total inductance of the chain without shrinking the low-frequency window where the chain behaves as an inductor. If the spatial modulation is introduced by varying the junction areas, we find that the best result is obtained for a spatially homogeneous chain, reported earlier in the literature. An improvement over the homogeneous result can be obtained by representing the junctions by SQUIDs with different loop areas, so the inductances can be varied by applying a magnetic field. Still, we find that this improvement becomes less important for longer chains.

DOI
10.1140/epjst/e2016-60278-4

Related papers

Mode engineering with a one-dimensional superconducting metamaterial

Masahiko Taguchi, D. M. Basko, F. W. J. Hekking

We propose a way to control the Josephson energy of a single Josephson junction embedded in a one-dimensional superconducting metamaterial: an inhomogeneous superconducting loop, made out of a superconducting nanowire or a chain of Josephson junctions. The Josephson energy is renormalized by the electromagnetic modes propagating along the loop. We study the behavior of the modes as well as of their frequency spectrum when the capacitance and the inductance along the loop are spatially modulated. We show that, depending on the amplitude of the modulation, the renormalized Josephson energy is either larger or smaller than the one found for a homogeneous loop. Using typical experimental parameters for Josephson junction chains and superconducting nanowires, we conclude that this mode engineering can be achieved with currently available metamaterials.

arXiv:1505.00385•Physical Review B•Jul 10, 2015•15 citations

Tuning the inductance of Josephson junction arrays without SQUIDs

Roman Kuzmin, N. Mehta, Nicholas Grabon +1 more

It is customary to use arrays of superconducting quantum interference devices (SQUIDs) for implementing magnetic field-tunable inductors. Here, we demonstrate an equivalent tunability in a (SQUID-free) array of single Al/AlOx/Al Josephson tunnel junctions. With the proper choice of junction geometry, a perpendicularly applied magnetic field bends along the plane of the superconductor and focuses into the tunnel barrier region due to a demagnetization effect. Consequently, the Josephson inductance can be efficiently modulated by the Fraunhofer-type supercurrent interference. The elimination of SQUIDs not only simplifies the device design and fabrication but also facilitates a denser packing of junctions, and, hence, a higher inductance per unit length. As an example, we demonstrate a transmission line, the characteristic impedance of which is field-tuned in the range of 4–8 kΩ, centered around the important value of the resistance quantum h/(2e)2≈6.5 kΩ.

arXiv:2210.12119•Applied Physics Letters•Oct 30, 2023•13 citations

Hyperinductance based on stacked Josephson junctions

Paul Manset, José M. Palomo, A. Schmitt +9 more

Superinductances are superconducting circuit elements that combine a large inductance with a low parasitic capacitance to ground, resulting in a characteristic impedance exceeding the resistance quantum $R_Q = h/(2e)^2 \simeq 6.45 \mathrm{k}Ω$. In recent years, these components have become key enablers for emerging quantum circuit architectures. However, achieving high characteristic impedance while maintaining scalability and fabrication robustness remains a major challenge. In this work, we present two fabrication techniques for realizing superinductances based on vertically stacked Josephson junctions. Using a multi-angle Manhattan (MAM) process and a zero-angle (ZA) evaporation technique -- in which junction stacks are connected pairwise using airbridges -- we fabricate one-dimensional chains of stacks that act as high-impedance superconducting transmission lines. Two-tone microwave spectroscopy reveals the expected $\sqrt{n}$ scaling of the impedance with the number of junctions per stack. The chain fabricated using the ZA process, with nine junctions per stack, achieves a characteristic impedance of $\sim 16 \mathrm{k}Ω$, a total inductance of $5.9 \mathrm{μH}$, and a maximum frequency-dependent impedance of $50 \mathrm{k}Ω$ at 1.4 GHz. Our results establish junction stacking as a scalable, robust, and flexible platform for next-generation quantum circuits requiring ultra-high impedance environments.

