Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1506.07921 · AIP Advances

Superconducting nanowire single-photon detectors at a wavelength of 940 nm

W. J. Zhang, Hao Li, Lixing You, Y. H. He, Lingsun Zhang, X.Y. Liu, Xuezhi Yang, Junjie Wu, Qi Guo, Shijian Chen, Z. Wang, Xiaohui Xie

Published Jun 1, 2015• 7 citations
arXivHTMLPDF

Abstract

We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.

DOI
10.1063/1.4922548

Related papers

Multimode fiber-coupled superconducting nanowire single-photon detector with 70% system efficiency at visible wavelength

Dengkuan Liu, Shigehito Miki, Taro Yamashita +3 more

We report the development of the multimode fiber-coupled superconducting nanowire single-photon detector with high system detection efficiency at visible wavelength. The detector consists of a 10.5-nm-thick and 150-nm-wide NbN nanowire meander fabricated on a Si substrate with a multilayer dielectric mirror and a quarter wavelength cavity for obtaining high optical absorptance. The meander area was 35 µm in diameter and coupled with the GRIN-lensed multimode optical fiber with a core diameter of 50 µm. The system reached detection efficiency of 70% with dark count rate of 100 Hz at the wavelength of 635 nm, 3 dB roll-off response counting rate of 8.5 Mcps, and timing jitter of 76 ps.

Optics Express•Aug 25, 2014•38 citations

Large-sensitive-area superconducting nanowire single-photon detector at 850 nm with high detection efficiency

Hao Li, Lu Zhang, Lixing You +6 more

Satellite-ground quantum communication requires single-photon detectors of 850-nm wavelength with both high detection efficiency and large sensitive area. We developed superconducting nanowire single-photon detectors (SNSPDs) on one-dimensional photonic crystals, which acted as optical cavities to enhance the optical absorption, with a sensitive-area diameter of 50 μm. The fabricated multimode fiber coupled NbN SNSPDs exhibited a maximum system detection efficiency (DE) of up to 82% and a DE of 78% at a dark count rate of 100 Hz at 850-nm wavelength as well as a system jitter of 105 ps.

arXiv:1506.07922•Optics Express•Jun 24, 2015•44 citations

Superconducting Nanowire Single-Photon Detector With a System Detection Efficiency Over 80% at 940-nm Wavelength

W. J. Zhang, Hao Li, Lixing You +7 more

Implementations of quantum information require single-photon detectors (SPDs) with high detection efficiency (DE) at a wavelength of 940 nm, which is a challenge for the available semiconducting SPDs. Superconducting nanowire SPDs (SNSPDs) are capable of detecting visible and near-infrared single photons with high DE. However, these detection capabilities place stringent design requirements on the cavity and nanowire geometry structures. We design, fabricate, and measure SNSPDs with high DE optimized for the 940-nm wavelength. The NbN SNSPDs were fabricated on 1-D photonic crystals for high optical absorptance. By tuning the filling factor of the nanowire through numerical simulations and experiments, we were able to obtain an SNSPD (7 nm thick, 125 nm width, and 0.57 filling factor, as well as active area of$18\ast 18\ \mu\text{m}$) with a saturated system DE of 83.6$\pm$3.7%, at a dark count rate of 10 Hz, and a low polarization dependence of 1.17$\pm$0.02. To our best knowledge, this is the highest value reported for NbN SNSPDs at 940-nm wavelength. The availability of an SNSPD with high system DE at 940 nm may have a profound impact in the field of photonic quantum technologies, such as multiphoton entanglement.

IEEE photonics journal•Mar 16, 2016•12 citations

Performances of NbTiN superconducting nanowire single photon detector

Shigehito Miki, Taro Yamashita, Hirotaka Terai +1 more

We present high performance fiber-coupled niobium titanium nitride superconducting nanowire single photon detectors fabricated on thermally oxidized silicon substrates. By applying a double sided cavity structure, simulated absorptance in the nanowire meander reached 97% at 1550 nm wavelength. The fabricated device showed a system detection efficiency (DE) of 74% at 1550 nm, dark count rate of 100 c/s, and a full width at half maximum timing jitter of 68 ps under a bias current of 18.0 μA with a practical Gifford-McMahon cryocooler system.

IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2013•1 citation

High efficiency superconducting nanowire single photon detector at wavelength 940 nm

Y. J. Chen, M. Gu, Labao Zhang +2 more

Superconducting nanowire single photon detectors with an optical resonant cavity structure are fabricated directly on the single crystal substrate. In order to enhance the photons absorption of incident light and improve system detection efficiency (SDE) efficiently, the structure of SNSPD was designed and optimized using the finite-difference time-domain analysis for different kinds of substrates. The NbN-SNSPDs fabricated on different substrates are measured and compared. The SDE of NbN-SNSPD on MgO substrate reaches 66 % at the wavelength of 940nm at a dark count rate of 100 cps by illuminating from the back of the device through single mode optical fiber.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Aug 1, 2015•0 citations

50 µm diameter superconducting nanowire single-photon detector with sub-17 ps timing jitter and high efficiency for visible wavelengths (Conference Presentation)

Jin Chang, Iman Esmaeil Zadeh

Superconducting nanowire single photon detectors (SNSPDs) have demonstrated advantages over traditional detectors in many fields [1]. Most fiber-coupled SNSPDs are coupled to single mode fibers, limiting their usability for applications where large surface area detectors are needed, for example fluorescence detection and satellite-based quantum communication [2][3]. Other important requirements for many applications are broadband detection efficiency, and low timing jitter [4]. So far, the increased meander length of multimode detectors, and the therefore increased kinetic inductance and number of imperfections due to film inhomogeneities have limited the timing jitter [5]. Moreover, combining low timing jitter with high detection efficiency and low dark count rate in one device is challenging due to the tradeoffs between different properties of SNSPDs [6]. In this paper, we achieved high efficiency and strong saturation over a broad wavelength range with a low timing jitter of 16.99 ps while maintaining a low dark count rate of < 0.2 Hz for an SNSPD coupled to a 50 µm core multimode fiber. To enhance the broadband absorption from 405 nm to 830 nm, detectors were fabricated on an optimized SiO2 cavity and Aluminum mirror. The geometry of the nanowire was also tuned to reach a good internal saturation of efficiency over the visible/NIR range but also to carry high current to get a large signal. Furthermore, a cryogenic readout amplifier was optimized to improve the signal to noise ratio and thus lead to high time resolution. Our devices can be readily used to enable higher resolution and faster quantum optics, bio-imaging, laser ranging and other optical experiments.

