Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1406.1810 · Applied Physics Letters

High-efficiency WSi superconducting nanowire single-photon detectors operating at 2.5 K

V. B. Verma, Boris A. Korzh, Félix Bussières, R. D. Horansky, A. E. Lita, Francesco Marsili, Matthew D. Shaw, H. Zbinden, Richard P. Mirin, S. W. Nam

Published Sep 22, 2014• 75 citations
arXivHTMLPDF

Abstract

We investigate the operation of WSi superconducting nanowire single-photon detectors (SNSPDs) at 2.5 K, a temperature which is ∼70% of the superconducting transition temperature (TC) of 3.4 K. We demonstrate saturation of the system detection efficiency at 78 ± 2% at a wavelength of 1310 nm, with a jitter of 191 ps. We find that the jitter at 2.5 K is limited by the noise of the readout and can be improved through the use of cryogenic amplifiers. Operation of SNSPDs with high efficiency at temperatures very close to TC appears to be a unique property of amorphous WSi.

DOI
10.1063/1.4896045

Related papers

High-efficiency superconducting nanowire single-photon detectors fabricated from MoSi thin-films

V. B. Verma, B. Korzh, F. Bussières +9 more

We report on MoSi SNSPDs which achieved high system detection efficiency (87.1 ± 0.5% at 1542 nm) at 0.7 K and we demonstrate that these detectors can also be operated with saturated internal efficiency at a temperature of 2.3 K in a Gifford-McMahon cryocooler. We measured a minimum system jitter of 76 ps, maximum count rate approaching 10 MHz, and polarization dependence as low as 3.3 ± 0.1%. The performance of MoSi SNSPDs at 2.3 K is similar to the performance of WSi SNSPDs at < 1 K. The higher operating temperature of MoSi SNSPDs makes these devices promising for widespread use due to the simpler and less expensive cryogenics required for their operation.

arXiv:1504.02793•Optics Express•Dec 22, 2015•140 citations

Superconducting nanowire single photon detectors fabricated from an amorphous Mo0.75Ge0.25 thin film

Varun Boehm Verma, Adriana E. Lita, Michael R. Vissers +4 more

We present the characteristics of superconducting nanowire single photon detectors (SNSPDs) fabricated from amorphous Mo0.75Ge0.25 thin-films. Fabricated devices show a saturation of the internal detection efficiency at temperatures below 1 K, with system dark count rates below 500 cps. Operation in a closed-cycle cryocooler at 2.5 K is possible with system detection efficiencies exceeding 20% for SNSPDs which have not been optimized for high detection efficiency. Jitter is observed to vary between 69 ps at 250 mK and 187 ps at 2.5 K using room temperature amplifiers.

arXiv:1402.4526•Applied Physics Letters•Jul 14, 2014•77 citations

High-detection efficiency and low-timing jitter with amorphous superconducting nanowire single-photon detectors

Misael Caloz, Matthieu Perrenoud, Claire Autebert +6 more

Recent progress in the development of superconducting nanowire single-photon detectors (SNSPDs) made of amorphous materials has delivered excellent performances and has had a great impact on a range of research fields. Despite showing the highest system detection efficiency (SDE) ever reported with SNSPDs, amorphous materials typically lead to lower critical currents, which have impacts on their jitter performance. Combining a very low jitter and a high SDE remains a challenge. Here, we report on highly efficient superconducting nanowire single-photon detectors based on amorphous MoSi, combining system jitters as low as 26 ps and a SDE of 80% at 1550 nm. We also report detailed observations on the jitter behaviour, which hints at intrinsic limitations and leads to practical implications for SNSPD performance.

arXiv:1710.06740•Applied Physics Letters•Feb 5, 2018•110 citations

Superconducting nanowire single photon detectors based on amorphous superconductors (Conference Presentation)

Boris A. Korzh, Misael Caloz, Jelmer J. Renema +4 more

Superconducting nanowire single photon detectors (SNSPD) made from amorphous superconductors have showed great promise for achieving high fabrication yields, due to the highly uniform nature of the films. We present progress on the development of SNSPD based on amorphous MoSi with a critical temperature of around 5 K, which is ideal for detector operation at temperatures of 1 – 2.5 K, accessible with widely available cryogenic systems. First generation devices have achieved a saturated internal efficiency from visible to near-infrared wavelengths, which is the first requirement for high overall system efficiency. The broadband response has allowed us to make a robust study the energy-current relation in these devices, which defines the current required for a saturated internal detection efficiency for a given incident photon energy. Contrary to previous studies with other material systems, we find a nonlinear energy-current relation, which is an important insight into the detection mechanism in SNSPDs. The latest generation devices have been embedded into an micro-cavity structure in order to increase the system detection efficiency, which has increased to over 65% at 1550 nm. The efficiency is believed to be limited by fabrication imperfections and we present ongoing progress towards improving this characteristic as well as the yield of the devices. Efforts are also being made towards increasing the maximum operating temperature of the devices.

•Jun 9, 2017•0 citations

Superconducting Nanowire Single Photon Detectors with High System Detection Efficiency at Telecom Wavelengths

Francesco Marsili, Varun Boehm Verma, Jeff A. Stern +9 more

We report on a fiber-coupled eight-channel single-photon-detection system employing superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten silicide (WSi) with system detection efficiency ranging from 81 to 89 % at 1550 nm wavelength.