arXiv:2505.02764•Physical Review Applied•Apr 14, 2026•3 citations

Tunable ohmic environment using Josephson junction chains

Gianluca Rastelli, Ioan M. Pop

We propose a scheme to implement a tunable, wide frequency-band dissipative environment using a double chain of Josephson junctions. The two parallel chains consist of identical superconducting quantum interference devices (SQUIDs), with magnetic-flux tunable inductance, coupled to each other at each node via a capacitance much larger than the junction capacitance. Thanks to this capacitive coupling, the system sustains electromagnetic modes with a wide frequency dispersion. The internal quality factor of the modes is maintained as high as possible, and the damping is introduced by a uniform coupling of the modes to a transmission line, itself connected to an amplification and readout circuit. For sufficiently long chains, containing several thousands of junctions, the resulting admittance is a smooth function versus frequency in the microwave domain, and its effective dissipation can be continuously monitored by recording the emitted radiation in the transmission line. We show that by varying in situ the SQUIDs' inductance, the double chain can operate as a tunable ohmic resistor in a frequency band spanning up to 1 GHz, with a resistance that can be swept through values comparable to the resistance quantum ${R}_{q}=h/(4{e}^{2})\ensuremath{\simeq}6.5\phantom{\rule{4pt}{0ex}}\text{k}\mathrm{\ensuremath{\Omega}}$. We argue that the circuit complexity is within reach using current Josephson junction technology.

arXiv:1712.07605•Physical review. B./Physical review. B•May 17, 2018•15 citations

SQUIDs as tunable inductors integrated in the design of filters

Raihan Rafique, Thomas Ohki, Anna Yurievna Herr

This work presents the dc-SQUID based tunable inductance and its relevance into the design of resonators and filters for the qubit application. The SQUID inductance depends on loop inductance, applied magnetic field and bias\ncurrent for a given thermal noise. Tunable resonators and\nfilters have been designed by replacing the inductances of the resonator with a chain of SQUIDs in series. A narrow bandpass filter with variable central frequency is useful for superconducting qubit applications, specifically for improving the line widths of Josephson junction oscillators. We have designed a tunable 3.5 GHz resonator and 2 GHz 7 stage Chebyshev filters to be fabricated in Hypres 4.5 kA/cm2 process. According to simulations, up to 50% of the operating frequency of the designed filter can be varied. We present data that shows a frequency tuning of >2 GHz.

•Jan 1, 2007•0 citations

Low-loss tunable metamaterials using superconducting thin-film circuits with Josephson junctions

S. Butz, P. Jung, Alexey Vladimirovich Ustinov

We report on experiments with superconducting Josephson metamaterials. In such a material, conventional split ring resonators are replaced by superconducting loops that are interrupted by Josephson junctions, so called rf-SQUIDs. Like the split ring resonators, they can be seen as LCresonators that couple to the magnetic component of the incoming wave. The advantage of superconducting thin-film metamaterials is that due to the tunable intrinsic inductance of the Josephson junction, the resonance frequency of the rf-SQUID can be changed by applying an external dc magnetic field. We present experimental results that show the tunability of the resonance frequency of these devices.

