Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1010.6302 · Physical Review A

Preservation of loss in linear-optical processing

Dominic William Berry, Alexander I. Lvovsky

Published Oct 4, 2011• 7 citations
arXivHTMLPDF

Abstract

We propose a measure of quantum efficiency of a multimode state of light that quantifies the amount of optical loss this state has experienced, and prove that this efficiency cannot increase in any linear-optical processing with destructive conditional measurements. Any loss that has affected a state can neither be removed nor redistributed so as to further increase the efficiency in higher-efficiency modes at the expense of lower-efficiency modes. This result eliminates the possibility of catalytically improving photon sources.

DOI
10.1103/physreva.84.042304

Related papers

Efficiencies of quantum optical detectors

D. Hogg, Dominic William Berry, Alexander I. Lvovsky

We propose a definition for the efficiency that can be universally applied to all classes of quantum optical detectors. This definition is based on the maximum amount of optical loss that a physically plausible device can experience while still replicating the properties of a given detector. We prove that detector efficiency cannot be increased using linear optical processing. That is, given a set of detectors, as well as arbitrary linear optical elements and ancillary light sources, it is impossible to construct detection devices that would exhibit higher efficiencies than the initial set.

arXiv:1408.0257•Physical Review A•Nov 25, 2014•9 citations

Efficiency limits for linear optical processing of single photons and single-rail qubits

Dominic William Berry, Alexander I. Lvovsky, Barry C. Sanders

We analyze the problem of increasing the efficiency of single-photon sources or single-rail photonic qubits via linear optical processing and destructive conditional measurements. We allow for the use of coherent states and do not limit to photon-counting measurements. We conjecture that, with the limitation that multiphoton components in the output are not permitted, it is not possible to increase the efficiency. We prove this conjecture for several important special cases, and provide extensive numerical results for the general case.

arXiv:quant-ph/0605043•Journal of the Optical Society of America B•Jan 26, 2007•5 citations

Linear-Optical Processing Cannot Increase Photon Efficiency

Dominic William Berry, Alexander I. Lvovsky

We answer the question whether linear-optical processing of the states produced by one or multiple imperfect single-photon sources can improve the single-photon fidelity. This processing can include arbitrary interferometers, coherent states, feedforward, and conditioning on results of detections. We show that without introducing multiphoton components, the single-photon fraction in any of the single-mode states resulting from such processing cannot be made to exceed the efficiency of the best available photon source. If multiphoton components are allowed, the single-photon fidelity cannot be increased beyond 1/2. We propose a natural general definition of the quantum-optical state efficiency, and show that it cannot increase under linear-optical processing.

arXiv:1004.2245•Physical Review Letters•Nov 12, 2010•20 citations

On quantum efficiencies of optical states

Dominic William Berry, Alexander I. Lvovsky

We propose a universal measure of efficiency associated with a quantum-optical state and show that this efficiency cannot be improved by any linear-optical processing combined with destructive conditional measurements.

International Conference on Quantum Information•Jan 1, 2011•0 citations

Improving single-photon sources via linear optics and photodetection

Dominic William Berry, Stefan Scheel, Barry C. Sanders +1 more

Triggered single-photon sources produce the vacuum state with nonzero probability, but produce a much smaller multiphoton component. It is therefore reasonable to approximate the output of these photon sources as a mixture of the vacuum and single-photon states with probabilities $1\ensuremath{-}p$ and $p$, respectively. Here we are concerned with increasing the efficiency $p$ by directing multiple copies of the single-photon-vacuum mixture into a linear optical device and applying photodetection on some outputs. We prove that it is impossible, under certain conditions, to increase $p$ via linear optics and conditional preparation based on photodetection. We also establish a class of photodetection events for which $p$ can be improved, although with an added multiphoton component. In addition we prove that it is not possible to obtain perfect single-photon states via this method from imperfect $(p<1)$ inputs.

