Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1403.7085 · Physical Review A

Optimal signal recovery for pulsed balanced detection

Yannick A. de Icaza Astiz, Vito Giovanni Lucivero, Roberto de J. León‐Montiel, Morgan W. Mitchell

Published Sep 10, 2014• 6 citations
arXivHTMLPDF

Abstract

We demonstrate a tool for filtering technical and electronic noises from pulses of light, especially relevant for signal processing methods in quantum optics experiments as a means to achieve the shot-noise level and reduce strong technical noise by means of a pattern function. We provide the theory of this pattern-function filtering based on balance detection. Moreover, we implement an experimental demonstration where 10 dB of technical noise is filtered after balance detection. Such filter can readily be used for probing magnetic atomic ensembles in environments with strong technical noise.

DOI
10.1103/physreva.90.033814

Related papers

Balanced homodyne detection of optical quantum states at audio-band frequencies and below

M S Stefszky, C M Mow-Lowry, S. Chua +7 more

The advent of stable, highly squeezed states of light has generated great interest in the gravitational wave community as a means for improving the quantumnoise- limited performance of advanced interferometric detectors. To confidently measure these squeezed states, it is first necessary to measure the shot-noise across the frequency band of interest. Technical noise, such as non-stationary events, beam pointing, and parasitic interference, can corrupt shot-noise measurements at low Fourier frequencies, below tens of kilo-Hertz. In this paper we present a qualitative investigation into all of the relevant noise sources and the methods by which they can be identified and mitigated in order to achieve quantum noise limited balanced homodyne detection. Using these techniques, flat shot-noise down to Fourier frequencies below 0.5 Hz is produced. This enables the direct observation of large magnitudes of squeezing across the entire audio-band, of particular interest for ground-based interferometric gravitational wave detectors. 11.6 dB of shot-noise suppression is directly observed, with more than 10 dB down to 10 Hz.

arXiv:1205.3229•Classical and Quantum Gravity•Jun 25, 2012•135 citations

Ultrasensitive pulsed, balanced homodyne detector: application to time-domain quantum measurements

Hauke Hansen, Thomas Aichele, Christian Hettich +4 more

A pulsed, balanced homodyne detector has been developed for precise measurement of the electric field quadratures of pulsed optical quantum states. A high level of common mode suppression (>85 dB) and low electronic noise (730 electrons per pulse) provide a signal-to-noise ratio of 14 dB for measurement of the quantum noise of individual pulses. Measurements at repetition rates as high as 1 MHz are possible. As a test, quantum tomography of the coherent state was performed, and the Wigner function and the density matrix were reconstructed with 99.5% fidelity. The detection system can be used for ultrarsensitive balanced detection in cw mode, e.g., for weak absorption measurements.

arXiv:quant-ph/0104084•Optics Letters•Nov 1, 2001•141 citations

Quantum tomography for time domain Balanced Homodyne Detection with high electronic noise

Martina Esposito, Daniele Fausti, Stefano Olivares +6 more

Here we report on the design, construction and characterization of a time domain Balanced Homodyne Detection apparatus operating in the regime of high electronic noise. The experimental setup has been commissioned by studying coherent ultrashort ( ∼ 80 fs) light pulses using Pattern-function Quantum Tomography. Furthermore, we proved that the electronic noise can be treated as a detector inefficiency showing the effectiveness of this approach by measuring light coherent states with different energies. In Quantum Mechanics the measurement of the state of a physical system implies to estimate the expectation value of any observable of the system. For a generic operator the expectation value is obtained starting from the measurement of an ensemble of observables defined “quorum ” 1. In particular, for the electromagnetic field the quorum is a continuum set of the field quadra-tures2,3. Balanced Homodyne Detection (BHD) is an experimen-tal method for measuring a discrete set of the field

•Jan 11, 2013•1 citation

Sub-shot-noise measurements with pulsed twin beams of light

Jianming Huang, Orhan Aytür, Prem Kumar

Recently, we have observed as much as 7 dB of quantum-noise reduction in the direct difference detection of twin-beam signal and idler outputs from a traveling-wave optical parametric amplifier (OPA).1 The OPA, which consists of a type-II phase-matched KTiOPO4 crystal, is pumped by the second harmonic of a mode-locked and Q-switched Nd:YAG laser. Here we describe an experiment in which we used these twin-beam pulses to improve on the optimal (shot-noise-limited) direct-detection signal-to-noise ratio (SNR) that can be achieved with coherent-state pulses of light of the same peak power.

Annual Meeting Optical Society of America•Jan 1, 1990•0 citations

Fast time-domain balanced homodyne detection of light

Ondřej Haderka, Václav Michálek, Vladimir Urbasek +1 more

A balanced homodyne detection scheme with nanosecond time resolution and sub-shot-noise sensitivity has been developed and successfully tested yielding an efficient detection scheme for high-speed quantum-optical measurements and communication protocols, for example, quantum cryptography. The parameters of the detector and its precise balancing allow complete characterization of quantum states created by femtosecond light pulses that include the measurement of photon number, optical phase, and statistical properties with a high signal-to-noise ratio for the whole bandwidth from DC to several tens of megahertz. The electronic part of the detector is based on a commercially available amplifier that provides ease of construction and use while yielding good performance.

