Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1401.4088 · Physical Review E

Measuring the heat exchange of a quantum process

John Goold, Ulrich Poschinger, Kavan Kishore Modi

Published Aug 12, 2014• 53 citations
arXivHTMLPDF

Abstract

Very recently, interferometric methods have been proposed to measure the full statistics of work performed on a driven quantum system [Dorner et al., Phys. Rev. Lett. 110, 230601 (2013) and Mazzola et al., Phys. Rev. Lett. 110, 230602 (2013)]. The advantage of such schemes is that they replace the necessity to make projective measurements by performing phase estimation on an appropriately coupled ancilla qubit. These proposals are one possible route to the tangible experimental exploration of quantum thermodynamics, a subject which is the center of much current attention due to the current control of mesoscopic quantum systems. In this Rapid Communication we demonstrate that a modification of the phase estimation protocols can be used in order to measure the heat distribution of a quantum process. In addition, we demonstrate how our scheme maybe implemented using ion trap technology. Our scheme should pave the way for experimental explorations of the Landauer principle and hence the intricate energy to information conversion in mesoscopic quantum systems.

DOI
10.1103/physreve.90.020101

Related papers

Experimental demonstration of information to energy conversion in a quantum system at the Landauer limit

John P. S. Peterson, Roberto S. Sarthour, Alexandre M. Souza +5 more

Landauer's principle sets fundamental thermodynamical constraints for classical and quantum information processing, thus affecting not only various branches of physics, but also of computer science and engineering. Despite its importance, this principle was only recently experimentally considered for classical systems. Here we employ a nuclear magnetic resonance set-up to experimentally address the information to energy conversion in a quantum system. Specifically, we consider a three nuclear spins [Formula: see text] (qubits) molecule-the system, the reservoir and the ancilla-to measure the heat dissipated during the implementation of a global system-reservoir unitary interaction that changes the information content of the system. By employing an interferometric technique, we were able to reconstruct the heat distribution associated with the unitary interaction. Then, through quantum state tomography, we measured the relative change in the entropy of the system. In this way, we were able to verify that an operation that changes the information content of the system must necessarily generate heat in the reservoir, exactly as predicted by Landauer's principle. The scheme presented here allows for the detailed study of irreversible entropy production in quantum information processors.

arXiv:1412.6490•Proceedings of the Royal Society A Mathematical Physical and Engineering Sciences•Apr 1, 2016•134 citations

Employing circuit QED to measure non-equilibrium work fluctuations

Michele Campisi, Ralf Blattmann, Sigmund Kohler +2 more

We study an interferometric method for measuring the statistics of work performed on a driven quantum system, which has been put forward recently (Dorner et al 2013 Phys. Rev. Lett. 110 230601, Mazzola et al 2013 Phys. Rev. Lett. 110 230602). This method allows the replacement of two projective measurements of the energy of the driven system with qubit tomography of an ancilla that is appropriately coupled to it. We highlight that this method could be employed to obtain the work statistics of closed as well as open driven system, even in the strongly dissipative regime. We then illustrate an implementation of the method in a circuit QED setup, which allows one to experimentally obtain the work statistics of a parametrically driven harmonic oscillator. Our implementation is an extension of the original method, in which two ancilla-qubits are employed and the work statistics are retrieved through two-qubit state tomography. Our simulations demonstrate the experimental feasibility.

arXiv:1307.2371•New Journal of Physics•Oct 28, 2013•72 citations

Detecting the work statistics through Ramsey-like interferometry

Laura Mazzola, Gabriele De Chiara, Mauro Paternostro

Out-of-equilibrium statistical mechanics is attracting considerable interest due to the recent advances in the control and manipulations of systems at the quantum level. Recently, an interferometric scheme for the detection of the characteristic function of the work distribution following a time-dependent process has been proposed [L. Mazzola et al., Phys. Rev. Lett.110 (2013) 230602]. There, it was demonstrated that the work statistics of a quantum system undergoing a process can be reconstructed by effectively mapping the characteristic function of work on the state of an ancillary qubit. Here, we expand that work in two important directions. We first apply the protocol to an interesting specific physical example consisting of a superconducting qubit dispersively coupled to the field of a microwave resonator, thus enlarging the class of situations for which our scheme would be key in the task highlighted above. We then account for the interaction of the system with an additional one (which might embody an environment), and generalize the protocol accordingly.

arXiv:1401.0566•International Journal of Quantum Information•Mar 1, 2014•21 citations

