Abstract : Qubit dephasing is governed by low-frequency noise in the bias parameters that control the energy separation between the qubit states. It has been shown that dephasing in phase and flux qubits is dominated by an excess low frequency magnetic flux noise with a 1/f power spectrum and magnitude at 1 Hz of order 1 microPhi0/sqrt(Hz). Recent experiments by McDermott et al. provide clear evidence for the existence of unpaired magnetic states on the surfaces of superconducting thin film devices; it is now believed that fluctuations of these surface spin states are the source of the ubiquitous 1/f flux noise. However, the microscopic mechanism that drives fluctuations of these spins is not understood; moreover, there is no clear path to reducing the flux noise magnitude. This program is devoted to a systematic investigation of magnetic surface defects in SQUIDs and phase qubits. Measurements of surface spin susceptibility and susceptibility noise will yield valuable clues about the microscopic nature of the magnetic fluctuators, and shed light on interactions between defects. The role of qubit loop geometry on flux noise magnitude and dephasing will be explored in detail. The experiments will guide theoretical efforts to develop improved models for flux noise.
The microscopic description of 1/f magnetic flux noise in superconducting circuits has remained an open question for several decades despite extensive experimental and theoretical investigation. Recent progress in superconducting devices for quantum information has highlighted the need to mitigate sources of qubit decoherence, driving a renewed interest in understanding the underlying noise mechanism(s). Though a consensus has emerged attributing flux noise to surface spins, their identity and interaction mechanisms remain unclear, prompting further study. Here, we apply weak in-plane magnetic fields to a capacitively shunted flux qubit (where the Zeeman splitting of surface spins lies below the device temperature) and study the flux-noise-limited qubit dephasing, revealing previously unexplored trends that may shed light on the dynamics behind the emergent 1/f noise. Notably, we observe an enhancement (suppression) of the spin-echo (Ramsey) pure-dephasing time in fields up to B=100 G. With direct noise spectroscopy, we further observe a transition from a 1/f to approximately Lorentzian frequency dependence below 10 Hz and a reduction of the noise above 1 MHz with increasing magnetic field. We suggest that these trends are qualitatively consistent with an increase of spin cluster sizes with magnetic field. These results should help to inform a complete microscopic theory of 1/f flux noise in superconducting circuits.
For over three decades, the presence of magnetic flux noise with a power spectral density scaling roughly as
SPhi(f)propto1/falpha, where
alphalesssim1, has been known to limit the low-frequency performance of dc superconducting quantum interference devices (SQUIDs). In recent years, experiments indicate that this same noise persists to frequencies up to 1~GHz and is a dominant source of dephasing in flux-sensitive superconducting quantum bits (qubits). Thus, the reduction of flux noise presents a major hurdle towards the successful realization of scalable quantum computers that are based on flux-based qubits. In this thesis, we present experimental measurements, theoretical analyses, and numerical simulations that support a more detailed understanding of both the microscopic and macroscopic properties of flux noise.Our experimental work begins with flux noise measurements of a large number of SQUIDs in the temperature range from 0.1~K to 4~K. We report on measurements of ten SQUIDs with systematically varied geometries and show that
alpha increases as the temperature is lowered; in so doing, each spectrum pivots about a nearly constant frequency. The mean square flux noise, inferred by integrating the power spectra, grows rapidly with temperature and at a given temperature is approximately independent of the outer dimension of a given SQUID washer. We show that these results are incompatible with a model based on the random reversal of independent, spins that are located at the surface of the SQUID washer.In the course of our flux noise measurements, we became aware of a spurious contribution to low-frequency critical current noise in Josephson junctions---normally attributed to charge trapping in the barrier---arising from temperature instabilities inherent in cryogenic systems. These temperature fluctuations modify the critical current via its temperature dependence. By computing cross-correlations between measured temperature and critical current noise in Al-AlOx-Al junctions, we show that, despite excellent temperature stability, temperature fluctuations induce observable critical current fluctuations. Particularly, because
1/f critical current noise has decreased with improved fabrication techniques in recent years, it is important to understand and eliminate this additional noise source.Next, we introduce a numerical method of calculating the mean square flux noise
Phisq from independently fluctuating spins on the surface of thin-film loops of arbitrary geometry. By reciprocity,
Phisq is proportional to
langleBbf(rbf)2rangle, where
Bbf(rbf) is the magnetic field generated by a circulating current around the loop and
rbf varies over the loop surface. By discretizing the loop nonuniformly, we efficiently and accurately compute the current distribution and resulting magnetic field, which may vary rapidly across the loop. We use this method to compute
Phisq in a number of scenarios in which we systematically vary physical parameters of the loop. We compare our simulations to an earlier analytic result predicting that
PhisqproptoR/W in the limit where the loop radius
R is much greater than the linewidth
W. We further show that the previously neglected contribution of edge spins to
Phisq is significant---even dominant---in narrow-linewidth loops.To calculate theoretical dephasing rates in qubits, we consider flux noise with a spectral density
SPhi(f)=A2/(f/1 hboxHz)alpha, where
A is of the order of 1~
muPhi0,hboxHz−1/2 and
0.6leqalphaleq1.2;
Phi0 is the flux quantum. For a qubit with an energy level splitting linearly coupled to the applied flux, our calculations of the dependence of the pure dephasing time
tauphi of Ramsey and echo pulse sequences on
alpha for fixed
A show that
tauphi decreases rapidly as
alpha is reduced. We find that
tauphi is relatively insensitive to the noise bandwidth,
f1leqfleqf2, for all
alpha provided the ultraviolet cutoff frequency
f2>1/tauphi. We calculate the ratio
tauphi,E/tauphi,R of the echo (
E) and Ramsey (
R) sequences, and the dependence of the decay function on
alpha and
f2. We investigate the case in which
SPhi(f0) is fixed at the ``pivot frequency''
f0neq1~Hz while
alpha is varied, and find that the choice of
f0 can greatly influence the sensitivity of
tauphi,E and
tauphi,R to the value of
alpha.Finally, we conclude with a brief review of our principal results and conclusions. We also comment on promising avenues of future research.
