Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1504.07628 · Quantum Studies Mathematics and Foundations

A scheme for performing strong and weak sequential measurements of non-commuting observables

Aharon Brodutch, Eliahu Cohen

Published Aug 23, 2016• 11 citations
arXivHTMLPDF

Abstract

Quantum systems usually travel a multitude of different paths when evolving through time from an initial to a final state. In general, the possible paths will depend on the future and past boundary conditions, as well as the system’s dynamics. We present a gedanken experiment where a single system apparently follows mutually exclusive paths simultaneously, each with probability one, depending on which measurement was performed. This experiment involves the measurement of observables that do not correspond to Hermitian operators. Our main result is a scheme for measuring these operators. The scheme is based on the erasure protocol [Brodutch and Cohen (Phys. Rev. Lett. 116:070404, 2016)] and allows a wide range of sequential measurements at both the weak and strong limits. At the weak limit the back action of the measurement cannot be used to account for the surprising behaviour and the resulting weak values provide a consistent yet strange account of the system’s past.

DOI
10.1007/s40509-016-0084-8

Related papers

Simultaneous weak measurement of non-commuting observables: a generalized Arthurs-Kelly protocol

Maicol A. Ochoa, Wolfgang Belzig, Abraham Nitzan

In contrast to a projective quantum measurement, in a weak measurement the system is only weakly perturbed while only partial information on the measured observable is obtained. A simultaneous measurement of non-commuting observables cannot be projective, however the strongest possible such measurement can be defined as providing their values at the smallest uncertainty limit. Starting with the Arthurs and Kelly (AK) protocol for such measurement of position and momentum, we derive a systematic extension to a corresponding weak measurement along three steps: First, a plausible form of the weak measurement operator analogous to the Gaussian Kraus operator, often used to model a weak measurement of a single observable, is obtained by projecting a naïve extension (valid for commuting observable) onto the corresponding Gabor space. Second, we show that the so obtained set of measurement operators satisfies the normalization condition for the probability to obtain given values of the position and momentum in the weak measurement operation, namely that this set constitutes a positive operator valued measure (POVM) in the position-momentum space. Finally, we show that the so-obtained measurement operator corresponds to a generalization of the AK measurement protocol in which the initial detector wavefunctions is suitable broadened.

arXiv:1707.08276•Scientific Reports•Oct 19, 2018•20 citations

Phase transitions in sequential weak measurements

Wen-Long Ma, Ping Wang, Weng-Hang Leong +1 more

Quantum measurement can be strong or weak, the former being important in readout and initialization of quantum objects and the latter being useful for monitoring and maneuvering quantum evolution. However, the boundary between weak and strong measurement is unclear. Here we show that a phase transition occurs in sequential quantum measurement, which unambiguously separates the weak and strong measurement by a critical value of measurement strength or duration. We formulate the probability distribution of the output of a sequence of quantum measurements as the Boltzmann distribution of an interacting spin model. The measurement results present phase transitions similar to those in the spin model. In particular the sequential commuting positive operator-valued measurement is mapped to a long-range Ising model, and a projective measurement emerges from sequential weak measurements when the strength or the number of measurements becomes above certain critical values, corresponding to the ferromagnetic phase transition of the spin model. This finding sheds insights on sequential quantum measurement, and also provides the theoretical foundation for constructing projective measurements from sequential weak measurements, which have applications in steering the quantum evolution and initializing quantum systems where strong measurement in a single shot is often not possible.

arXiv:1711.02482•Physical Review A•Jul 13, 2018•25 citations

The Retrocausal Nature of Quantum Measurement Revealed by Partial and Weak Measurements

Avshalom C. Elitzur, Eliahu Cohen, Daniel P. Sheehan

Quantum measurement is sometimes more effective when its result is not definite. Partial measurement turns the initial superposition not into a certain state but to a greater probability for it, enabling probing the quantum state in cases where complete measurement makes the noncommuting variables inaccessible. It also enables full quantum erasure that, unlike prevailing method, can be carried out even on recorded results. Aharonov's weak measurement is another method of imprecisely measuring quantum variables, outsmarting the uncertainty principle in even subtler ways. Happily, the two methods complement and corroborate one another in several interesting ways. We gedankenly apply these measurements to the EPR case. A pair of entangled particles undergoes more than one pair of partial and weak measurements, which, unlike complete measurements, leave them partially correlated. Their erasure is then shown to be as nonlocal as measurement itself. Surprisingly, the temporal relations between such measurements in the EPR setting do not follow the temporal sequence perceived by an external observer. For each particle, the measurements performed on the other operate as if they occurred (with signs reversed) in its own past, and in reversed order. This fully accords with Cramer's transactional interpretation and Aharonov's two state‐vector formalism.

