Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1206.5145 · Physical Review A

Tomography and state reconstruction with superconducting single-photon detectors

J. J. Renema, G. Frucci, M. J. A. de Dood, Richard David Gill, Andrea Fiore, Martin P. van Exter

Published Dec 21, 2012• 12 citations
arXivHTMLPDF

Abstract

We investigate the performance of a single-element superconducting single-photon detector (SSPD) for quantum state reconstruction. We perform quantum state reconstruction, using the measured photon counting behavior of the detector. Standard quantum state reconstruction assumes a linear response; this simple model fails for SSPDs, which are known to show a nonlinear response intrinsic to the detection mechanism. We quantify the photon counting behavior of the SSPD by a sparsity-based detector tomography technique and use this to perform quantum state reconstruction of both thermal and coherent states. We find that the nonlinearities inherent in the detection process enhance the ability of the detector to do state reconstruction compared to a linear detector with similar efficiency for detecting single photons.

DOI
10.1103/physreva.86.062113

Related papers

Quantum State Reconstruction with a Single-element SSPD at Telecommunication Wavelengths

Jelmer J. Renema, G. Frucci, M. J. A. de Dood +2 more

We demonstrate high fidelity quantum state reconstruction of coherent and thermal states of light using a single NbN superconducting single photon detector (SSPD). SSPDs outperform commonly used avalanche photodiodes for the task of quantum state reconstruction.

Frontiers in Optics•Jan 1, 2012•0 citations

Spectroscopy With Nanostructured Superconducting Single Photon Detectors

Elisabeth Reiger, Dong Pan, Wojtek Slysz +10 more

Superconducting single-photon detectors (SSPDs) are nanostructured devices made from ultrathin superconducting films. They are typically operated at liquid helium temperature and exhibit high detection efficiency, in combination with very low dark counts, fast response time, and extremely low timing jitter, within a broad wavelength range from ultraviolet to mid-infrared (up to 6mum). SSPDs are very attractive for applications such as fiber-based telecommunication, where single-photon sensitivity and high photon-counting rates are required. We review the current state-of-the-art in the SSPD research and development, and compare the SSPD performance to the best semiconducting avalanche photodiodes and other superconducting photon detectors. Furthermore, we demonstrate that SSPDs can also be successfully implemented in photon-energy-resolving experiments. Our approach is based on the fact that the size of the hotspot, a nonsuperconducting region generated upon photon absorption, is linearly dependent on the photon energy. We introduce a statistical method, where, by measuring the SSPD system detection efficiency at different bias currents, we are able to resolve the wavelength of the incident photons with a resolution of 50 nm.

IEEE Journal of Selected Topics in Quantum Electronics•Jul 1, 2007•31 citations

Universal response curve for nanowire superconducting single-photon detectors

J. J. Renema, G. Frucci, Zili Zhou +6 more

Using detector tomography, we investigate the detection mechanism in NbN-based superconducting single photon detectors (SSPDs). We demonstrate that the detection probability uniquely depends on a particular linear combination of bias current and energy, for a large variation of bias currents, input energies and detection probabilities, producing a universal detection curve. We obtain this result by studying multiphoton excitations in a nanodetector with a sparsity-based tomographic method that allows factoring out of the optical absorption. We discuss the implication of our model system for the understanding of meander-type SSPDs.

arXiv:1301.3337•Physical Review B•May 30, 2013•33 citations

Superconducting single photon detectors for ultrasensitive visible and IR detection

R. Espiau de Lamaëstre, L. Maingault, Laurent Frey +5 more

Superconducting single photons detectors (SSPDs) have emerged in recent years as a promising alternative for fast and sensitive infrared detectors working in the photon counting mode. In particular, those detectors combine very low dark count rates (below 1 Hz), high speed (above 1GHz), photon number resolution and reasonable quantum efficiency (10 % at telecom wavelengths). They already found applications in quantum cryptography systems and integrated circuit failure analysis, but could also be used as ultimate sensors in matrix configurations. We show here the optimization of SSPD fabrication and their optical metrology at CEA. SSPD are fabricated by patterning a 80 nm wide nanowire in a very thin (4 nm) NbN film on sapphire, forming a pixel of several microns size. A cryogenic all-fibered optoelectronic system has been developed and allows precise metrology of the optical performances of SSPD. When biasing near the critical current of the nanowire, we demonstrate a detection quantum efficiency of 8 % at 1.55 μm, which is also found to be strongly polarization dependent. This quantum efficiency being limited by optical absorption, we propose a prism coupling based absorption enhancing structure that allows reaching 100 % quantum efficiency.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 22, 2009•4 citations

Quantum tomography of superconducting single photon detectors

J. J. Renema, Rosalinda Gaudio, Qiusha Wang +8 more

Nanowire superconducting single photon detectors (SSPDs) consist of a thin (~ 4 to 6 nm) and narrow (~ 50 to 200 nm) superconducting wire biased close to the critical current. Operating conditions are such that the absorption of one or more photons locally transfers the detector to its normal state, which then results in a detectable electrical pulse. SSPDs are versatile detectors that operate in a wide wavelength range (from UV to mid-infrared) with almost negligible dark counts. They are typically shaped in the form of a meander to cover a sizeable fraction of a sufficiently large 2D surface, but other shapes have also been produced and are often easier to analyse. Until recently, the working principle of SSPDs was badly understood and several competing theory were formulated.

