Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1303.0333

Production of a rubidium Bose-Einstein condensate in a hybrid trap with light induced atom desorption

Dezhi Xiong, Fudong Wang, Xiaoke Li, Ting-Fai Lam, Dajun Wang

Published Mar 2, 2013• 10 citations
arXivHTMLPDF

Abstract

We report on the production of a rubidium Bose-Einstein condensate in a simplified vacuum apparatus. Magneto-optical traps with large numbers and ultra-high vacuum for moderately long conservative trap lifetimes of 16 seconds are sequentially obtained with light induced rapid atomic vapor pressure modulation. Subsequent evaporative cooling is carried out in two stages in a hybrid magnetic quadrupole plus optical dipole trap. High evaporation efficiencies are observed in both stages and $^{87}$Rb BECs with more than 10$^5$ atoms can be reliably produced with total evaporation time of only 9.5 seconds.

DOI
10.48550/arxiv.1303.0333

Related papers

Compact setup for the production of 87Rb |F= 2,mF= + 2〉 Bose-Einstein condensates in a hybrid trap

Raffaele Nolli, Michela Venturelli, Luca Marmugi +2 more

We present a compact experimental apparatus for Bose-Einstein condensation of (87)Rb in the |F = 2, mF = + 2〉 state. A pre-cooled atomic beam of (87)Rb is obtained by using an unbalanced magneto-optical trap, allowing controlled transfer of trapped atoms from the first vacuum chamber to the science chamber. Here, atoms are transferred to a hybrid trap, as produced by overlapping a magnetic quadrupole trap with a far-detuned optical trap with crossed beam configuration, where forced radiofrequency evaporation is realized. The final evaporation leading to Bose-Einstein condensation is then performed by exponentially lowering the optical trap depth. Control and stabilization systems of the optical trap beams are discussed in detail. The setup reliably produces a pure condensate in the |F = 2, mF = + 2〉 state in 50 s, which includes 33 s loading of the science magneto-optical trap and 17 s forced evaporation.

arXiv:1608.03221•Review of Scientific Instruments•Aug 1, 2016•3 citations

Fast production of ultracold sodium gases using light-induced desorption and optical trapping

Emmanuel Mimoun, L. De Sarlo, David Jacob +2 more

In this article we report on the production of a Bose-Einstein condensate (BEC) of $^{23}\mathrm{Na}$ using light-induced desorption as an atomic source. We load about $2\ifmmode\times\else\texttimes\fi{}{10}^{7}$ atoms in a magneto-optical trap (MOT) from this source with a $~6$ s loading time constant. The MOT lifetime can be kept around $27$ s by turning off the desorbing light after loading. We show that the pressure drops down by a factor of 40 in less than $100$ ms after the extinction of the desorbing light, restoring the low background pressure for evaporation. Using this technique, a BEC with ${10}^{4}$ atoms is produced after a $6$ s evaporation in an optical dipole trap.

arXiv:0911.5656•Physical Review A•Feb 26, 2010•35 citations

Rapid production of R87b Bose-Einstein condensates in a combined magnetic and optical potential

Y.-J. Lin, Abigail R. Perry, R. L. Compton +2 more

We describe an apparatus for quickly and simply producing $^{87}\text{R}\text{b}$ Bose-Einstein condensates. It is based on a magnetic quadrupole trap and a red-detuned optical dipole trap. We collect atoms in a magneto-optical trap (MOT) and then capture the atoms in a magnetic quadrupole trap and force rf evaporation. We then transfer the resulting cold dense cloud into a spatially mode-matched optical dipole trap by lowering the quadrupole field gradient to below gravity. This technique combines the efficient capture of atoms from a MOT into a magnetic trap with the rapid evaporation of optical dipole traps; the approach is insensitive to the peak quadrupole gradient and the precise trapping beam waist. Our system reliably produces a condensate with $N\ensuremath{\approx}2\ifmmode\times\else\texttimes\fi{}{10}^{6}$ atoms every 16 s.

arXiv:0904.3314•Physical Review A•Jun 29, 2009•217 citations

Production of87Rb Bose—Einstein condensates in a hybrid trap

Yafan Duan, Bo-Nan Jiang, Jian-Fang Sun +3 more

We report a rapid evaporative cooling method using a hybrid trap which is composed of a quadrupole magnetic trap and a one-beam optical dipole trap. It contains two kinds of evaporative coolings to reach the quantum degeneracy: initial radio-frequency (RF) enforced evaporative cooling in the quadrupole magnetic trap and further runaway evaporative cooling in the optical dipole trap. The hybrid trap does not require a very high power laser such as that in the traditional pure optical trap, but still has a deep trap depth and a large trap volume, and has better optical access than the normal magnetic trap like the quadrupole-Ioffe-configuration (QUIC) cloverleaf trap. A high trap frequency can be easily realized in the hybrid trap to enhance the elastic collision rate and shorten the evaporative cooling time. In our experiment, pure Bose—Einstein condensates (BECs) with about 1 × 10 5 atoms can be realized in 6 s evaporative cooling in the optical dipole trap.

