Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1004.4020 · IEEE Transactions on Communications

Analysis and Design of Binary Message Passing Decoders

Gottfried Lechner, Troels Pedersen, Gerhard G. Kramer

Published Dec 29, 2011• 50 citations
arXivHTMLPDF

Abstract

Binary message passing decoders for low-density parity-check codes are studied by using extrinsic information transfer charts. The channel delivers hard or soft decisions and the variable node decoder performs all computations in the log-likelihood ratio (L-value) domain. A hard decision results in the Gallager B algorithm and examples show that increasing the channel output alphabet to two bits gains more than 1.0 dB in signal to noise ratio when using optimized codes. Finally, it is shown that errors on cycles consisting only of degree two and three variable nodes cannot be corrected and a necessary and sufficient condition for the existence of a cycle-free subgraph is derived.

DOI
10.1109/tcomm.2011.122111.100212

Related papers

EXIT Chart Analysis of Binary Message-Passing Decoders

Gottfried Lechner, Troels Pedersen, Gerhard G. Kramer

Binary message-passing decoders for LDPC codes are analyzed using EXIT charts. For the analysis, the variable node decoder performs all computations in the L-value domain. For the special case of a hard decision channel, this leads to the well-know Gallager B algorithm, while the analysis can be extended to channels with larger output alphabets. By increasing the output alphabet from hard decisions to four symbols, a gain of more than 1.0 dB is achieved using optimized codes. For this code optimization, the mixing property of EXIT functions has to be modified to the case of binary message-passing decoders.

IEEE International Symposium on Information Theory (ISIT)•Jun 1, 2007•8 citations

The effect of cycles on binary message-passing decoding of LDPC codes

Gottfried Lechner

We study the error-floor behavior of binary message-passing decoders for low-density parity-check (LDPC) codes. We find that the stability condition is independent of the quality of the channel messages (i.e. soft or hard decision). Furthermore, we identify a structure in the graph where the involved variable nodes cannot be corrected by the binary message-passing decoder. This leads to an error floor for regular LDPC codes with variable node degree smaller than four. An additional constraint on the degree distribution is derived which allows to avoid this structure, leading to optimized LDPC codes without error floors.

Australian Communications Theory Workshop•Feb 1, 2010•5 citations

A differential binary message-passing LDPC decoder

Nastaran Mobini, A.H. Banihashemi, Saied Hemati

In this paper, we propose a binary message-passing algorithm for decoding low-density parity-check (LDPC) codes. The algorithm substantially improves the performance of purely hard-decision iterative algorithms with a small increase in the memory requirements and the computational complexity. We associate a reliability value to each nonzero element of the code's parity-check matrix, and differentially modify this value in each iteration based on the sum of the extrinsic binary messages from the check nodes. For the tested random and finitegeometry LDPC codes, the proposed algorithm can perform as close as about 1 dB and 0.5 dB to belief propagation (BP) at the error rates of interest, respectively. This is while, unlike BP, the algorithm does not require the estimation of channel signal to noise ratio. Low memory and computational requirements and binary message-passing make the proposed algorithm attractive for high-speed low-power applications.

IEEE Transactions on Communications•Sep 1, 2009•32 citations

A Differential Binary Message-Passing LDPC Decoder

Nastaran Mobini, Amir H. Banihashemi, Saied Hemati

In this paper, we propose a binary message-passing algorithm for decoding low-density parity-check (LDPC) codes. The algorithm substantially improves the performance of purely hard-decision iterative algorithms with a small increase in the memory requirements and the computational complexity. We associate a reliability value to each nonzero element of the code's parity-check matrix, and differentially modify this value in each iteration based on the sum of the extrinsic binary messages from the check nodes. For the tested random and finite-geometry LDPC codes, the proposed algorithm can achieve performance as close as 1.3 dB and 0.7 dB to that of belief propagation (BP) at the error rates of interest, respectively. This is while, unlike BP, the algorithm does not require the estimation of channel signal to noise ratio. Low memory and computational requirements and binary message-passing make the proposed algorithm attractive for high-speed low-power applications.

Globecom•Nov 1, 2007•16 citations

Properties of Optimum Binary Message-Passing Decoders

Masoud Ardakani, Frank R. Kschischang

We consider a class of message-passing decoders for low-density parity-check (LDPC) codes whose messages are binary valued. We prove that if the channel is symmetric and all codewords are equally likely to be transmitted, an optimum decoding rule (in the sense of minimizing message error rate) should satisfy certain symmetry and isotropy conditions. Using this result, we prove that Gallager's Algorithm B achieves the optimum decoding threshold among all binary message-passing decoding algorithms for regular codes. For irregular codes, we argue that when the nodes of the message-passing decoder do not exploit knowledge of their decoding neighborhood, optimality of Gallager's Algorithm B is preserved. We also consider the problem of designing irregular LDPC codes and find a bound on the achievable rates with Gallager's Algorithm B. Using this bound, we study the case of low error-rate channels and analytically find good degree distributions for them.