Experimental Verification of Fluctuation Relations with a Quantum Computer

Andrea Solfanelli, Alessandro Santini, Michele Campisi

Inspired by the idea that quantum computers can be useful in advancing basic science, we use a quantum processor to experimentally validate a number of theoretical results in non-equilibrium quantum thermodynamics, that were not (or were very little) corroborated so far.In order to do so, we first put forward a novel method to implement the so called two-point measurement scheme, which is at the basis of the study of nonequilibrium energetic exchanges in quantum systems.Like previously established methods, our method uses an ancillary system, but at variance with them, it provides direct access to the energy exchange statistics, and is, accordingly more effective, at least when applied to small quantum systems.Using a quantum computer as a remotely programmable experimental platform, we first validate our ancilla-assisted two-point measurement scheme, and then apply it to (i) experimentally verify that fluctuation theorems are robust against projective measurements, a theoretical prediction, which was not validated so far; (ii) experimentally verify the so-called heat-engine fluctuation relation, by implementing a SWAP quantum heat engine; (iii) experimentally verify that the heat-engine fluctuation relation holds for measurement-fueled quantum heat engines, by implementing the design at the basis of the so-called quantum-measurement-cooling concept.For both engines, we report the measured average heat and work exchanged and single out their operation mode.Our experiments constitute an experimental basis for the understanding of the nonequilibrium energetics of quantum computation and for the implementation of energy-management devices on quantum processors.

arXiv:2106.04388•PRX Quantum•Sep 30, 2021•70 citations

Measurement-induced operation of two-ion quantum heat machines

Suman Chand, Asoka Biswas

We show how one can implement a quantum heat machine by using two interacting trapped ions, in presence of a thermal bath. The electronic states of the ions act like a working substance, while the vibrational mode is modelled as the cold bath. The heat exchange with the cold bath is mimicked by the projective measurement of the electronic states. We show how such measurement in a suitable basis can lead to either a quantum heat engine or a refrigerator, which undergoes a quantum Otto cycle. The local magnetic field is adiabatically changed during the heat cycle. The performance of the heat machine depends upon the interaction strength between the ions, the magnetic fields, and the measurement cost. In our model, the coupling to the hot and the cold baths is never switched off in an alternative fashion during the heat cycle, unlike other existing proposals of quantum heat engines. This makes our proposal experimentally realizable using current tapped-ion technology.

arXiv:1703.05949•Physical review. E•Mar 7, 2017•46 citations

Feedback-controlled heat transport in quantum devices: theory and solid-state experimental proposal

Michele Campisi, Jukka P Pekola, Rosario Fazio

A theory of feedback-controlled heat transport in quantum systems is presented. It is based on modelling heat engines as driven multipartite systems subject to projective quantum measurements and measurement-conditioned unitary evolutions. The theory unifies various results presented previously in the literature. Feedback control breaks time reversal invariance. This in turn results in the fluctuation relation not being obeyed. Its restoration occurs through appropriate accounting of the gain and use of information via measurements and feedback. We further illustrate an experimental proposal for the realisation of a Maxwell demon using superconducting circuits and single-photon on-chip calorimetry. A two-level qubit acts as a trap-door, which, conditioned on its state, is coupled to either a hot resistor or a cold one. The feedback mechanism alters the temperatures felt by the qubit and can result in an effective inversion of temperature gradient, where heat flows from cold to hot thanks to the gain and use of information.