arXiv:quant-ph/0309140•Physical Review A•Mar 1, 2004•20 citations

Experimental study of retrieval efficiency of Duan-Lukin-Cirac-Zoller quantum memory by optical cavity-enhanced

Teng-Fei Ma, Minjie Wang, Shengzhi Wang +5 more

Long-distance entanglement distribution is an important task for quantum communication, but difficult to achieve due to the loss of photons in optical fiber transmission. Quantum repeater is a scheme to solve this problem. In this scheme, the long distance of entanglement distribution is divided into several small parts, the entanglement is established first at both ends of each part, then, the entanglement distance is extended through the entanglement exchange of adjacent interval parts, in order to achieve the long distance entanglement distribution. Of them, the Duan-Lukin-Cirac-Zoller (DLCZ) protocol based on the cold atom ensemble and the linear optics which can generate and store entanglement, is regarded as one of the most potential schemes. In the process of DLCZ, retrieval efficiency is an important index of the quantum repeater, because it will influence each entanglement exchange operation between adjacent quantum repeater nodes. Generally, the retrieval efficiency is improved by optimizing the reading pulse, increasing the optical depth (OD) of the atomic ensemble and the cavity enhancement. The ring cavity constrains the light field to increase the intensity of the interaction between light and atoms, and effectively improve the retrieval efficiency of the quantum memory. In this work, atomic ensembles are placed in a ring cavity. The cavity length is 3.3 m and the fineness is 13.5. The optical loss of all ring cavity is 21%, mainly including 15% loss of other optical elements and 6% loss of the cell. In order to increase the retrieval efficiency, we need to ensure the mode resonance of read-out photon, write-out photon and locking. The cavity needs two input beams of light: one comes from the path of read-out photon and the other from the path of write-out photon in the reverse direction. The two beams are locked at the same frequency as the write-out photon and the read-out photon respectively. The cavity length is adjusted by moving the cavity mirrors’ positions through translating the frame, to make two light modes resonate. The acousto-optic modulator (AOM) is inserted into the path of the locking to control the frequency of the locking. By adjusting the AOM to change the frequency of the locking, the locking can be coincident with the write-out and read-out cavity modes. Then, the three-mode resonance can be achieved When the cavity mode resonates with the atomic line, it will lead the atomic formants to split. thereby affecting the enhancement effect of retrieval efficiency. In the experiment, the detuning of the read light will affect the frequency of the read-out photon, and further affect the detuning of the cavity mode with the resonance line of the atom. Thus, by increasing the detuning between the reading light and the atomic transition line, the frequency splitting between the two modes can be reduced, then enhance the retrieval efficiency. We study the relation between the enhancement factor of the retrieval efficiency and the detuning amount of the reading light relative to the atomic resonance line. The results show that when the detuning amount of reading light is 80 MHz, the intrinsic readout efficiency is 45%, and the readout efficiency is enhanced by 1.68 times.

