Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1204.0327 · New Journal of Physics

The analogy between optical beam shifts and quantum weak measurements

Mark R Dennis, Jörg B. Götte

Published Jul 6, 2012• 122 citations
arXivHTMLPDF

Abstract

We describe how the notion of optical beam shifts (including the spatial and angular Goos-Hänchen shift and Imbert-Federov shift) can be understood as a classical analogue of a quantum measurement of the polarization state of a paraxial beam by its transverse amplitude distribution.Under this scheme, complex quantum weak values are interpreted as spatial and angular shifts of polarized scalar components of the reflected beam.This connection leads us to predict an extra spatial shift for beams with a radially-varying phase dependance.Contents 1. Introduction 2 2. Weak quantum measurement 4 3.The analogy between beam shifts and quantum measurement 5 4. The case of radial and azimuthally varying pointer phase 9 5. Discussion

DOI
10.1088/1367-2630/14/7/073013

Related papers

Weak Measurements on Optical Systems

Sayandip Dhara

The spatial and the angular variants of the Imbert-Federov (IF) beam shifts and the angular Goos-Hanchen (GH) shift contribute in a complex interrelated way to the resultant beam shift in partial reflection at planar dielectric interfaces. Here, we show that the two variants of the IF effects can be decoupled and separately observed by weak value amplification and subsequent conversion of spatial to angular nature of the beam shifts using appropriate pre and post-selection of polarization states. Such optimized weak measurement schemes also enable one to nullify one effect (either the GH or the IF) and exclusively observe the other. We experimentally demonstrate this and illustrate various other intriguing manifestations of optimized weak measurements in elliptical and / or linear polarization basis. We also present a Poincare sphere based analysis on conversion / retention of the angular or spatial nature of the shifts with pre and post-selection of states in weak measurement. In another separate experiment we set up a Mach-Zender interferometer with the weak measurement scheme for partial reflection in one hand of the interferometer to observe the effect of the geometric phase gradient at the time of weak measurement and interpret the effect as an effective rotation of the interference fringe pattern.

•Apr 1, 2016•0 citations

Observing angular deviations in light-beam reflection via weak measurements

Gaurav Jayaswal, Giampaolo Mistura, Michele Merano

An optical analog of the quantum weak measurement scheme proved to be very useful for the observation of optical beam shifts. Here we adapt the weak value amplification method to the observation of the angular Goos-Hänchen shift. We observe this effect in the case of external air-dielectric reflection, the more fundamental case in which it occurs. We show that weak measurements allow for a faithful amplification of the effect at any angle of incidence, even at Brewster's angle of incidence.

arXiv:1405.5710•Optics Letters•Oct 23, 2014•51 citations

Limits to superweak amplification of beam shifts

Jörg B. Götte, Mark R. Dennis

The magnitudes of beam shifts (Goos-Hänchen and Imbert-Fedorov, spatial and angular) are greatly enhanced when a reflected light beam is postselected by an analyzer, by analogy with superweak measurements in quantum theory. Particularly strong enhancements can be expected close to angles at which no light is transmitted for fixed initial and final polarizations. We derive a formula for the angular and spatial shifts at such angles (which includes the Brewster angle), and we show that their maximum size is limited by higher-order terms from the reflection coefficients occurring in the Artmann shift formula.

arXiv:1303.5038•Optics Letters•Jun 24, 2013•40 citations

Optimized weak measurements of Goos–Hänchen and Imbert–Fedorov shifts in partial reflection

Sumit Goswami, Sajal Dhara, Mandira Pal +3 more

The spatial and the angular variants of the Imbert-Federov (IF) beam shifts and the angular Goos-Hänchen (GH) shift contribute in a complex interrelated way to the resultant beam shift in partial reflection at planar dielectric interfaces. Here, we show that the two variants of the IF effects can be decoupled and separately observed by weak value amplification and subsequent conversion of spatial ↔angular nature of the beam shifts using appropriate pre and post selection of polarization states. Such optimized weak measurement schemes also enable one to nullify one effect (either the GH or the IF) and exclusively observe the other. We experimentally demonstrate this and illustrate various other intriguing manifestations of optimized weak measurements in elliptical and / or linear polarization basis. We also present a Poincare sphere based analysis on conversion / retention of the angular or spatial nature of the shifts with pre and post selection of states in weak measurement. The demonstrated ability to amplify, controllably decouple or combine the beam shifts via weak measurements may prove to be valuable for understanding the different physical contributions of the effects and for their applications in sensing and precision metrology.