Applied Optics•May 13, 2009•32 citations

Balanced-heterodyne detection of sub-shot-noise optical signals

Sheng Feng, Lu, Zehuan, Jie Zhang +1 more

As part of the effort to make use of squeezed states of light for detection of sub-shot-noise optical signals, we study the balanced heterodyne scheme, for which the corresponding spectral density of the photocurrent fluctuations produced at the output of the detector is calculated as the Fourier transform of their autocorrelation function. Our analysis shows that, for maximal signal-to-noise ratio enhancement by use of squeezed states of light, an optical signal to be measured must be carried in the squeezed quadrature of the carrier field. We discuss how "the additional heterodyne noise" can be eliminated in this scheme and its potential application to gravitational-wave searching. To demonstrate the practical feasibility, we propose and study a phase-locking technique for this scheme.

arXiv:1112.3155•Dec 14, 2011•4 citations
We demonstrate a tool for filtering technical and electronic noises from pulses of light, especially relevant for signal processing methods in quantum optics experiments as a means to achieve the shot-noise level and reduce strong technical noise by means of a pattern function. We provide the theory of this pattern-function filtering based on balance detection. Moreover, we implement an experimental demonstration where 10 dB of technical noise is filtered after balance detection. Such filter can readily be used for probing magnetic atomic ensembles in environments with strong technical noise.
The advent of stable, highly squeezed states of light has generated great interest in the gravitational wave community as a means for improving the quantumnoise- limited performance of advanced interferometric detectors. To confidently measure these squeezed states, it is first necessary to measure the shot-noise across the frequency band of interest. Technical noise, such as non-stationary events, beam pointing, and parasitic interference, can corrupt shot-noise measurements at low Fourier frequencies, below tens of kilo-Hertz. In this paper we present a qualitative investigation into all of the relevant noise sources and the methods by which they can be identified and mitigated in order to achieve quantum noise limited balanced homodyne detection. Using these techniques, flat shot-noise down to Fourier frequencies below 0.5 Hz is produced. This enables the direct observation of large magnitudes of squeezing across the entire audio-band, of particular interest for ground-based interferometric gravitational wave detectors. 11.6 dB of shot-noise suppression is directly observed, with more than 10 dB down to 10 Hz.
A pulsed, balanced homodyne detector has been developed for precise measurement of the electric field quadratures of pulsed optical quantum states. A high level of common mode suppression (>85 dB) and low electronic noise (730 electrons per pulse) provide a signal-to-noise ratio of 14 dB for measurement of the quantum noise of individual pulses. Measurements at repetition rates as high as 1 MHz are possible. As a test, quantum tomography of the coherent state was performed, and the Wigner function and the density matrix were reconstructed with 99.5% fidelity. The detection system can be used for ultrarsensitive balanced detection in cw mode, e.g., for weak absorption measurements.
Here we report on the design, construction and characterization of a time domain Balanced Homodyne Detection apparatus operating in the regime of high electronic noise. The experimental setup has been commissioned by studying coherent ultrashort ( ∼ 80 fs) light pulses using Pattern-function Quantum Tomography. Furthermore, we proved that the electronic noise can be treated as a detector inefficiency showing the effectiveness of this approach by measuring light coherent states with different energies. In Quantum Mechanics the measurement of the state of a physical system implies to estimate the expectation value of any observable of the system. For a generic operator the expectation value is obtained starting from the measurement of an ensemble of observables defined “quorum ” 1. In particular, for the electromagnetic field the quorum is a continuum set of the field quadra-tures2,3. Balanced Homodyne Detection (BHD) is an experimen-tal method for measuring a discrete set of the field
Recently, we have observed as much as 7 dB of quantum-noise reduction in the direct difference detection of twin-beam signal and idler outputs from a traveling-wave optical parametric amplifier (OPA).1 The OPA, which consists of a type-II phase-matched KTiOPO4 crystal, is pumped by the second harmonic of a mode-locked and Q-switched Nd:YAG laser. Here we describe an experiment in which we used these twin-beam pulses to improve on the optimal (shot-noise-limited) direct-detection signal-to-noise ratio (SNR) that can be achieved with coherent-state pulses of light of the same peak power.
A balanced homodyne detection scheme with nanosecond time resolution and sub-shot-noise sensitivity has been developed and successfully tested yielding an efficient detection scheme for high-speed quantum-optical measurements and communication protocols, for example, quantum cryptography. The parameters of the detector and its precise balancing allow complete characterization of quantum states created by femtosecond light pulses that include the measurement of photon number, optical phase, and statistical properties with a high signal-to-noise ratio for the whole bandwidth from DC to several tens of megahertz. The electronic part of the detector is based on a commercially available amplifier that provides ease of construction and use while yielding good performance.
As part of the effort to make use of squeezed states of light for detection of sub-shot-noise optical signals, we study the balanced heterodyne scheme, for which the corresponding spectral density of the photocurrent fluctuations produced at the output of the detector is calculated as the Fourier transform of their autocorrelation function. Our analysis shows that, for maximal signal-to-noise ratio enhancement by use of squeezed states of light, an optical signal to be measured must be carried in the squeezed quadrature of the carrier field. We discuss how "the additional heterodyne noise" can be eliminated in this scheme and its potential application to gravitational-wave searching. To demonstrate the practical feasibility, we propose and study a phase-locking technique for this scheme.