IEEE Transactions on Information Theory•Sep 26, 2005•14 citations

Efficient Analysis, Design and Decoding of Low-Density Parity-Check Codes

Masoud Ardakani

This dissertation presents new methods for the analysis, design and decoding of low-density parity-check (LDPC) codes. We start by studying the simplest class of decoders: the binary message-passing (BMP) decoders. We show that the optimum BMP decoder must satisfy certain symmetry and isotropy conditions, and prove that Gallager's Algorithm B is the optimum BMP algorithm. We use a generalization of extrinsic information transfer (EXIT) charts to formulate a linear program that leads to the design of highly efficient irregular LDPC codes for the BMP decoder. We extend this approach to the design of irregular LDPC codes for the additive white Gaussian noise channel. We introduce a "semi-Gaussian" approximation that very accurately predicts the behaviour of the decoder and permits code design over a wider range of rates and code parameters than in previous approaches. We then study the EXIT chart properties of the highest rate LDPC code which guarantees a certain convergence behaviour. We also introduce and analyze gear-shift decoding in which the decoder is permitted to select the decoding rule from among a predefined set. We show that this flexibility can give rise to significant reductions in decoding complexity. Finally, we show that binary LDPC codes can be combined with quadrature amplitude modulation to achieve near-capacity performance in a multitone system over frequency selective Gaussian channels.

•Jan 1, 2004•14 citations
Binary message passing decoders for low-density parity-check codes are studied by using extrinsic information transfer charts. The channel delivers hard or soft decisions and the variable node decoder performs all computations in the log-likelihood ratio (L-value) domain. A hard decision results in the Gallager B algorithm and examples show that increasing the channel output alphabet to two bits gains more than 1.0 dB in signal to noise ratio when using optimized codes. Finally, it is shown that errors on cycles consisting only of degree two and three variable nodes cannot be corrected and a necessary and sufficient condition for the existence of a cycle-free subgraph is derived.
Binary message-passing decoders for LDPC codes are analyzed using EXIT charts. For the analysis, the variable node decoder performs all computations in the L-value domain. For the special case of a hard decision channel, this leads to the well-know Gallager B algorithm, while the analysis can be extended to channels with larger output alphabets. By increasing the output alphabet from hard decisions to four symbols, a gain of more than 1.0 dB is achieved using optimized codes. For this code optimization, the mixing property of EXIT functions has to be modified to the case of binary message-passing decoders.
We study the error-floor behavior of binary message-passing decoders for low-density parity-check (LDPC) codes. We find that the stability condition is independent of the quality of the channel messages (i.e. soft or hard decision). Furthermore, we identify a structure in the graph where the involved variable nodes cannot be corrected by the binary message-passing decoder. This leads to an error floor for regular LDPC codes with variable node degree smaller than four. An additional constraint on the degree distribution is derived which allows to avoid this structure, leading to optimized LDPC codes without error floors.
In this paper, we propose a binary message-passing algorithm for decoding low-density parity-check (LDPC) codes. The algorithm substantially improves the performance of purely hard-decision iterative algorithms with a small increase in the memory requirements and the computational complexity. We associate a reliability value to each nonzero element of the code's parity-check matrix, and differentially modify this value in each iteration based on the sum of the extrinsic binary messages from the check nodes. For the tested random and finitegeometry LDPC codes, the proposed algorithm can perform as close as about 1 dB and 0.5 dB to belief propagation (BP) at the error rates of interest, respectively. This is while, unlike BP, the algorithm does not require the estimation of channel signal to noise ratio. Low memory and computational requirements and binary message-passing make the proposed algorithm attractive for high-speed low-power applications.
In this paper, we propose a binary message-passing algorithm for decoding low-density parity-check (LDPC) codes. The algorithm substantially improves the performance of purely hard-decision iterative algorithms with a small increase in the memory requirements and the computational complexity. We associate a reliability value to each nonzero element of the code's parity-check matrix, and differentially modify this value in each iteration based on the sum of the extrinsic binary messages from the check nodes. For the tested random and finite-geometry LDPC codes, the proposed algorithm can achieve performance as close as 1.3 dB and 0.7 dB to that of belief propagation (BP) at the error rates of interest, respectively. This is while, unlike BP, the algorithm does not require the estimation of channel signal to noise ratio. Low memory and computational requirements and binary message-passing make the proposed algorithm attractive for high-speed low-power applications.
We consider a class of message-passing decoders for low-density parity-check (LDPC) codes whose messages are binary valued. We prove that if the channel is symmetric and all codewords are equally likely to be transmitted, an optimum decoding rule (in the sense of minimizing message error rate) should satisfy certain symmetry and isotropy conditions. Using this result, we prove that Gallager's Algorithm B achieves the optimum decoding threshold among all binary message-passing decoding algorithms for regular codes. For irregular codes, we argue that when the nodes of the message-passing decoder do not exploit knowledge of their decoding neighborhood, optimality of Gallager's Algorithm B is preserved. We also consider the problem of designing irregular LDPC codes and find a bound on the achievable rates with Gallager's Algorithm B. Using this bound, we study the case of low error-rate channels and analytically find good degree distributions for them.
This dissertation presents new methods for the analysis, design and decoding of low-density parity-check (LDPC) codes. We start by studying the simplest class of decoders: the binary message-passing (BMP) decoders. We show that the optimum BMP decoder must satisfy certain symmetry and isotropy conditions, and prove that Gallager's Algorithm B is the optimum BMP algorithm. We use a generalization of extrinsic information transfer (EXIT) charts to formulate a linear program that leads to the design of highly efficient irregular LDPC codes for the BMP decoder. We extend this approach to the design of irregular LDPC codes for the additive white Gaussian noise channel. We introduce a "semi-Gaussian" approximation that very accurately predicts the behaviour of the decoder and permits code design over a wider range of rates and code parameters than in previous approaches. We then study the EXIT chart properties of the highest rate LDPC code which guarantees a certain convergence behaviour. We also introduce and analyze gear-shift decoding in which the decoder is permitted to select the decoding rule from among a predefined set. We show that this flexibility can give rise to significant reductions in decoding complexity. Finally, we show that binary LDPC codes can be combined with quadrature amplitude modulation to achieve near-capacity performance in a multitone system over frequency selective Gaussian channels.