Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1203.3998 · Physical Review B

Unconventional rf photoresponse from a superconducting spiral resonator

Alexander P. Zhuravel, Cihan Kurter, Alexey Vladimirovich Ustinov, Steven M. Anlage

Published Apr 30, 2012• 25 citations
arXivHTMLPDF

Abstract

Superconducting thin film resonators employing strip geometries show great promise in rf/microwave applications due to their low loss and compact nature. However, their functionality is limited by nonlinear effects at elevated rf/microwave powers. Here, we show that by using a planar spiral geometry carrying parallel currents in adjacent turns, this limitation can be minimized. We investigate the rf current distributions in spiral resonators implemented with Nb thin films via laser scanning microscopy. The rf current density profile along the width of the individual turns of the resonators reveals an unconventional trend: maximum current in the middle of the structure and decaying toward its edges. This unusual behavior is associated with the circular nature of the geometry and the cancellation of magnetic field between the turns, which is favorable for handling high powers since it allows the linear characteristics to persist at high rf current densities.

DOI
10.1103/physrevb.85.134535

Related papers

Magnetic-field-tolerant superconducting spiral resonators for circuit quantum electrodynamics

Mihirangi Medahinne, Yadav P. Kandel, Suraj Thapa Magar +3 more

We present thin-film niobium ($\mathrm{Nb}$) spiral resonators exhibiting large geometric inductance, high critical magnetic fields, and high single-photon quality factors. These low-loss geometric inductors can be a compelling alternative to kinetic inductors to create high-impedance superconducting devices for applications that require magnetic fields. By varying the spiral pitch, we realize resonators with characteristic impedances ranging from $3.25--7.09\phantom{\rule{0.2em}{0ex}}\mathrm{k}\mathrm{\ensuremath{\Omega}}$. We measure the temperature and magnetic-field-dependent losses and find that the high-impedance resonators maintain an intrinsic quality factor above approximately ${10}^{5}$ for parallel magnetic fields of up to 1 T. These properties make spiral $\mathrm{Nb}$ resonators a promising candidate for quantum devices that require circuit elements with high impedance and magnetic-field resilience.

arXiv:2406.10386•Physical Review Applied•Jan 28, 2025•7 citations

Influence of LaAlO3 surface topography on rf current distribution in superconducting microwave devices

Alexander P. Zhuravel, Alexey Vladimirovich Ustinov, K. Solomon Harshavardhan +1 more

A laser scanning microscope with a thermal spot size of about 4 μm is used to measure a quantity proportional to the rf current density in an operating superconducting coplanar waveguide microwave resonator. The twinning of the LaAlO3 substrate produces a meandering of the current at the edges due to irregularities in the wet etching of the YBa2Cu3O7−δ film associated with substrate twin domain blocks, and an (∼20%) enhancement of the rf photoresponse at these locations. These irregularities are candidates for enhanced nonlinear response from the device.

arXiv:cond-mat/0209614•Applied Physics Letters•Dec 19, 2002•31 citations

Phase-resolved visualization of radio-frequency standing waves in superconducting spiral resonator for metamaterial applications

A. A. Leha, Alexander P. Zhuravel, Alexandre Karpov +2 more

Superconducting microcircuits and metamaterials are promising candidates for use in new generation cryogenic electronics. Their functionality is largely justified by the macroscopic distribution of electromagnetic fields in arranged unit cells, rather than by the microscopic properties of composite materials. We present a new method for visualizing the spatial structure of penetrating microwaves with microscopic resolution in planar superconducting macroscopic resonators as the most important circuit-forming elements of modern microelectronics. This method uses a low-temperature laser scanning microscope that examines the phase (i.e., direction) and amplitude of local radio-frequency currents versus the two-dimensional coordinates of the superconducting resonant structure under test. Phase-sensitive contrast is achieved by synchronizing the intensity-modulated laser radiation with the resonant harmonics of the microwave signal passing through the sample. In this case, the laser-beam-induced loss in the illuminated area will strongly depend on the local phase difference between the RF carrier signal and the spatially temporal structure of the focused laser oscillation. This approach eliminates the hardware limitations of the existing technique of radio-frequency microscopy and brings the phase-sensitive demodulation mode to the level necessary for studying the physics of superconducting metamaterials. The advantage of the presented method over the previous method of RF laser scanning micros-copy is demonstrated by the example of the formation of standing waves in a spiral superconducting Archimedean resonator up to the 38th eigenmode resonance.