Conference on Lasers and Electro-Optics•Jan 1, 2013•1 citation

Superconducting nanowire single-photon detectors based on amorphous tungsten germanide

Shi‐Jie Yang, Ying Chen, Limin Sun +13 more

In this Letter, we characterized superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten germanide (W0.8Ge0.2) superconducting films, which exhibit superconducting properties comparable to those of amorphous WSi. The nanowire width ranges from 60 to 90 nm, with a fixed filling factor of 30%. All fabricated devices exhibit saturated intrinsic detection efficiency for infrared photons with wavelengths up to 2 μm, indicating that WGe is a promising candidate for SNSPDs designed for mid- and far-infrared photon detection. The timing jitter of these detectors, measured with a room-temperature amplifier, ranges from 127 to 234.5 ps. Further improvements can be achieved through device geometry optimization or the implementation of cryogenic amplifiers.

Applied Physics Letters•Apr 21, 2025•5 citations
We investigate the operation of WSi superconducting nanowire single-photon detectors (SNSPDs) at 2.5 K, a temperature which is ∼70% of the superconducting transition temperature (TC) of 3.4 K. We demonstrate saturation of the system detection efficiency at 78 ± 2% at a wavelength of 1310 nm, with a jitter of 191 ps. We find that the jitter at 2.5 K is limited by the noise of the readout and can be improved through the use of cryogenic amplifiers. Operation of SNSPDs with high efficiency at temperatures very close to TC appears to be a unique property of amorphous WSi.
We report on MoSi SNSPDs which achieved high system detection efficiency (87.1 ± 0.5% at 1542 nm) at 0.7 K and we demonstrate that these detectors can also be operated with saturated internal efficiency at a temperature of 2.3 K in a Gifford-McMahon cryocooler. We measured a minimum system jitter of 76 ps, maximum count rate approaching 10 MHz, and polarization dependence as low as 3.3 ± 0.1%. The performance of MoSi SNSPDs at 2.3 K is similar to the performance of WSi SNSPDs at < 1 K. The higher operating temperature of MoSi SNSPDs makes these devices promising for widespread use due to the simpler and less expensive cryogenics required for their operation.
We present the characteristics of superconducting nanowire single photon detectors (SNSPDs) fabricated from amorphous Mo0.75Ge0.25 thin-films. Fabricated devices show a saturation of the internal detection efficiency at temperatures below 1 K, with system dark count rates below 500 cps. Operation in a closed-cycle cryocooler at 2.5 K is possible with system detection efficiencies exceeding 20% for SNSPDs which have not been optimized for high detection efficiency. Jitter is observed to vary between 69 ps at 250 mK and 187 ps at 2.5 K using room temperature amplifiers.
Recent progress in the development of superconducting nanowire single-photon detectors (SNSPDs) made of amorphous materials has delivered excellent performances and has had a great impact on a range of research fields. Despite showing the highest system detection efficiency (SDE) ever reported with SNSPDs, amorphous materials typically lead to lower critical currents, which have impacts on their jitter performance. Combining a very low jitter and a high SDE remains a challenge. Here, we report on highly efficient superconducting nanowire single-photon detectors based on amorphous MoSi, combining system jitters as low as 26 ps and a SDE of 80% at 1550 nm. We also report detailed observations on the jitter behaviour, which hints at intrinsic limitations and leads to practical implications for SNSPD performance.
Superconducting nanowire single photon detectors (SNSPD) made from amorphous superconductors have showed great promise for achieving high fabrication yields, due to the highly uniform nature of the films. We present progress on the development of SNSPD based on amorphous MoSi with a critical temperature of around 5 K, which is ideal for detector operation at temperatures of 1 – 2.5 K, accessible with widely available cryogenic systems. First generation devices have achieved a saturated internal efficiency from visible to near-infrared wavelengths, which is the first requirement for high overall system efficiency. The broadband response has allowed us to make a robust study the energy-current relation in these devices, which defines the current required for a saturated internal detection efficiency for a given incident photon energy. Contrary to previous studies with other material systems, we find a nonlinear energy-current relation, which is an important insight into the detection mechanism in SNSPDs. The latest generation devices have been embedded into an micro-cavity structure in order to increase the system detection efficiency, which has increased to over 65% at 1550 nm. The efficiency is believed to be limited by fabrication imperfections and we present ongoing progress towards improving this characteristic as well as the yield of the devices. Efforts are also being made towards increasing the maximum operating temperature of the devices.
In this Letter, we characterized superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten germanide (W0.8Ge0.2) superconducting films, which exhibit superconducting properties comparable to those of amorphous WSi. The nanowire width ranges from 60 to 90 nm, with a fixed filling factor of 30%. All fabricated devices exhibit saturated intrinsic detection efficiency for infrared photons with wavelengths up to 2 μm, indicating that WGe is a promising candidate for SNSPDs designed for mid- and far-infrared photon detection. The timing jitter of these detectors, measured with a room-temperature amplifier, ranges from 127 to 234.5 ps. Further improvements can be achieved through device geometry optimization or the implementation of cryogenic amplifiers.