We study photonic heat conduction between two resistors coupled weakly to a single superconducting microwave cavity. At low enough temperature, the dominant part of the heat exchanged between the resistors is transmitted by single-photon excitations of the fundamental mode of the cavity. This manifestation of single-photon heat conduction should be experimentally observable with the current state of the art. Our scheme can possibly be utilized in remote interference-free temperature control of electric components and environment engineering for superconducting quantum bits coupled to cavities.
We study photonic heat conduction between two resistors coupled weakly to a single superconducting microwave cavity. At low enough temperature, the dominant part of the heat exchanged between the resistors is transmitted by single-photon excitations of the fundamental mode of the cavity. This manifestation of single-photon heat conduction should be experimentally observable with the current state of the art. Our scheme can possibly be utilized in remote interference-free temperature control of electric components and environment engineering for superconducting quantum bits coupled to cavities.
We build on the study of single-photon heat conduction in electronic circuits taking into account the back-action of the superconductor--insulator--normal-metal thermometers. In addition, we show that placing capacitors, resistors, and superconducting quantum interference devices (SQUIDs) into a microwave cavity can severely distort the spatial current profile which, in general, should be accounted for in circuit design. The introduction of SQUIDs also allows for in situ tuning of the photonic power transfer which could be utilized in experiments on superconducting quantum bits.
We report our recent work on developing artificial electromagnetic environments for superconducting devices. Previously, we have showed that single-photon heat conduction between two resistors embedded in a superconducting cavity can be achieved [1]. Here, we modify this setup to provide in-situ control of the photonic heat power [2] and open up the possibility to tune the coupling strength between the artificial environment and the desired component in the cavity by several orders of magnitude. Our results provide an efficient pathway to control the lifetime of a superconducting quantum bit, qubit, allowing for rapid initialization to the ground state at will and unhindered normal operation as desired [3].
Superconducting quantum bits are one of the leading frontrunners in the race to build a solid-state quantum computer. In circuit quantum electrodynamics (cQED), electronic quantum circuits, playing the role of quantum bits, qubits, are placed into superconducting cavities with incredibly weak dissipation. The resulting system exhibits both photon and qubit characteristics, and it is possible to perform complex operations by driving the system with microwaves. Progress has been rapid, with vast improvements in cavities, qubits, and in controlling the interaction between the two. As a result, the first simple quantum algorithms to utilize this architecture have recently been implemented. \nAt the same time, there have been significant developments in improving our understanding of the heat flow in nanoelectronics. In particular the development of tunnel junctions has reached such a level, that it is now possible to control and measure the temperature of small metal islands with high precision. Such techniques have enabled the first observations of quantum-limited heat conduction through the photonic modes of a circuit. \nThis thesis introduces some of the benefits that come with the unification of these two fields. Theoretical models for experiments in a superconducting cavity are presented, with heat conduction due to individual cavity photons discussed in detail, along with a novel method to vary the lifetime of a qubit over many orders of magnitude. The realisation of these experiments would be the first steps on the road to integrating normal-metal components with cQED.
We report an experimental realization of a three-terminal photonic heat transport device based on a superconducting quantum circuit. The central element of the device is a flux qubit made of a superconducting loop containing three Josephson junctions, which can be tuned by magnetic flux. It is connected to three resonators terminated by resistors. By heating one of the resistors and monitoring the temperatures of the other two, we determine photonic heat currents in the system and demonstrate their tunability by magnetic field at the level of 1 aW. We determine system parameters by performing microwave transmission measurements on a separate nominally identical sample and, in this way, demonstrate clear correlation between the level splitting of the qubit and the heat currents flowing through it. Our experiment is an important step towards realization of heat transistors, heat amplifiers, masers pumped by heat and other quantum heat transport devices.
Superconducting microwave circuits are a ubiquitous and important tool for devices that exploit the phenomena of superconductivity and cryogenic temperatures as an environment for achieving the generation, manipulation, and detection of quantum states - required for the ongoing development of quantum technologies. In particular, superconducting circuits are a promising platform for the universal quantum computer, which will require an unprecedented density of quantum-coherent elements to perform large-scale quantum-enhanced calculations and simulations, using the framework of cavity quantum lectrodynamics.Dissipation and heat in these superconducting circuits is a key source of error and inefficiency, however the thermodynamics in this regime is poorly understood despite its increasing relevancy.This thesis describes the integration of superconducting resonators and artificial atoms derived from superconducting quantum circuits with ultra-sensitive bolometry, for looking at heat transport through superconducting circuits. We will describe the physics and operation of each of these elements, before combining and utilising them to perform heat transport measurements through a superconducting artificial atom coupled to two resonators, each terminated by a normal-metal mesoscopic resistor, with the resistor temperature measured and temperature gradients across the circuit induced by superconducting tunnel-probes. We will present tunable heat transport through this system, firstly when the resonators are symmetric, allowing us to observe the role of dissipation-limited coupling of the resonators to the artificial atom on the locality of the heat transport, then on an asymmetric system, demonstrating a directional rectification of the heat transport. Additionally, we will discuss how each element of the system can be individually characterised, in particular the quality factor of superconducting resonators in the highly-dissipative limit, by exploiting the superconducting transition to perform a background reference. It is suggested that this hybrid quantum system, and these initial experiments provide a promising platform in the emergent field of circuit quantum thermodynamics. We believe that the techniques and tools developed during this thesis present key steps towards the understanding of the thermodynamics of quantum circuits, towards the realisation of devices that can explore heat transport in the quantum limit, such as a quantum heat engine.