arXiv:2201.06660•Low Temperature Physics•Jan 26, 2022•2 citations

High-impedance spirals in superconducting devices

Mihirangi Medahinne, Machiel Blok

High-impedance quantum circuit elements consisting of large inductors with small self-capacitance, are important building blocks in quantum circuit elements, with many potential applications. We present thin-film niobium (Nb) spiral resonators exhibiting large geometric inductance, high critical magnetic fields, and high single-photon quality factors. These low-loss geometric inductors can be a compelling alternative to kinetic inductors to create high-impedance superconducting devices for applications that require magnetic fields. We measure the temperature and magnetic-field-dependent losses and find that the high-impedance resonators maintain an intrinsic quality factor above approximately 105 for parallel magnetic fields of up to 1 T. These properties make spiral Nb resonators a promising candidate for quantum devices that require circuit elements with high impedance and magnetic-field resilience. The quantum device we present, incorporating these spirals, is the inductively shunted transmon qudit. The transmon is a widely used superconducting qubit. We develop and optimize a fabrication procedure for transmons, and our primary qubit measurements indicate that we have successfully fabricated qubits. We develop and optimize a fabrication procedure for transmons with Al/AlOx/Al Josephson junctions. For the rest of the circuit, we start with Nb and then shift to Ta due to its superior material properties and the more feasible fabrication procedure it allows using our existing fabrication capabilities. Finally, we introduce the inductively shunted transmon, a transmon shunted by a linear inductor. We show numerically that it could provide highly coherent qudit operations. Then, we propose a simple design to shunt the previously introduced spirals to the transmons.

•Jan 1, 2025•0 citations

Intermodulation measurements in Nb superconducting microstrip resonators

R. Monaco, A. Andreone, F. Palomba

The issue of intermodulation distortion in superconducting devices for rf and microwave applications is discussed. The classical frequency conversion theory for nonlinear two-port devices in the small signal limit is shown to apply to microstrip resonators regardless of their geometry and material. Two tone, third order intermodulation measurements allow more sensitive detection of nonlinearity compared to surface impedance measurements, provided a low noise, spurious free experimental setup is adopted. Measurements carried out on high quality Nb meanderline microstrip resonators show that at very low power level nonlinearity is dominated by intrinsic device properties. Film defects start to play a predominant role above a critical power level that strongly depends on the defect’s nature.