Chinese Physics B•May 1, 2013•4 citations

High-Performance Sodium Bose–Einstein Condensate Apparatus with a Hybrid Trap and Long-Distance Magnetic Transfer

Feng Zhang, Yun Long, Jiang-Ling Yang +3 more

We report on the production of large sodium Bose–Einstein condensates in a hybrid of magnetic quadrupole and optical dipole trap. With an optimized spin-flip Zeeman slower, 2 × 10 10 sodium atoms are captured in the magneto-optical trap (MOT). A long distance magnetic transfer setup moves the cold atom over 46 cm from the MOT chamber to the UHV science chamber, which provides great optical access and long conservative trap lifetime. After evaporative cooling in the hybrid trap, we produce nearly pure condensates of 1 × 10 7 atoms with lifetime of 80 s in the optical dipole trap.

Chinese Physics Letters•Dec 1, 2015•4 citations

Fast production of 87Rb Bose-Einstein condensates

陈良超 CHEN Liang-chao, Zengming Meng, Pengjun Wang

A rapid atomic beam of rubidium (87Rb) is produced by two-dimensional magneto-optical trap (2D MOT), and then trapped by three-dimensional magneto-optical trap (3D MOT) with high vacuum for further cooling. After a process of optical molasses cooling, atoms are reloaded into a magnetic trap, where radio frequency (RF) evaporation cooling is implemented. The precooled atoms in the magnetic trap are then transferred into a far detuning optical dipole trap, where Bose-Einstein condensate (BEC) appears by further evaporation cooling. The 3D MOT is loaded to its maximum within 25 s and then BEC is prepared in 16 s. Due to the linear intensity of magnetic trap, the frequency can be scanned fast in the RF evaporation cooling process. In our experiment, the frequency scans from 39 MHz to 15 MHz in 6 s and then scans to 2 MHz in 5 s. The number of atoms in 3D MOT is about 11010, and there are 5105 atoms in the BEC after a succession of cooling processes. To optimize the performances of 2D MOT, a special light path is constructed. And prisms with high reflectivity are used to reduce the imbalance between opposite propagating cooling +beams. Furthermore, quarter-wave plates are used to keep the polarization state of the cooling beam when reflected by prisms or mirrors. The atoms are cooled to a temperature about 15 K in the magnetic trap by RF evaporation. In such a low temperature, the loss of magnetic trap (Majorana loss) will prevent the atoms from reaching a high density, and the atoms cannot be cooled further. To reduce the loss rate of the magnetic trap, the far blue detuning light (532 nm, 18 W) is added to plug the zero point of the magnetic trap. In the optically plugged magnetic trap, atoms with high density are cooled down enough, which gives a good start for the loading of optical dipole trap.