•Jan 1, 2012•0 citations
We report a theoretical study of the low-frequency impedance of a Josephson junction chain whose parameters vary in space. Our goal is to find the optimal spatial profile which maximizes the total inductance of the chain without shrinking the low-frequency window where the chain behaves as an inductor. If the spatial modulation is introduced by varying the junction areas, we find that the best result is obtained for a spatially homogeneous chain, reported earlier in the literature. An improvement over the homogeneous result can be obtained by representing the junctions by SQUIDs with different loop areas, so the inductances can be varied by applying a magnetic field. Still, we find that this improvement becomes less important for longer chains.
We propose a way to control the Josephson energy of a single Josephson junction embedded in a one-dimensional superconducting metamaterial: an inhomogeneous superconducting loop, made out of a superconducting nanowire or a chain of Josephson junctions. The Josephson energy is renormalized by the electromagnetic modes propagating along the loop. We study the behavior of the modes as well as of their frequency spectrum when the capacitance and the inductance along the loop are spatially modulated. We show that, depending on the amplitude of the modulation, the renormalized Josephson energy is either larger or smaller than the one found for a homogeneous loop. Using typical experimental parameters for Josephson junction chains and superconducting nanowires, we conclude that this mode engineering can be achieved with currently available metamaterials.
It is customary to use arrays of superconducting quantum interference devices (SQUIDs) for implementing magnetic field-tunable inductors. Here, we demonstrate an equivalent tunability in a (SQUID-free) array of single Al/AlOx/Al Josephson tunnel junctions. With the proper choice of junction geometry, a perpendicularly applied magnetic field bends along the plane of the superconductor and focuses into the tunnel barrier region due to a demagnetization effect. Consequently, the Josephson inductance can be efficiently modulated by the Fraunhofer-type supercurrent interference. The elimination of SQUIDs not only simplifies the device design and fabrication but also facilitates a denser packing of junctions, and, hence, a higher inductance per unit length. As an example, we demonstrate a transmission line, the characteristic impedance of which is field-tuned in the range of 4–8 kΩ, centered around the important value of the resistance quantum h/(2e)2≈6.5 kΩ.
Superinductances are superconducting circuit elements that combine a large inductance with a low parasitic capacitance to ground, resulting in a characteristic impedance exceeding the resistance quantum RQ=h/(2e)2≃6.45kΩR_Q = h/(2e)^2 \simeq 6.45 \mathrm{k}ΩRQ​=h/(2e)2≃6.45kΩ. In recent years, these components have become key enablers for emerging quantum circuit architectures. However, achieving high characteristic impedance while maintaining scalability and fabrication robustness remains a major challenge. In this work, we present two fabrication techniques for realizing superinductances based on vertically stacked Josephson junctions. Using a multi-angle Manhattan (MAM) process and a zero-angle (ZA) evaporation technique -- in which junction stacks are connected pairwise using airbridges -- we fabricate one-dimensional chains of stacks that act as high-impedance superconducting transmission lines. Two-tone microwave spectroscopy reveals the expected n\sqrt{n}n​ scaling of the impedance with the number of junctions per stack. The chain fabricated using the ZA process, with nine junctions per stack, achieves a characteristic impedance of ∼16kΩ\sim 16 \mathrm{k}Ω∼16kΩ, a total inductance of 5.9μH5.9 \mathrm{μH}5.9μH, and a maximum frequency-dependent impedance of 50kΩ50 \mathrm{k}Ω50kΩ at 1.4 GHz. Our results establish junction stacking as a scalable, robust, and flexible platform for next-generation quantum circuits requiring ultra-high impedance environments.
We propose a scheme to implement a tunable, wide frequency-band dissipative environment using a double chain of Josephson junctions. The two parallel chains consist of identical superconducting quantum interference devices (SQUIDs), with magnetic-flux tunable inductance, coupled to each other at each node via a capacitance much larger than the junction capacitance. Thanks to this capacitive coupling, the system sustains electromagnetic modes with a wide frequency dispersion. The internal quality factor of the modes is maintained as high as possible, and the damping is introduced by a uniform coupling of the modes to a transmission line, itself connected to an amplification and readout circuit. For sufficiently long chains, containing several thousands of junctions, the resulting admittance is a smooth function versus frequency in the microwave domain, and its effective dissipation can be continuously monitored by recording the emitted radiation in the transmission line. We show that by varying in situ the SQUIDs' inductance, the double chain can operate as a tunable ohmic resistor in a frequency band spanning up to 1 GHz, with a resistance that can be swept through values comparable to the resistance quantum ${R}_{q}=h/(4{e}^{2})\ensuremath{\simeq}6.5\phantom{\rule{4pt}{0ex}}\text{k}\mathrm{\ensuremath{\Omega}}$. We argue that the circuit complexity is within reach using current Josephson junction technology.
This work presents the dc-SQUID based tunable inductance and its relevance into the design of resonators and filters for the qubit application. The SQUID inductance depends on loop inductance, applied magnetic field and bias\ncurrent for a given thermal noise. Tunable resonators and\nfilters have been designed by replacing the inductances of the resonator with a chain of SQUIDs in series. A narrow bandpass filter with variable central frequency is useful for superconducting qubit applications, specifically for improving the line widths of Josephson junction oscillators. We have designed a tunable 3.5 GHz resonator and 2 GHz 7 stage Chebyshev filters to be fabricated in Hypres 4.5 kA/cm2 process. According to simulations, up to 50% of the operating frequency of the designed filter can be varied. We present data that shows a frequency tuning of >2 GHz.
We report on experiments with superconducting Josephson metamaterials. In such a material, conventional split ring resonators are replaced by superconducting loops that are interrupted by Josephson junctions, so called rf-SQUIDs. Like the split ring resonators, they can be seen as LCresonators that couple to the magnetic component of the incoming wave. The advantage of superconducting thin-film metamaterials is that due to the tunable intrinsic inductance of the Josephson junction, the resonance frequency of the rf-SQUID can be changed by applying an external dc magnetic field. We present experimental results that show the tunability of the resonance frequency of these devices.