The magnetic flux noise caused by surface spin fluctuations in superconducting quantum interference devices (SQUIDs) limits their development. In this work, we report that different adsorbents such as H, O 2, NO, and NO 2 that adsorb on the surfaces of Mg-based and Pb-based SQUIDs, respectively, producing large local magnetic moments ranging from 0.7–1.6 μ B, with energy barriers for thermal spin fluctuation as low as 10–30 mK. Moreover, we observe that the presence of H atoms on the surface of MgO can cause the coadsorption of other molecules, which generates additional spin sources. Monte Carlo simulations of the weakly coupled spin on a two-dimensional square lattice produce a low-frequency flux noise spectrum. We suggest eliminating the surface magnetism by coating the surface with monolayer indium phosphide or protecting the surface from other molecules by nonmagnetic preoccupants with a larger adsorption energy. The work provides important physical insights and feasible strategies for reducing magnetic noise sources in superconducting circuits.
Superconducting quantum devices, from qubits and magnetometers to dark matter detectors, are influenced by magnetic flux noise originating from paramagnetic surface defects and impurities. These spin systems can feature complex dynamics, including a Berezinskii-Kosterlitz-Thouless transition, that depend on the lattice, interactions, external fields, and disorder. However, the disorder included in typical models is not materials-specific, diminishing the ability to accurately capture measured flux noise phenomena. We present a first principles-based simulation of a spin lattice consisting of paramagnetic O
2 molecules on an Al
2O
3 surface, a likely flux noise source in superconducting qubits, to elucidate opportunities to mitigate flux noise. We simulate an ensemble of surface adsorbates with disordered orientations and calculate the orientation-dependent exchange couplings using density functional theory. Thus, our spin simulation has no free parameters or assumed functional form of the disorder, and captures correlation in the defect landscape that would appear in real systems. We calculate a range of exchange interactions between electron pairs, with the smallest values, 0.016 meV and -0.023 meV, being in the range required to act as a two-level system and couple to GHz resonators. We calculate the flux noise frequency, temperature, and applied external magnetic field dependence, as well as the susceptibility-flux noise cross-correlation. Calculated trends agree with experiment, demonstrating that a surface harboring paramagnetic adsorbates arranged with materials-specific disorder and interactions captures the various properties of magnetic flux noise observed in superconducting circuits. In addition, we find that an external electric field can tune the spin-spin interaction strength and reduce magnetic flux noise.
Flux noise is unanimously recognised as a leading dephasing mechanism for flux-tunable superconducting qubits. However, our microscopic understanding remains incomplete, and basic effects like Faraday's law of induction have only very recently come into focus. Based on a quantum geometric description of the Faraday effect, we provide an in-depth derivation of the coupling of generic magnetic sources to thin film superconducting structures, under appropriate consideration of the device geometry. We apply the resulting framework to time-varying magnetic dipoles, describing surface or substrate spins, as well as current-carrying flux lines. We show that flux noise not only affects dephasing, but also provides a fundamental limit for the qubit quality factor - notably, even when the qubit contains no loops and is thus nominally not flux-tunable. Assuming surface spins as the origin for universal flux noise, we expect that this quality factor limit might be reached in the near term. For flux lines, we formulate a minimal safety distance to conserve the qubit performance, potentially constraining the scale-up of quantum hardware. This distance is boosted in the presence of large capacitor wings typical for transmons, due to a lensing of the electromotive field which is largely independent of Meissner screening.