•Jul 21, 2014•0 citations

Experimental investigation of the detection mechanism in WSi nanowire superconducting single photon detectors

Rosalinda Gaudio, Jelmer J. Renema, Zili Zhou +9 more

We use quantum detector tomography to investigate the detection mechanism in WSi nanowire superconducting single photon detectors. To this purpose, we fabricated a 250 nm wide and 250 nm long WSi nanowire and measured its response to impinging photons with wavelengths ranging from λ = 900 nm to λ = 1650 nm. Tomographic measurements show that the detector response depends on the total excitation energy only. Moreover, for total absorbed energies >0.8 eV the current–energy relation is linear, similar to what was observed in NbN nanowires, whereas the current–energy relation deviates from linear behavior for total energies below 0.8 eV.

arXiv:1602.07659•Applied Physics Letters•Jul 18, 2016•20 citations
We investigate the performance of a single-element superconducting single-photon detector (SSPD) for quantum state reconstruction. We perform quantum state reconstruction, using the measured photon counting behavior of the detector. Standard quantum state reconstruction assumes a linear response; this simple model fails for SSPDs, which are known to show a nonlinear response intrinsic to the detection mechanism. We quantify the photon counting behavior of the SSPD by a sparsity-based detector tomography technique and use this to perform quantum state reconstruction of both thermal and coherent states. We find that the nonlinearities inherent in the detection process enhance the ability of the detector to do state reconstruction compared to a linear detector with similar efficiency for detecting single photons.
Superconducting single-photon detectors (SSPDs) are nanostructured devices made from ultrathin superconducting films. They are typically operated at liquid helium temperature and exhibit high detection efficiency, in combination with very low dark counts, fast response time, and extremely low timing jitter, within a broad wavelength range from ultraviolet to mid-infrared (up to 6mum). SSPDs are very attractive for applications such as fiber-based telecommunication, where single-photon sensitivity and high photon-counting rates are required. We review the current state-of-the-art in the SSPD research and development, and compare the SSPD performance to the best semiconducting avalanche photodiodes and other superconducting photon detectors. Furthermore, we demonstrate that SSPDs can also be successfully implemented in photon-energy-resolving experiments. Our approach is based on the fact that the size of the hotspot, a nonsuperconducting region generated upon photon absorption, is linearly dependent on the photon energy. We introduce a statistical method, where, by measuring the SSPD system detection efficiency at different bias currents, we are able to resolve the wavelength of the incident photons with a resolution of 50 nm.
Using detector tomography, we investigate the detection mechanism in NbN-based superconducting single photon detectors (SSPDs). We demonstrate that the detection probability uniquely depends on a particular linear combination of bias current and energy, for a large variation of bias currents, input energies and detection probabilities, producing a universal detection curve. We obtain this result by studying multiphoton excitations in a nanodetector with a sparsity-based tomographic method that allows factoring out of the optical absorption. We discuss the implication of our model system for the understanding of meander-type SSPDs.
Superconducting single photons detectors (SSPDs) have emerged in recent years as a promising alternative for fast and sensitive infrared detectors working in the photon counting mode. In particular, those detectors combine very low dark count rates (below 1 Hz), high speed (above 1GHz), photon number resolution and reasonable quantum efficiency (10 % at telecom wavelengths). They already found applications in quantum cryptography systems and integrated circuit failure analysis, but could also be used as ultimate sensors in matrix configurations. We show here the optimization of SSPD fabrication and their optical metrology at CEA. SSPD are fabricated by patterning a 80 nm wide nanowire in a very thin (4 nm) NbN film on sapphire, forming a pixel of several microns size. A cryogenic all-fibered optoelectronic system has been developed and allows precise metrology of the optical performances of SSPD. When biasing near the critical current of the nanowire, we demonstrate a detection quantum efficiency of 8 % at 1.55 μm, which is also found to be strongly polarization dependent. This quantum efficiency being limited by optical absorption, we propose a prism coupling based absorption enhancing structure that allows reaching 100 % quantum efficiency.
Nanowire superconducting single photon detectors (SSPDs) consist of a thin (~ 4 to 6 nm) and narrow (~ 50 to 200 nm) superconducting wire biased close to the critical current. Operating conditions are such that the absorption of one or more photons locally transfers the detector to its normal state, which then results in a detectable electrical pulse. SSPDs are versatile detectors that operate in a wide wavelength range (from UV to mid-infrared) with almost negligible dark counts. They are typically shaped in the form of a meander to cover a sizeable fraction of a sufficiently large 2D surface, but other shapes have also been produced and are often easier to analyse. Until recently, the working principle of SSPDs was badly understood and several competing theory were formulated.
We use quantum detector tomography to investigate the detection mechanism in WSi nanowire superconducting single photon detectors. To this purpose, we fabricated a 250 nm wide and 250 nm long WSi nanowire and measured its response to impinging photons with wavelengths ranging from λ = 900 nm to λ = 1650 nm. Tomographic measurements show that the detector response depends on the total excitation energy only. Moreover, for total absorbed energies >0.8 eV the current–energy relation is linear, similar to what was observed in NbN nanowires, whereas the current–energy relation deviates from linear behavior for total energies below 0.8 eV.