Atoms and photons, two things so different but yet so alike. The former, the building block of matter, something we learn about in school and imagine it as some tiny marbles encircled by other tinier marbles. The latter, an electromagnetic wave, a light particle or an excitation of the electromagnetic field. Quantum mechanics tells us about the properties of these two entities. And even if it sounds, looks and writes counter-intuitive, it has proven right for over a century now. In this work, I elaborate on how we tested the laws of quantum mechanics and how we used them learn more about the tiny building blocks of nature and the fields they use to talk to each other. The atoms we use, are artificial. Superconducting qubits, small electrical circuits with quantized energy levels behave like electrons that transition between different orbitals in an atom. One of the qubits' advantages, is also a big disadvantage. We design the circuits' energy levels and fabricate them in a cleanroom. This allows for arbitrary spaced energy levels but in contrast to real atoms, prevents two superconducting qubits from being alike. Still, this qubit platform is one of the frontrunners for future quantum computing technology and testing fundamental physics due to their scalability. We interface superconducting qubits, which operate in the GHz regime, with microwave photons. We use 3D aluminum cavities as mediators between qubits and photons. The cavities allow for non-destructive readout of the qubit state, they shield the qubits from noise at the qubit frequency and they give us an easy way to frequency-tune these joint systems. We need to operate superconducting qubits and their cavities at millikelvin temperatures in dilution refrigerators. At higher temperatures, superconductivity suffers and even worse, the environment is filled with thermal noise photons. This poses a fundamental limitation on the scalability of superconducting qubit devices. Also connecting multiple devices in different fridges does not work over room temperature links because the microwave photons used for this purpose will be covered in noise and the quantum information they carry, will be unusable. Infrared photons do not suffer from this noise problem since there are close to zero thermal noise photons at their frequencies at room temperature. We cannot simply interface superconducting devices with optical photons due their frequency mismatch and the destructive effect of optical photons on superconductors. Therefore, we use microwave-to-optics transducers that allow to convert microwave photons into optical ones and vice-versa. The transducers that we use are macroscopic electro-optic transducers using the Pockels effect in a disk-shaped Lithium Niobate whispering gallery mode resonator. By using a strong optical pump, photons from the two frequency domains experience a beam-splitter interaction and get converted from one to the other. We measure the generated optical photons using elaborate optical setups, optical heterodyning and single photon detectors to gain knowledge about the qubit state or the converted microwave photons. Bridging the microwave and the optical world allows us to take advantage of both of their strengths but it also requires deep knowledge about both of their working principles. In this work, we describe two experiments that our group conducted to showcase the opportunities that arise from interfacing superconducting qubits with optical photons but also the pitfalls, one may encounter on the way. In the first experiment, we managed to all-optically read out a superconducting qubit. We show that the assignment fidelity, the probability that a measurement of the qubit state matches the prepared state, is close to equal for all-optical, microwave-to-optics and conventional microwave readout. We show T1 and T2 measurements for all three readout types and give an analysis of the noise caused by the optics. Finally, we show that the infrared light does not affect the qubit performance in a negative way but that the heating it causes does. This is an important insight that we used in the next experiment. The second experiment is the upconversion of itinerant single microwave photons to the optical domain. We show that we can generate single microwave photons from a qubit-cavity system. We upconvert these single photons, measure them with a single photon detector and reconstruct their shape. By conducting a single photon Rabi measurement, we show correlations between the microwave and the optical domain. And by thorough signal-to-noise measurements and noise analysis, we find that we can generate single infrared photons with high signal-to-noise ratio 5.1 and low transducer added noise (<0.012 quanta). We show that this measurement creates a path towards entanglement of a superconducting qubit and an optical photon and what parameters need to be improved to achieve it. Additionally, this experiment is a proof of principle for an on-demand infrared single photon source. More generally, it allows to link microwave quantum technology in general to the optical domain.