arXiv:1511.03062•Optics Express•Mar 9, 2016•37 citations

Weak Measurements in Nano-optics

Niladri Modak, Ankit Kumar Singh, Shyamal Guchhait +3 more

Background: Weak measurement involves weak coupling between the system and the measuring device (pointer) enables large amplification and high precision measurement of small physical parameters. The outcome of this special measurement procedure involving nearly mutually orthogonal pre- and post-selection of states in such weakly interacting systems leads to weak value that can become exceedingly large and lie outside the eigenvalue spectrum of the measured observable. This unprecedented ability of weak value amplification of small physical parameters has been successfully exploited for various metrological applications in the optical domain and beyond. Even though it is a quantum mechanical concept, it can be understood using the classical electromagnetic theory of light and thus can be realized in classical optics. Objective: Here, we briefly review the basic concepts of weak measurement and weak value amplification, provide illustrative examples of its implementation in various optical domains. The applications involve measuring ultra-sensitive beam deflections, high precision measurements of angular rotation, phase shift, temporal shift, frequency shift and so forth, and expand this extraordinary concept in the domain of nano-optics and plasmonics. Methods: In order to perform weak value amplification, we have used Gaussian beam and spectral response as the pointer subsequently. The polarization state associated with the pointer is used as pre and post-selection device. Results: We reveal the weak value amplification of sub-wavelength optical effects namely the Goos-Hänchen shift and the spin hall shift. Further, we demonstrate weak measurements using spectral line shape of resonance as a natural pointer, enabling weak value amplification beyond the conventional limit, demonstrating natural weak value amplification in plasmonic Fano resonances and so forth. The discussed concepts could have useful implications in various nano-optical systems to amplify tiny signals or effects. Conclusion: The emerging prospects of weak value amplification towards the development of novel optical weak measurement devices for metrological applications are extensively discussed.

Current Nanomaterials•Jul 24, 2020•6 citations

Weak measurement of the Goos–Hänchen shift of partially coherent light beams

Octávio J. S. Santana, Luís E. E. de Araujo

Optical beam shifts are very small and challenging phenomena to measure. Weak measurement techniques have been developed to amplify and more easily measure the shifts of spatially coherent beams. We here investigate theoretically a weak measurement technique for measuring the Goos–Hänchen shift of partially spatially coherent beams. We show that the amplification factor of the technique depends on the global coherence degree of the field and on the size of the Goos–Hänchen shift experienced by the beam. Large amplification factors can be obtained for low shifts, even for very incoherent beams. But, for higher beam shifts, such as those occurring near critical incidence, the amplification factors are modest to low for beams of low coherence.

