All optical detectors to date annihilate photons upon detection, thus excluding repeated measurements. Here, we demonstrate a robust photon detection scheme that does not rely on absorption. Instead, an incoming photon is reflected from an optical resonator containing a single atom prepared in a superposition of two states. The reflection toggles the superposition phase, which is then measured to trace the photon. Characterizing the device with faint laser pulses, a single-photon detection efficiency of 74% and a survival probability of 66% are achieved. The efficiency can be further increased by observing the photon repeatedly. The large single-photon nonlinearity of the experiment should enable the development of photonic quantum gates and the preparation of exotic quantum states of light.
All optical detectors to date annihilate photons upon detection, thus excluding repeated measurements. Here, we demonstrate a robust photon detection scheme that does not rely on absorption. Instead, an incoming photon is reflected from an optical resonator containing a single atom prepared in a superposition of two states. The reflection toggles the superposition phase, which is then measured to trace the photon. Characterizing the device with faint laser pulses, a single-photon detection efficiency of 74% and a survival probability of 66% are achieved. The efficiency can be further increased by observing the photon repeatedly. The large single-photon nonlinearity of the experiment should enable the development of photonic quantum gates and the preparation of exotic quantum states of light.
Abstract One of the biggest challenges in experimental quantum information is to sustain the fragile superposition state of a qubit1. Long lifetimes can be achieved for material qubit carriers as memories2, at least in principle, but not for propagating photons that are rapidly lost by absorption, diffraction or scattering3. The loss problem can be mitigated with a nondestructive photonic qubit detector that heralds the photon without destroying the encoded qubit. Such a detector is envisioned to facilitate protocols in which distributed tasks depend on the successful dissemination of photonic qubits4,5, improve loss-sensitive qubit measurements6,7 and enable certain quantum key distribution attacks8. Here we demonstrate such a detector based on a single atom in two crossed fibre-based optical resonators, one for qubit-insensitive atom–photon coupling and the other for atomic-state detection9. We achieve a nondestructive detection efficiency upon qubit survival of 79 ± 3 per cent and a photon survival probability of 31 ± 1 per cent, and we preserve the qubit information with a fidelity of 96.2 ± 0.3 per cent. To illustrate the potential of our detector, we show that it can, with the current parameters, improve the rate and fidelity of long-distance entanglement and quantum state distribution compared to previous methods, provide resource optimization via qubit amplification and enable detection-loophole-free Bell tests.
Since the emergence of quantum computing as a field, interactions between two-level systems that can carry quantum information have been conceptualized in terms of quantum devices. Here, I demonstrate four such devices for optical photons traveling in two different modes: an all-optical switch and transistor, a nondestructive photon detector, a phase shifter, and a quantum state generator. These devices rely on a nonlinear optical interface comprised of a few thousand atoms inside of a high-finesse optical cavity. Signal light is sent through a mode transverse to the cavity and is stored or travels through the atoms as a collective excitation. The corresponding atomic population couples to the cavity mode's optical field. The strength of the resulting photon-photon interaction is governed by the optical depth of the atoms for the signal light, and the strong atom-photon coupling in the optical cavity. I first demonstrate an all-optical switch and transistor using blocking interactions that reduce the cavity's transmission by a factor of 11 +/- 1 in the presence of a stored signal photon. This interaction creates anticorrelations between the output light in the signal and cavity paths. I show that these anticorrelations persist in time continuous operation when the photon signal and cavity arrive at the same time. Then, I turn to photon detection. I reconfigure the system and reconceptualize it as a nondestructive, cavity-based detector for signal light. I demonstrate strong correlations between this nondestructive detection and a subsequent destructive detection with non-destructive detection efficiency of 0.5%. Next, I show that a single cavity photon can shift the phase of stored signal light by up to 1.0 +/- 0.4 rad and demonstrate entanglement between output cavity and signal photons. Finally, I present recent experiments where this entanglement is used to modify the phase and amplitude of the signal light by making a projective measurement on the cavity light.
We study the use of detection devices in entanglement-based state preparation. In particular we consider optical detection devices such as single-photon sensitivity detectors, single-photon resolution detectors, and detector cascades (with an emphasis on the performance of realistic detectors). We develop an extensive theory for the use of these devices. In entanglement-based state preparation we perform measurements on subsystems, and we therefore need precise bounds on the distinguishability of these measurements (this is fundamentally different from, e.g., tomography, where an ensemble of identical states is used to determine probability distributions, etc.). To this end, we introduce the confidence of preparation, which may also be used to quantify the performance of detection devices in entanglement-based preparation. We give a general expression for detector cascades of arbitrary size for the detection up to two photons. We show that, contrary to the general belief, cascading does not give a practical advantage over detectors with single-photon resolution in entanglement-based state preparation.
Abstract One of the most fascinating aspects of quantum networks is their capability to distribute entanglement as a nonlocal communication resource1. In a first step, this requires network-ready devices that can generate and store entangled states2. Another crucial step, however, is to develop measurement techniques that allow for entanglement detection. Demonstrations for different platforms3–13 suffer from being not complete, destructive or local. Here, we demonstrate a complete and nondestructive measurement scheme14–16 that always projects any initial state of two spatially separated network nodes onto a maximally entangled state. Each node consists of an atom trapped inside an optical resonator from which two photons are successively reflected. Polarization measurements on the photons discriminate between the four maximally entangled states. Remarkably, such states are not destroyed by our measurement. In the future, our technique might serve to probe the decay of entanglement and to stabilize it against dephasing via repeated measurements17,18.
The article shows that a single photon source and straightforward, purely optical processes can be used to produce a linear superposition of two macroscopically identifiable optical coherent states. A superposition of coherent states in a freely propagating optical field with high coherence amplitude can be generated via weak squeezing on a single photon, beam mixing with an auxiliary coherent state, and photon detection with imperfect threshold detectors. (α>2) and F=0.99, which is extremely precise. Our technique does not require a precise photon count, resolving measurements, or nonlinear Kerr-type interactions, in contrast to all existing schemes for obtaining such a state. It also exhibits some tolerance to inefficiencies in photon generation and is robust against detection of inefficiencies.
Nondestructive quantum measurements are central for quantum physics applications ranging from quantum sensing to quantum computing and quantum communication. Employing the toolbox of cavity quantum electrodynamics, we here concatenate two identical nondestructive photon detectors to repeatedly detect and track a single photon propagating through a 60 m long optical fiber. By demonstrating that the combined signal-to-noise ratio of the two detectors surpasses each single one by about 2 orders of magnitude, we experimentally verify a key practical benefit of cascaded nondemolition detectors compared to conventional absorbing devices.