Journal of Applied Physics•Sep 1, 2000•23 citations

Josephson soliton oscillators in a superconducting thin film resonator

J. Holm, J. Mygind, N. F. Pedersen +3 more

Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•1 citation
Superconducting thin film resonators employing strip geometries show great promise in rf/microwave applications due to their low loss and compact nature. However, their functionality is limited by nonlinear effects at elevated rf/microwave powers. Here, we show that by using a planar spiral geometry carrying parallel currents in adjacent turns, this limitation can be minimized. We investigate the rf current distributions in spiral resonators implemented with Nb thin films via laser scanning microscopy. The rf current density profile along the width of the individual turns of the resonators reveals an unconventional trend: maximum current in the middle of the structure and decaying toward its edges. This unusual behavior is associated with the circular nature of the geometry and the cancellation of magnetic field between the turns, which is favorable for handling high powers since it allows the linear characteristics to persist at high rf current densities.
We present thin-film niobium (Nb\mathrm{Nb}Nb) spiral resonators exhibiting large geometric inductance, high critical magnetic fields, and high single-photon quality factors. These low-loss geometric inductors can be a compelling alternative to kinetic inductors to create high-impedance superconducting devices for applications that require magnetic fields. By varying the spiral pitch, we realize resonators with characteristic impedances ranging from $3.25--7.09\phantom{\rule{0.2em}{0ex}}\mathrm{k}\mathrm{\ensuremath{\Omega}}$. We measure the temperature and magnetic-field-dependent losses and find that the high-impedance resonators maintain an intrinsic quality factor above approximately 105{10}^{5}105 for parallel magnetic fields of up to 1 T. These properties make spiral Nb\mathrm{Nb}Nb resonators a promising candidate for quantum devices that require circuit elements with high impedance and magnetic-field resilience.
A laser scanning microscope with a thermal spot size of about 4 μm is used to measure a quantity proportional to the rf current density in an operating superconducting coplanar waveguide microwave resonator. The twinning of the LaAlO3 substrate produces a meandering of the current at the edges due to irregularities in the wet etching of the YBa2Cu3O7−δ film associated with substrate twin domain blocks, and an (∼20%) enhancement of the rf photoresponse at these locations. These irregularities are candidates for enhanced nonlinear response from the device.
Superconducting microcircuits and metamaterials are promising candidates for use in new generation cryogenic electronics. Their functionality is largely justified by the macroscopic distribution of electromagnetic fields in arranged unit cells, rather than by the microscopic properties of composite materials. We present a new method for visualizing the spatial structure of penetrating microwaves with microscopic resolution in planar superconducting macroscopic resonators as the most important circuit-forming elements of modern microelectronics. This method uses a low-temperature laser scanning microscope that examines the phase (i.e., direction) and amplitude of local radio-frequency currents versus the two-dimensional coordinates of the superconducting resonant structure under test. Phase-sensitive contrast is achieved by synchronizing the intensity-modulated laser radiation with the resonant harmonics of the microwave signal passing through the sample. In this case, the laser-beam-induced loss in the illuminated area will strongly depend on the local phase difference between the RF carrier signal and the spatially temporal structure of the focused laser oscillation. This approach eliminates the hardware limitations of the existing technique of radio-frequency microscopy and brings the phase-sensitive demodulation mode to the level necessary for studying the physics of superconducting metamaterials. The advantage of the presented method over the previous method of RF laser scanning micros-copy is demonstrated by the example of the formation of standing waves in a spiral superconducting Archimedean resonator up to the 38th eigenmode resonance.
High-impedance quantum circuit elements consisting of large inductors with small self-capacitance, are important building blocks in quantum circuit elements, with many potential applications. We present thin-film niobium (Nb) spiral resonators exhibiting large geometric inductance, high critical magnetic fields, and high single-photon quality factors. These low-loss geometric inductors can be a compelling alternative to kinetic inductors to create high-impedance superconducting devices for applications that require magnetic fields. We measure the temperature and magnetic-field-dependent losses and find that the high-impedance resonators maintain an intrinsic quality factor above approximately 105 for parallel magnetic fields of up to 1 T. These properties make spiral Nb resonators a promising candidate for quantum devices that require circuit elements with high impedance and magnetic-field resilience. The quantum device we present, incorporating these spirals, is the inductively shunted transmon qudit. The transmon is a widely used superconducting qubit. We develop and optimize a fabrication procedure for transmons, and our primary qubit measurements indicate that we have successfully fabricated qubits. We develop and optimize a fabrication procedure for transmons with Al/AlOx/Al Josephson junctions. For the rest of the circuit, we start with Nb and then shift to Ta due to its superior material properties and the more feasible fabrication procedure it allows using our existing fabrication capabilities. Finally, we introduce the inductively shunted transmon, a transmon shunted by a linear inductor. We show numerically that it could provide highly coherent qudit operations. Then, we propose a simple design to shunt the previously introduced spirals to the transmons.
The issue of intermodulation distortion in superconducting devices for rf and microwave applications is discussed. The classical frequency conversion theory for nonlinear two-port devices in the small signal limit is shown to apply to microstrip resonators regardless of their geometry and material. Two tone, third order intermodulation measurements allow more sensitive detection of nonlinearity compared to surface impedance measurements, provided a low noise, spurious free experimental setup is adopted. Measurements carried out on high quality Nb meanderline microstrip resonators show that at very low power level nonlinearity is dominated by intrinsic device properties. Film defects start to play a predominant role above a critical power level that strongly depends on the defect’s nature.
Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>