AIP conference proceedings•Jan 1, 2011•16 citations

What the complex joint probabilities observed in weak measurements can tell us about quantum physics

Holger Friedrich Hofmann

Quantum mechanics does not permit joint measurements of non-commuting observables.However, it is possible to measure the weak value of a projection operator, followed by the precise measurement of a different property.The results can be interpreted as complex joint probabilities of the two non-commuting measurement outcomes.Significantly, it is possible to predict the outcome of completely different measurements by combining the joint probabilities of the initial state with complex conditional probabilities relating the new measurement to the possible combinations of measurement outcomes used in the characterization of the quantum state.We can therefore conclude that the complex conditional probabilities observed in weak measurements describe fundamental state-independent relations between non-commuting properties that represent the most fundamental form of universal laws in quantum physics.

arXiv:1303.0078•AIP conference proceedings•Jan 1, 2014•6 citations

Experimental realization of sequential weak measurements of non-commuting Pauli observables

Jiang-Shan Chen, Meng-Jun Hu, Xiao-Min Hu +5 more

Sequential weak measurements of non-commuting observables are not only fundamentally interesting in terms of quantum measurement but also show potential in various applications. Previously reported methods, however, can only make limited sequential weak measurements experimentally. In this article, we propose the realization of sequential measurements of non-commuting Pauli observables and experimentally demonstrate for the first time the measurement of sequential weak values of three non-commuting Pauli observables using genuine single photons.

arXiv:1805.02235•Optics Express•Feb 20, 2019•31 citations

Sequential measurements of non-commuting observables with quantum controlled interactions

Holger F Hofmann

The origin of non-classical correlations is difficult to identify since the uncertainty principle requires that information obtained about one observable invariably results in the disturbance of any other non-commuting observable. Here, this problem is addressed by investigating the uncertainty trade-off between measurement errors and disturbance for measurement interactions controlled by the state of a single qubit, where the measurement is described by a quantum coherent superposition of a fully projective measurement and the identity operation. It is shown that the measurement statistics obtained from a quantum controlled measurement of followed by a projective measurement of can be explained in terms of a simple combination of resolution and back-action errors acting on an intrinsic joint probability of the non-commuting observables defined by the input state of the system. These intrinsic joint probabilities are consistent with the complex-valued joint probabilities recently observed in weak measurements of quantum systems and provide direct evidence of non-commutativity in the form of imaginary correlations between the non-commuting operators. In quantum controlled measurements, these imaginary correlations can be converted into well-defined contributions to the real measurement statistics, allowing a direct experimental observation of the less intuitive aspects of quantum theory.

