Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1604.00680 · Journal of Low Temperature Physics

Weak-Link Phenomena in AC-Biased Transition Edge Sensors

L. Gottardi, H. Akamatsu, M. Bruijn, J.-R. Gao, R. den Hartog, R. Hijmering, H. Hoevers, P. Khosropanah, A. Kozorezov, Jan van der Kuur, A. van der Linden, M. Ridder

Published Jan 31, 2014• 21 citations
arXivHTMLPDF
DOI
10.1007/s10909-014-1093-9

Related papers

Implications of Weak Link Effects on Thermal Characteristics of Transition-Edge Sensors

Catherine N. Bailey, J. S. Adams, S. R. Bandler +10 more

Journal of Low Temperature Physics•Feb 9, 2012•11 citations

Voltage Fluctuations in ac Biased Superconducting Transition-Edge Sensors

Luciano G. Gottardi, M. de Wit, E. Taralli +2 more

We present a detailed analysis of the fundamental noise sources in superconducting transition-edge sensors (TESs), ac voltage biased at MHz frequencies and treated as superconducting weak links. We have studied the noise in the resistive transition as a function of bath temperature of several detectors with different normal resistances and geometries. We show that the "excess" noise, typically observed in the TES electrical bandwidth, can be explained by the equilibrium Johnson noise of the quasiparticles generated within the weak link. The fluctuations at the Josephson frequency and higher harmonics contribute significantly to the measured voltage noise at the detector bandwidth through the nonlinear response of the weak link with a sinusoidal current-phase relation.

arXiv:2210.06869•Physical Review Letters•May 26, 2021•24 citations

Josephson effects in an alternating current biased transition edge sensor

Luciano G. Gottardi, Alexander G. Kozorezov, Hiroki Akamatsu +10 more

We report the experimental evidence of the ac Josephson effect in a transition edge sensor (TES) operating in a frequency domain multiplexer and biased by ac voltage at MHz frequencies. The effect is observed by measuring the non-linear impedance of the sensor. The TES is treated as a weakly linked superconducting system and within the resistively shunted junction model framework. We provide a full theoretical explanation of the results by finding the analytic solution of the non-inertial Langevian equation of the system and calculating the non-linear response of the detector to a large ac bias current in the presence of noise.

arXiv:1604.00549•Applied Physics Letters•Oct 20, 2014•31 citations

The Magnetically-Tuned Transition-Edge Sensor

John E. Sadleir, Sang‐Jun Lee, S. J. Smith +9 more

Journal of Low Temperature Physics•May 27, 2014•6 citations

Direct Observation of Josephson Oscillations in DC-Biased Transition-Edge Sensors

Felix T. Jaeckel, Conjeepuram V. Ambarish, Ayshea Banes +22 more

It has long been recognized that weak-link effects play an important role in transition edge sensors (Sadleir et al., 2010 and Sadleir et al., 2011), especially when the intrinsic transition temperature of the leads is much higher than that of the device itself. The weak-link physics has also been identified as an important complication if the TES is read-out under MHz-range AC bias for multiplexing purposes (Gottardi et al., 2014). More recently, it has been proposed that the commonly observed “excess” Johnson noise could also be explained as a white Johnson noise component that is mixed down into the signal band from higher frequencies via Josephson oscillations on a non-linear I-V relation (Gottardi et al., 2021 and Wessels et al., 2021). In recent experiments with small scale Mo/Au (50$\mu$m length, 15$\mu$m wide) TES devices with Nb leads (fabricated at GSFC) with a small DC bias applied, we have been able to directly observe Josephson oscillations over a kHz to MHz frequency range. The spectrum of the oscillations is well described by a simple damped oscillator model, with its center frequency scaling in direct proportion to the voltage across the TES. The second harmonic is also observed at small bias. If nothing else, we show that the Josephson oscillations provide a straightforward way to determine the value of the shunt-resistor with accuracy of$\mathbf {10^{-4}}$or better, as well as the offset voltage of the bias circuit. This is complementary to our previous work demonstrating that Shapiro steps in the IV curve induced by AC magnetic fields can be used for shunt resistor calibration (Zhou et al., 2018). Further work will be needed to determine if this effect can be observed in larger TES or those with relatively low-$\mathbf {T_{c}}$contacts, where Shapiro steps are too weak to observe. It remains to be seen whether additional insights on the mixed-down Johnson noise can be obtained from a physics-based model of the weak-link.

IEEE Transactions on Applied Superconductivity•Jan 24, 2025•0 citations

Modelling the Resistive State in a Transition Edge Sensor

Alexander G. Kozorezov, Alexander A. Golubov, Didier D. E. Martin +8 more

Journal of Low Temperature Physics•Jan 20, 2012•1 citation
We present a detailed analysis of the fundamental noise sources in superconducting transition-edge sensors (TESs), ac voltage biased at MHz frequencies and treated as superconducting weak links. We have studied the noise in the resistive transition as a function of bath temperature of several detectors with different normal resistances and geometries. We show that the "excess" noise, typically observed in the TES electrical bandwidth, can be explained by the equilibrium Johnson noise of the quasiparticles generated within the weak link. The fluctuations at the Josephson frequency and higher harmonics contribute significantly to the measured voltage noise at the detector bandwidth through the nonlinear response of the weak link with a sinusoidal current-phase relation.
We report the experimental evidence of the ac Josephson effect in a transition edge sensor (TES) operating in a frequency domain multiplexer and biased by ac voltage at MHz frequencies. The effect is observed by measuring the non-linear impedance of the sensor. The TES is treated as a weakly linked superconducting system and within the resistively shunted junction model framework. We provide a full theoretical explanation of the results by finding the analytic solution of the non-inertial Langevian equation of the system and calculating the non-linear response of the detector to a large ac bias current in the presence of noise.
It has long been recognized that weak-link effects play an important role in transition edge sensors (Sadleir et al., 2010 and Sadleir et al., 2011), especially when the intrinsic transition temperature of the leads is much higher than that of the device itself. The weak-link physics has also been identified as an important complication if the TES is read-out under MHz-range AC bias for multiplexing purposes (Gottardi et al., 2014). More recently, it has been proposed that the commonly observed “excess” Johnson noise could also be explained as a white Johnson noise component that is mixed down into the signal band from higher frequencies via Josephson oscillations on a non-linear I-V relation (Gottardi et al., 2021 and Wessels et al., 2021). In recent experiments with small scale Mo/Au (50μ\muμm length, 15μ\muμm wide) TES devices with Nb leads (fabricated at GSFC) with a small DC bias applied, we have been able to directly observe Josephson oscillations over a kHz to MHz frequency range. The spectrum of the oscillations is well described by a simple damped oscillator model, with its center frequency scaling in direct proportion to the voltage across the TES. The second harmonic is also observed at small bias. If nothing else, we show that the Josephson oscillations provide a straightforward way to determine the value of the shunt-resistor with accuracy of10−4\mathbf {10^{-4}}10−4or better, as well as the offset voltage of the bias circuit. This is complementary to our previous work demonstrating that Shapiro steps in the IV curve induced by AC magnetic fields can be used for shunt resistor calibration (Zhou et al., 2018). Further work will be needed to determine if this effect can be observed in larger TES or those with relatively low-Tc\mathbf {T_{c}}Tc​contacts, where Shapiro steps are too weak to observe. It remains to be seen whether additional insights on the mixed-down Johnson noise can be obtained from a physics-based model of the weak-link.