Acta Physica Sinica•Jan 1, 2022•1 citation
We propose a measure of quantum efficiency of a multimode state of light that quantifies the amount of optical loss this state has experienced, and prove that this efficiency cannot increase in any linear-optical processing with destructive conditional measurements. Any loss that has affected a state can neither be removed nor redistributed so as to further increase the efficiency in higher-efficiency modes at the expense of lower-efficiency modes. This result eliminates the possibility of catalytically improving photon sources.
We propose a definition for the efficiency that can be universally applied to all classes of quantum optical detectors. This definition is based on the maximum amount of optical loss that a physically plausible device can experience while still replicating the properties of a given detector. We prove that detector efficiency cannot be increased using linear optical processing. That is, given a set of detectors, as well as arbitrary linear optical elements and ancillary light sources, it is impossible to construct detection devices that would exhibit higher efficiencies than the initial set.
We analyze the problem of increasing the efficiency of single-photon sources or single-rail photonic qubits via linear optical processing and destructive conditional measurements. We allow for the use of coherent states and do not limit to photon-counting measurements. We conjecture that, with the limitation that multiphoton components in the output are not permitted, it is not possible to increase the efficiency. We prove this conjecture for several important special cases, and provide extensive numerical results for the general case.
We answer the question whether linear-optical processing of the states produced by one or multiple imperfect single-photon sources can improve the single-photon fidelity. This processing can include arbitrary interferometers, coherent states, feedforward, and conditioning on results of detections. We show that without introducing multiphoton components, the single-photon fraction in any of the single-mode states resulting from such processing cannot be made to exceed the efficiency of the best available photon source. If multiphoton components are allowed, the single-photon fidelity cannot be increased beyond 1/2. We propose a natural general definition of the quantum-optical state efficiency, and show that it cannot increase under linear-optical processing.
Triggered single-photon sources produce the vacuum state with nonzero probability, but produce a much smaller multiphoton component. It is therefore reasonable to approximate the output of these photon sources as a mixture of the vacuum and single-photon states with probabilities $1\ensuremath{-}p$ and ppp, respectively. Here we are concerned with increasing the efficiency ppp by directing multiple copies of the single-photon-vacuum mixture into a linear optical device and applying photodetection on some outputs. We prove that it is impossible, under certain conditions, to increase ppp via linear optics and conditional preparation based on photodetection. We also establish a class of photodetection events for which ppp can be improved, although with an added multiphoton component. In addition we prove that it is not possible to obtain perfect single-photon states via this method from imperfect (p<1)(p<1)(p<1) inputs.
Long-distance entanglement distribution is an important task for quantum communication, but difficult to achieve due to the loss of photons in optical fiber transmission. Quantum repeater is a scheme to solve this problem. In this scheme, the long distance of entanglement distribution is divided into several small parts, the entanglement is established first at both ends of each part, then, the entanglement distance is extended through the entanglement exchange of adjacent interval parts, in order to achieve the long distance entanglement distribution. Of them, the Duan-Lukin-Cirac-Zoller (DLCZ) protocol based on the cold atom ensemble and the linear optics which can generate and store entanglement, is regarded as one of the most potential schemes. In the process of DLCZ, retrieval efficiency is an important index of the quantum repeater, because it will influence each entanglement exchange operation between adjacent quantum repeater nodes. Generally, the retrieval efficiency is improved by optimizing the reading pulse, increasing the optical depth (OD) of the atomic ensemble and the cavity enhancement. The ring cavity constrains the light field to increase the intensity of the interaction between light and atoms, and effectively improve the retrieval efficiency of the quantum memory. In this work, atomic ensembles are placed in a ring cavity. The cavity length is 3.3 m and the fineness is 13.5. The optical loss of all ring cavity is 21%, mainly including 15% loss of other optical elements and 6% loss of the cell. In order to increase the retrieval efficiency, we need to ensure the mode resonance of read-out photon, write-out photon and locking. The cavity needs two input beams of light: one comes from the path of read-out photon and the other from the path of write-out photon in the reverse direction. The two beams are locked at the same frequency as the write-out photon and the read-out photon respectively. The cavity length is adjusted by moving the cavity mirrors’ positions through translating the frame, to make two light modes resonate. The acousto-optic modulator (AOM) is inserted into the path of the locking to control the frequency of the locking. By adjusting the AOM to change the frequency of the locking, the locking can be coincident with the write-out and read-out cavity modes. Then, the three-mode resonance can be achieved When the cavity mode resonates with the atomic line, it will lead the atomic formants to split. thereby affecting the enhancement effect of retrieval efficiency. In the experiment, the detuning of the read light will affect the frequency of the read-out photon, and further affect the detuning of the cavity mode with the resonance line of the atom. Thus, by increasing the detuning between the reading light and the atomic transition line, the frequency splitting between the two modes can be reduced, then enhance the retrieval efficiency. We study the relation between the enhancement factor of the retrieval efficiency and the detuning amount of the reading light relative to the atomic resonance line. The results show that when the detuning amount of reading light is 80 MHz, the intrinsic readout efficiency is 45%, and the readout efficiency is enhanced by 1.68 times.