Quantum Optics and Photon Counting•May 13, 2019•0 citations
We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.
We report the development of the multimode fiber-coupled superconducting nanowire single-photon detector with high system detection efficiency at visible wavelength. The detector consists of a 10.5-nm-thick and 150-nm-wide NbN nanowire meander fabricated on a Si substrate with a multilayer dielectric mirror and a quarter wavelength cavity for obtaining high optical absorptance. The meander area was 35 µm in diameter and coupled with the GRIN-lensed multimode optical fiber with a core diameter of 50 µm. The system reached detection efficiency of 70% with dark count rate of 100 Hz at the wavelength of 635 nm, 3 dB roll-off response counting rate of 8.5 Mcps, and timing jitter of 76 ps.
Satellite-ground quantum communication requires single-photon detectors of 850-nm wavelength with both high detection efficiency and large sensitive area. We developed superconducting nanowire single-photon detectors (SNSPDs) on one-dimensional photonic crystals, which acted as optical cavities to enhance the optical absorption, with a sensitive-area diameter of 50 μm. The fabricated multimode fiber coupled NbN SNSPDs exhibited a maximum system detection efficiency (DE) of up to 82% and a DE of 78% at a dark count rate of 100 Hz at 850-nm wavelength as well as a system jitter of 105 ps.
Implementations of quantum information require single-photon detectors (SPDs) with high detection efficiency (DE) at a wavelength of 940 nm, which is a challenge for the available semiconducting SPDs. Superconducting nanowire SPDs (SNSPDs) are capable of detecting visible and near-infrared single photons with high DE. However, these detection capabilities place stringent design requirements on the cavity and nanowire geometry structures. We design, fabricate, and measure SNSPDs with high DE optimized for the 940-nm wavelength. The NbN SNSPDs were fabricated on 1-D photonic crystals for high optical absorptance. By tuning the filling factor of the nanowire through numerical simulations and experiments, we were able to obtain an SNSPD (7 nm thick, 125 nm width, and 0.57 filling factor, as well as active area of18∗18 μm18\ast 18\ \mu\text{m}18∗18 μm) with a saturated system DE of 83.6$\pm3.73.7%, at a dark count rate of 10 Hz, and a low polarization dependence of 1.173.7\pm$0.02. To our best knowledge, this is the highest value reported for NbN SNSPDs at 940-nm wavelength. The availability of an SNSPD with high system DE at 940 nm may have a profound impact in the field of photonic quantum technologies, such as multiphoton entanglement.
We present high performance fiber-coupled niobium titanium nitride superconducting nanowire single photon detectors fabricated on thermally oxidized silicon substrates. By applying a double sided cavity structure, simulated absorptance in the nanowire meander reached 97% at 1550 nm wavelength. The fabricated device showed a system detection efficiency (DE) of 74% at 1550 nm, dark count rate of 100 c/s, and a full width at half maximum timing jitter of 68 ps under a bias current of 18.0 μA with a practical Gifford-McMahon cryocooler system.
Superconducting nanowire single photon detectors with an optical resonant cavity structure are fabricated directly on the single crystal substrate. In order to enhance the photons absorption of incident light and improve system detection efficiency (SDE) efficiently, the structure of SNSPD was designed and optimized using the finite-difference time-domain analysis for different kinds of substrates. The NbN-SNSPDs fabricated on different substrates are measured and compared. The SDE of NbN-SNSPD on MgO substrate reaches 66 % at the wavelength of 940nm at a dark count rate of 100 cps by illuminating from the back of the device through single mode optical fiber.
Superconducting nanowire single photon detectors (SNSPDs) have demonstrated advantages over traditional detectors in many fields [1]. Most fiber-coupled SNSPDs are coupled to single mode fibers, limiting their usability for applications where large surface area detectors are needed, for example fluorescence detection and satellite-based quantum communication [2][3]. Other important requirements for many applications are broadband detection efficiency, and low timing jitter [4]. So far, the increased meander length of multimode detectors, and the therefore increased kinetic inductance and number of imperfections due to film inhomogeneities have limited the timing jitter [5]. Moreover, combining low timing jitter with high detection efficiency and low dark count rate in one device is challenging due to the tradeoffs between different properties of SNSPDs [6]. In this paper, we achieved high efficiency and strong saturation over a broad wavelength range with a low timing jitter of 16.99 ps while maintaining a low dark count rate of < 0.2 Hz for an SNSPD coupled to a 50 µm core multimode fiber. To enhance the broadband absorption from 405 nm to 830 nm, detectors were fabricated on an optimized SiO2 cavity and Aluminum mirror. The geometry of the nanowire was also tuned to reach a good internal saturation of efficiency over the visible/NIR range but also to carry high current to get a large signal. Furthermore, a cryogenic readout amplifier was optimized to improve the signal to noise ratio and thus lead to high time resolution. Our devices can be readily used to enable higher resolution and faster quantum optics, bio-imaging, laser ranging and other optical experiments.