Acta Physica Sinica•Jan 1, 2017•5 citations
We report on the production of a rubidium Bose-Einstein condensate in a simplified vacuum apparatus. Magneto-optical traps with large numbers and ultra-high vacuum for moderately long conservative trap lifetimes of 16 seconds are sequentially obtained with light induced rapid atomic vapor pressure modulation. Subsequent evaporative cooling is carried out in two stages in a hybrid magnetic quadrupole plus optical dipole trap. High evaporation efficiencies are observed in both stages and 87^{87}87Rb BECs with more than 105^55 atoms can be reliably produced with total evaporation time of only 9.5 seconds.
We present a compact experimental apparatus for Bose-Einstein condensation of (87)Rb in the |F = 2, mF = + 2〉 state. A pre-cooled atomic beam of (87)Rb is obtained by using an unbalanced magneto-optical trap, allowing controlled transfer of trapped atoms from the first vacuum chamber to the science chamber. Here, atoms are transferred to a hybrid trap, as produced by overlapping a magnetic quadrupole trap with a far-detuned optical trap with crossed beam configuration, where forced radiofrequency evaporation is realized. The final evaporation leading to Bose-Einstein condensation is then performed by exponentially lowering the optical trap depth. Control and stabilization systems of the optical trap beams are discussed in detail. The setup reliably produces a pure condensate in the |F = 2, mF = + 2〉 state in 50 s, which includes 33 s loading of the science magneto-optical trap and 17 s forced evaporation.
In this article we report on the production of a Bose-Einstein condensate (BEC) of 23Na^{23}\mathrm{Na}23Na using light-induced desorption as an atomic source. We load about $2\ifmmode\times\else\texttimes\fi{}{10}^{7}$ atoms in a magneto-optical trap (MOT) from this source with a  6~6 6 s loading time constant. The MOT lifetime can be kept around 272727 s by turning off the desorbing light after loading. We show that the pressure drops down by a factor of 40 in less than 100100100 ms after the extinction of the desorbing light, restoring the low background pressure for evaporation. Using this technique, a BEC with 104{10}^{4}104 atoms is produced after a 666 s evaporation in an optical dipole trap.
We describe an apparatus for quickly and simply producing 87Rb^{87}\text{R}\text{b}87Rb Bose-Einstein condensates. It is based on a magnetic quadrupole trap and a red-detuned optical dipole trap. We collect atoms in a magneto-optical trap (MOT) and then capture the atoms in a magnetic quadrupole trap and force rf evaporation. We then transfer the resulting cold dense cloud into a spatially mode-matched optical dipole trap by lowering the quadrupole field gradient to below gravity. This technique combines the efficient capture of atoms from a MOT into a magnetic trap with the rapid evaporation of optical dipole traps; the approach is insensitive to the peak quadrupole gradient and the precise trapping beam waist. Our system reliably produces a condensate with $N\ensuremath{\approx}2\ifmmode\times\else\texttimes\fi{}{10}^{6}$ atoms every 16 s.
We report a rapid evaporative cooling method using a hybrid trap which is composed of a quadrupole magnetic trap and a one-beam optical dipole trap. It contains two kinds of evaporative coolings to reach the quantum degeneracy: initial radio-frequency (RF) enforced evaporative cooling in the quadrupole magnetic trap and further runaway evaporative cooling in the optical dipole trap. The hybrid trap does not require a very high power laser such as that in the traditional pure optical trap, but still has a deep trap depth and a large trap volume, and has better optical access than the normal magnetic trap like the quadrupole-Ioffe-configuration (QUIC) cloverleaf trap. A high trap frequency can be easily realized in the hybrid trap to enhance the elastic collision rate and shorten the evaporative cooling time. In our experiment, pure Bose—Einstein condensates (BECs) with about 1 × 10 5 atoms can be realized in 6 s evaporative cooling in the optical dipole trap.
We report on the production of large sodium Bose–Einstein condensates in a hybrid of magnetic quadrupole and optical dipole trap. With an optimized spin-flip Zeeman slower, 2 × 10 10 sodium atoms are captured in the magneto-optical trap (MOT). A long distance magnetic transfer setup moves the cold atom over 46 cm from the MOT chamber to the UHV science chamber, which provides great optical access and long conservative trap lifetime. After evaporative cooling in the hybrid trap, we produce nearly pure condensates of 1 × 10 7 atoms with lifetime of 80 s in the optical dipole trap.
A rapid atomic beam of rubidium (87Rb) is produced by two-dimensional magneto-optical trap (2D MOT), and then trapped by three-dimensional magneto-optical trap (3D MOT) with high vacuum for further cooling. After a process of optical molasses cooling, atoms are reloaded into a magnetic trap, where radio frequency (RF) evaporation cooling is implemented. The precooled atoms in the magnetic trap are then transferred into a far detuning optical dipole trap, where Bose-Einstein condensate (BEC) appears by further evaporation cooling. The 3D MOT is loaded to its maximum within 25 s and then BEC is prepared in 16 s. Due to the linear intensity of magnetic trap, the frequency can be scanned fast in the RF evaporation cooling process. In our experiment, the frequency scans from 39 MHz to 15 MHz in 6 s and then scans to 2 MHz in 5 s. The number of atoms in 3D MOT is about 11010, and there are 5105 atoms in the BEC after a succession of cooling processes. To optimize the performances of 2D MOT, a special light path is constructed. And prisms with high reflectivity are used to reduce the imbalance between opposite propagating cooling +beams. Furthermore, quarter-wave plates are used to keep the polarization state of the cooling beam when reflected by prisms or mirrors. The atoms are cooled to a temperature about 15 K in the magnetic trap by RF evaporation. In such a low temperature, the loss of magnetic trap (Majorana loss) will prevent the atoms from reaching a high density, and the atoms cannot be cooled further. To reduce the loss rate of the magnetic trap, the far blue detuning light (532 nm, 18 W) is added to plug the zero point of the magnetic trap. In the optically plugged magnetic trap, atoms with high density are cooled down enough, which gives a good start for the loading of optical dipole trap.