arXiv:1212.2683•New Journal of Physics•Jun 24, 2014•35 citations
Quantum systems usually travel a multitude of different paths when evolving through time from an initial to a final state. In general, the possible paths will depend on the future and past boundary conditions, as well as the system’s dynamics. We present a gedanken experiment where a single system apparently follows mutually exclusive paths simultaneously, each with probability one, depending on which measurement was performed. This experiment involves the measurement of observables that do not correspond to Hermitian operators. Our main result is a scheme for measuring these operators. The scheme is based on the erasure protocol [Brodutch and Cohen (Phys. Rev. Lett. 116:070404, 2016)] and allows a wide range of sequential measurements at both the weak and strong limits. At the weak limit the back action of the measurement cannot be used to account for the surprising behaviour and the resulting weak values provide a consistent yet strange account of the system’s past.
In contrast to a projective quantum measurement, in a weak measurement the system is only weakly perturbed while only partial information on the measured observable is obtained. A simultaneous measurement of non-commuting observables cannot be projective, however the strongest possible such measurement can be defined as providing their values at the smallest uncertainty limit. Starting with the Arthurs and Kelly (AK) protocol for such measurement of position and momentum, we derive a systematic extension to a corresponding weak measurement along three steps: First, a plausible form of the weak measurement operator analogous to the Gaussian Kraus operator, often used to model a weak measurement of a single observable, is obtained by projecting a naïve extension (valid for commuting observable) onto the corresponding Gabor space. Second, we show that the so obtained set of measurement operators satisfies the normalization condition for the probability to obtain given values of the position and momentum in the weak measurement operation, namely that this set constitutes a positive operator valued measure (POVM) in the position-momentum space. Finally, we show that the so-obtained measurement operator corresponds to a generalization of the AK measurement protocol in which the initial detector wavefunctions is suitable broadened.
Quantum measurement can be strong or weak, the former being important in readout and initialization of quantum objects and the latter being useful for monitoring and maneuvering quantum evolution. However, the boundary between weak and strong measurement is unclear. Here we show that a phase transition occurs in sequential quantum measurement, which unambiguously separates the weak and strong measurement by a critical value of measurement strength or duration. We formulate the probability distribution of the output of a sequence of quantum measurements as the Boltzmann distribution of an interacting spin model. The measurement results present phase transitions similar to those in the spin model. In particular the sequential commuting positive operator-valued measurement is mapped to a long-range Ising model, and a projective measurement emerges from sequential weak measurements when the strength or the number of measurements becomes above certain critical values, corresponding to the ferromagnetic phase transition of the spin model. This finding sheds insights on sequential quantum measurement, and also provides the theoretical foundation for constructing projective measurements from sequential weak measurements, which have applications in steering the quantum evolution and initializing quantum systems where strong measurement in a single shot is often not possible.
Quantum measurement is sometimes more effective when its result is not definite. Partial measurement turns the initial superposition not into a certain state but to a greater probability for it, enabling probing the quantum state in cases where complete measurement makes the noncommuting variables inaccessible. It also enables full quantum erasure that, unlike prevailing method, can be carried out even on recorded results. Aharonov's weak measurement is another method of imprecisely measuring quantum variables, outsmarting the uncertainty principle in even subtler ways. Happily, the two methods complement and corroborate one another in several interesting ways. We gedankenly apply these measurements to the EPR case. A pair of entangled particles undergoes more than one pair of partial and weak measurements, which, unlike complete measurements, leave them partially correlated. Their erasure is then shown to be as nonlocal as measurement itself. Surprisingly, the temporal relations between such measurements in the EPR setting do not follow the temporal sequence perceived by an external observer. For each particle, the measurements performed on the other operate as if they occurred (with signs reversed) in its own past, and in reversed order. This fully accords with Cramer's transactional interpretation and Aharonov's two state‐vector formalism.
Quantum mechanics does not permit joint measurements of non-commuting observables.However, it is possible to measure the weak value of a projection operator, followed by the precise measurement of a different property.The results can be interpreted as complex joint probabilities of the two non-commuting measurement outcomes.Significantly, it is possible to predict the outcome of completely different measurements by combining the joint probabilities of the initial state with complex conditional probabilities relating the new measurement to the possible combinations of measurement outcomes used in the characterization of the quantum state.We can therefore conclude that the complex conditional probabilities observed in weak measurements describe fundamental state-independent relations between non-commuting properties that represent the most fundamental form of universal laws in quantum physics.
Sequential weak measurements of non-commuting observables are not only fundamentally interesting in terms of quantum measurement but also show potential in various applications. Previously reported methods, however, can only make limited sequential weak measurements experimentally. In this article, we propose the realization of sequential measurements of non-commuting Pauli observables and experimentally demonstrate for the first time the measurement of sequential weak values of three non-commuting Pauli observables using genuine single photons.
The origin of non-classical correlations is difficult to identify since the uncertainty principle requires that information obtained about one observable invariably results in the disturbance of any other non-commuting observable. Here, this problem is addressed by investigating the uncertainty trade-off between measurement errors and disturbance for measurement interactions controlled by the state of a single qubit, where the measurement is described by a quantum coherent superposition of a fully projective measurement and the identity operation. It is shown that the measurement statistics obtained from a quantum controlled measurement of followed by a projective measurement of can be explained in terms of a simple combination of resolution and back-action errors acting on an intrinsic joint probability of the non-commuting observables defined by the input state of the system. These intrinsic joint probabilities are consistent with the complex-valued joint probabilities recently observed in weak measurements of quantum systems and provide direct evidence of non-commutativity in the form of imaginary correlations between the non-commuting operators. In quantum controlled measurements, these imaginary correlations can be converted into well-defined contributions to the real measurement statistics, allowing a direct experimental observation of the less intuitive aspects of quantum theory.