Journal of the Optical Society of America B•Jan 31, 2019•7 citations
We describe how the notion of optical beam shifts (including the spatial and angular Goos-Hänchen shift and Imbert-Federov shift) can be understood as a classical analogue of a quantum measurement of the polarization state of a paraxial beam by its transverse amplitude distribution.Under this scheme, complex quantum weak values are interpreted as spatial and angular shifts of polarized scalar components of the reflected beam.This connection leads us to predict an extra spatial shift for beams with a radially-varying phase dependance.Contents 1. Introduction 2 2. Weak quantum measurement 4 3.The analogy between beam shifts and quantum measurement 5 4. The case of radial and azimuthally varying pointer phase 9 5. Discussion
The spatial and the angular variants of the Imbert-Federov (IF) beam shifts and the angular Goos-Hanchen (GH) shift contribute in a complex interrelated way to the resultant beam shift in partial reflection at planar dielectric interfaces. Here, we show that the two variants of the IF effects can be decoupled and separately observed by weak value amplification and subsequent conversion of spatial to angular nature of the beam shifts using appropriate pre and post-selection of polarization states. Such optimized weak measurement schemes also enable one to nullify one effect (either the GH or the IF) and exclusively observe the other. We experimentally demonstrate this and illustrate various other intriguing manifestations of optimized weak measurements in elliptical and / or linear polarization basis. We also present a Poincare sphere based analysis on conversion / retention of the angular or spatial nature of the shifts with pre and post-selection of states in weak measurement. In another separate experiment we set up a Mach-Zender interferometer with the weak measurement scheme for partial reflection in one hand of the interferometer to observe the effect of the geometric phase gradient at the time of weak measurement and interpret the effect as an effective rotation of the interference fringe pattern.
An optical analog of the quantum weak measurement scheme proved to be very useful for the observation of optical beam shifts. Here we adapt the weak value amplification method to the observation of the angular Goos-Hänchen shift. We observe this effect in the case of external air-dielectric reflection, the more fundamental case in which it occurs. We show that weak measurements allow for a faithful amplification of the effect at any angle of incidence, even at Brewster's angle of incidence.
The magnitudes of beam shifts (Goos-Hänchen and Imbert-Fedorov, spatial and angular) are greatly enhanced when a reflected light beam is postselected by an analyzer, by analogy with superweak measurements in quantum theory. Particularly strong enhancements can be expected close to angles at which no light is transmitted for fixed initial and final polarizations. We derive a formula for the angular and spatial shifts at such angles (which includes the Brewster angle), and we show that their maximum size is limited by higher-order terms from the reflection coefficients occurring in the Artmann shift formula.
The spatial and the angular variants of the Imbert-Federov (IF) beam shifts and the angular Goos-Hänchen (GH) shift contribute in a complex interrelated way to the resultant beam shift in partial reflection at planar dielectric interfaces. Here, we show that the two variants of the IF effects can be decoupled and separately observed by weak value amplification and subsequent conversion of spatial ↔angular nature of the beam shifts using appropriate pre and post selection of polarization states. Such optimized weak measurement schemes also enable one to nullify one effect (either the GH or the IF) and exclusively observe the other. We experimentally demonstrate this and illustrate various other intriguing manifestations of optimized weak measurements in elliptical and / or linear polarization basis. We also present a Poincare sphere based analysis on conversion / retention of the angular or spatial nature of the shifts with pre and post selection of states in weak measurement. The demonstrated ability to amplify, controllably decouple or combine the beam shifts via weak measurements may prove to be valuable for understanding the different physical contributions of the effects and for their applications in sensing and precision metrology.
Background: Weak measurement involves weak coupling between the system and the measuring device (pointer) enables large amplification and high precision measurement of small physical parameters. The outcome of this special measurement procedure involving nearly mutually orthogonal pre- and post-selection of states in such weakly interacting systems leads to weak value that can become exceedingly large and lie outside the eigenvalue spectrum of the measured observable. This unprecedented ability of weak value amplification of small physical parameters has been successfully exploited for various metrological applications in the optical domain and beyond. Even though it is a quantum mechanical concept, it can be understood using the classical electromagnetic theory of light and thus can be realized in classical optics. Objective: Here, we briefly review the basic concepts of weak measurement and weak value amplification, provide illustrative examples of its implementation in various optical domains. The applications involve measuring ultra-sensitive beam deflections, high precision measurements of angular rotation, phase shift, temporal shift, frequency shift and so forth, and expand this extraordinary concept in the domain of nano-optics and plasmonics. Methods: In order to perform weak value amplification, we have used Gaussian beam and spectral response as the pointer subsequently. The polarization state associated with the pointer is used as pre and post-selection device. Results: We reveal the weak value amplification of sub-wavelength optical effects namely the Goos-Hänchen shift and the spin hall shift. Further, we demonstrate weak measurements using spectral line shape of resonance as a natural pointer, enabling weak value amplification beyond the conventional limit, demonstrating natural weak value amplification in plasmonic Fano resonances and so forth. The discussed concepts could have useful implications in various nano-optical systems to amplify tiny signals or effects. Conclusion: The emerging prospects of weak value amplification towards the development of novel optical weak measurement devices for metrological applications are extensively discussed.
Optical beam shifts are very small and challenging phenomena to measure. Weak measurement techniques have been developed to amplify and more easily measure the shifts of spatially coherent beams. We here investigate theoretically a weak measurement technique for measuring the Goos–Hänchen shift of partially spatially coherent beams. We show that the amplification factor of the technique depends on the global coherence degree of the field and on the size of the Goos–Hänchen shift experienced by the beam. Large amplification factors can be obtained for low shifts, even for very incoherent beams. But, for higher beam shifts, such as those occurring near critical incidence, the amplification factors are modest to low for beams of low coherence.