arXiv:1702.05604•New Journal of Physics•May 26, 2017•48 citations
Very recently, interferometric methods have been proposed to measure the full statistics of work performed on a driven quantum system [Dorner et al., Phys. Rev. Lett. 110, 230601 (2013) and Mazzola et al., Phys. Rev. Lett. 110, 230602 (2013)]. The advantage of such schemes is that they replace the necessity to make projective measurements by performing phase estimation on an appropriately coupled ancilla qubit. These proposals are one possible route to the tangible experimental exploration of quantum thermodynamics, a subject which is the center of much current attention due to the current control of mesoscopic quantum systems. In this Rapid Communication we demonstrate that a modification of the phase estimation protocols can be used in order to measure the heat distribution of a quantum process. In addition, we demonstrate how our scheme maybe implemented using ion trap technology. Our scheme should pave the way for experimental explorations of the Landauer principle and hence the intricate energy to information conversion in mesoscopic quantum systems.
Landauer's principle sets fundamental thermodynamical constraints for classical and quantum information processing, thus affecting not only various branches of physics, but also of computer science and engineering. Despite its importance, this principle was only recently experimentally considered for classical systems. Here we employ a nuclear magnetic resonance set-up to experimentally address the information to energy conversion in a quantum system. Specifically, we consider a three nuclear spins [Formula: see text] (qubits) molecule-the system, the reservoir and the ancilla-to measure the heat dissipated during the implementation of a global system-reservoir unitary interaction that changes the information content of the system. By employing an interferometric technique, we were able to reconstruct the heat distribution associated with the unitary interaction. Then, through quantum state tomography, we measured the relative change in the entropy of the system. In this way, we were able to verify that an operation that changes the information content of the system must necessarily generate heat in the reservoir, exactly as predicted by Landauer's principle. The scheme presented here allows for the detailed study of irreversible entropy production in quantum information processors.
We study an interferometric method for measuring the statistics of work performed on a driven quantum system, which has been put forward recently (Dorner et al 2013 Phys. Rev. Lett. 110 230601, Mazzola et al 2013 Phys. Rev. Lett. 110 230602). This method allows the replacement of two projective measurements of the energy of the driven system with qubit tomography of an ancilla that is appropriately coupled to it. We highlight that this method could be employed to obtain the work statistics of closed as well as open driven system, even in the strongly dissipative regime. We then illustrate an implementation of the method in a circuit QED setup, which allows one to experimentally obtain the work statistics of a parametrically driven harmonic oscillator. Our implementation is an extension of the original method, in which two ancilla-qubits are employed and the work statistics are retrieved through two-qubit state tomography. Our simulations demonstrate the experimental feasibility.
Out-of-equilibrium statistical mechanics is attracting considerable interest due to the recent advances in the control and manipulations of systems at the quantum level. Recently, an interferometric scheme for the detection of the characteristic function of the work distribution following a time-dependent process has been proposed [L. Mazzola et al., Phys. Rev. Lett.110 (2013) 230602]. There, it was demonstrated that the work statistics of a quantum system undergoing a process can be reconstructed by effectively mapping the characteristic function of work on the state of an ancillary qubit. Here, we expand that work in two important directions. We first apply the protocol to an interesting specific physical example consisting of a superconducting qubit dispersively coupled to the field of a microwave resonator, thus enlarging the class of situations for which our scheme would be key in the task highlighted above. We then account for the interaction of the system with an additional one (which might embody an environment), and generalize the protocol accordingly.
Inspired by the idea that quantum computers can be useful in advancing basic science, we use a quantum processor to experimentally validate a number of theoretical results in non-equilibrium quantum thermodynamics, that were not (or were very little) corroborated so far.In order to do so, we first put forward a novel method to implement the so called two-point measurement scheme, which is at the basis of the study of nonequilibrium energetic exchanges in quantum systems.Like previously established methods, our method uses an ancillary system, but at variance with them, it provides direct access to the energy exchange statistics, and is, accordingly more effective, at least when applied to small quantum systems.Using a quantum computer as a remotely programmable experimental platform, we first validate our ancilla-assisted two-point measurement scheme, and then apply it to (i) experimentally verify that fluctuation theorems are robust against projective measurements, a theoretical prediction, which was not validated so far; (ii) experimentally verify the so-called heat-engine fluctuation relation, by implementing a SWAP quantum heat engine; (iii) experimentally verify that the heat-engine fluctuation relation holds for measurement-fueled quantum heat engines, by implementing the design at the basis of the so-called quantum-measurement-cooling concept.For both engines, we report the measured average heat and work exchanged and single out their operation mode.Our experiments constitute an experimental basis for the understanding of the nonequilibrium energetics of quantum computation and for the implementation of energy-management devices on quantum processors.
We show how one can implement a quantum heat machine by using two interacting trapped ions, in presence of a thermal bath. The electronic states of the ions act like a working substance, while the vibrational mode is modelled as the cold bath. The heat exchange with the cold bath is mimicked by the projective measurement of the electronic states. We show how such measurement in a suitable basis can lead to either a quantum heat engine or a refrigerator, which undergoes a quantum Otto cycle. The local magnetic field is adiabatically changed during the heat cycle. The performance of the heat machine depends upon the interaction strength between the ions, the magnetic fields, and the measurement cost. In our model, the coupling to the hot and the cold baths is never switched off in an alternative fashion during the heat cycle, unlike other existing proposals of quantum heat engines. This makes our proposal experimentally realizable using current tapped-ion technology.
A theory of feedback-controlled heat transport in quantum systems is presented. It is based on modelling heat engines as driven multipartite systems subject to projective quantum measurements and measurement-conditioned unitary evolutions. The theory unifies various results presented previously in the literature. Feedback control breaks time reversal invariance. This in turn results in the fluctuation relation not being obeyed. Its restoration occurs through appropriate accounting of the gain and use of information via measurements and feedback. We further illustrate an experimental proposal for the realisation of a Maxwell demon using superconducting circuits and single-photon on-chip calorimetry. A two-level qubit acts as a trap-door, which, conditioned on its state, is coupled to either a hot resistor or a cold one. The feedback mechanism alters the temperatures felt by the qubit and can result in an effective inversion of temperature gradient, where heat flows from cold to hot thanks to the gain and use of information.