Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0912.1990 · Physical Review B

Ground-state cooling of a nanomechanical resonator coupled to two interacting flux qubits

Keyu Xia, Jörg Evers

Published Nov 23, 2010• 15 citations
arXivHTMLPDF

Abstract

We discuss cooling of a nanomechanical resonator to its mechanical ground state by coupling it to a collective system of two interacting flux qubits. We find that the collectivity crucially improves cooling by two mechanisms. First, cooling transitions proceed via subradiant Dicke states, and the reduced linewidth of these subradiant states suppresses both the scattering and the environmental contribution to the final phonon number. Second, detrimental carrier excitations without change in the motion of the resonator are suppressed by collective energy shifts.

DOI
10.1103/physrevb.82.184532

Related papers

Ground State Cooling of a Nanomechanical Resonator in the Nonresolved Regime via Quantum Interference

Keyu Xia, Jörg Evers

Ground state cooling of a nanomechanical resonator coupled to a superconducting flux qubit is discussed. By inducing quantum interference to cancel unwanted heating excitations, ground state cooling becomes possible in the nonresolved regime. The qubit is modeled as a three-level system in Lambda configuration, and the driving fluxes are applied such that the qubit absorption spectrum exhibits electromagnetically induced transparency, thereby canceling the unwanted excitations. As our scheme allows the application of strong cooling fields, fast and efficient cooling can be achieved.

arXiv:0902.3939•Physical Review Letters•Nov 25, 2009•66 citations

Ground-state cooling enabled by critical coupling and dark entangled states

Cristian L. Cortes, Matthew Otten, Stephen K. Gray

We analyze the cooling of a mechanical resonator coupled to an ensemble of interacting two-level systems via an open quantum systems approach. Using an exact analytical result, we find optimal cooling occurs when the phonon mode is critically coupled $(\ensuremath{\gamma}\ensuremath{\sim}g)$ to the two-level system ensemble. Typical systems operate in suboptimal cooling regimes due to the intrinsic parameter mismatch $(\ensuremath{\gamma}\ensuremath{\gg}g)$ between the dissipative decay rate $\ensuremath{\gamma}$ and the coupling factor $g$. To overcome this obstacle, we show that carefully engineering the coupling parameters through the strain profile of the mechanical resonator allows phonon cooling to proceed through the dark (subradiant) entangled states of an interacting ensemble, thereby resulting in optimal phonon cooling. Our results provide an avenue for ground-state cooling and should be accessible for experimental demonstrations.

arXiv:2001.01318•Physical review. B./Physical review. B•Jan 14, 2019•10 citations

Ground-state cooling of a nanomechanical resonator via a Cooper-pair box qubit

Konstanze Jaehne, Klemens Hammerer, Margareta Wallquist

In this paper, we present a scheme for ground-state cooling of a flexural mode of a nanomechanical beam incorporated in a loop-shaped Cooper-pair box (CPB) circuit. Via the Lorentz force coupling of the beam motion to circulating CPB-circuit currents, energy is transferred to the CPB qubit which acts as a dissipative two-level system. The cooling process is driven by a detuned gate voltage drive acting on the CPB. We analyze the cooling force spectrum and present analytical expressions for the cooling rate and final occupation number for a wide parameter regime. In particular, we find that cooling is optimized in a strong drive regime, and we present the necessary conditions for ground-state cooling.

arXiv:0804.0603•New Journal of Physics•Sep 1, 2008•56 citations

Cooling Mechanism for a Nanomechanical Resonator by Periodic Coupling to a Cooper Pair Box

Peng Zhang, Y. D. Wang, C. P. Sun

We propose and study an active cooling mechanism for the nanomechanical resonator (NAMR) based on periodical coupling to a Cooper pair box (CPB), which is implemented by a designed series of magnetic flux pluses threading through the CPB. When the initial phonon number of the NAMR is not too large, this cooling protocol is efficient in decreasing the phonon number by 2 to 3 orders of magnitude. Our proposal is theoretically universal in cooling various boson systems of a single mode. It can be specifically generalized to prepare the nonclassical state of the NAMR.

arXiv:quant-ph/0410149•Physical Review Letters•Aug 26, 2005•94 citations

Coupled Dynamics of a Nanomechanical Resonator and Superconducting Quantum Circuits

Junho Suh

The coupled dynamics of a nanomechanical resonator and superconducting quantum circuits are studied in three experiments, in the context of studying the quantum limit for force detection and quantum physics of macroscopic objects. In the first experiment, the dispersive mechanical resonance shift from the interaction with a Cooper-pair box qubit is studied. The measured coupling strength is large enough to satisfy one of the conditions required to perform many of the proposed quantum nanomechanical measurements. The resonance shift also probes the microwave-driven response of the qubit, showing Rabi oscillation and Landau-Zener tunneling, proving the coherent dynamics of the qubit. Second, the parametric excitation of nanomechanical motion is studied via experiments with a driven qubit. Degenerate parametric amplification and oscillation are demonstrated, with a new observation of nonlinear dissipation. The squeezing of the back-action noise from the detection amplifier is also observed, up to 4dB. It is the first demonstration using a qubit as an auxiliary system to modify the nanomechanical dynamics, showing a possible route for generation of nanomechanical quantum states. Finally, back-action cooling of nanomechanical motion has been investigated, which is implemented by capacitively coupling a high-Q coplanar waveguide microwave resonator to a nanomechanical resonator. The thermal state with 7.5 mechanical quanta on average is reached, a result that is ultimately limited due to increased bath heating with microwave power. The heating is consistent with a model based on two-level systems resonantly coupled to the nanomechanical mode. This additional heating suggests future efforts to improve coupling and for reducing two-level system density in materials employed to reach the motional ground state via back-action cooling.

•May 17, 2011•1 citation

Ground-state cooling of mechanical resonators

Ivar Martin, Alexander Shnirman, Lin Tian +1 more

We propose an application of a single Cooper pair box (Josephson qubit) for active cooling of nanomechanical resonators. Latest experiments with Josephson qubits demonstrated that long coherence time of the order of microsecond can be achieved in special symmetry points. Here we show that this level of coherence is sufficient to perform an analog of the well known in quantum optics ``laser'' cooling of a nanomechanical resonator capacitively coupled to the qubit. By applying an ac driving to the qubit or the resonator, resonators with frequency of order 100 MHz and quality factors higher than ${10}^{3}$ can be efficiently cooled down to their ground state, while lower-frequency resonators can be cooled down to micro-Kelvin temperatures. We also consider an alternative setup where dc-voltage-induced Josephson oscillations play the role of the ac driving and show that cooling is possible in this case as well.

arXiv:cond-mat/0310229•Physical Review B•Mar 30, 2004•184 citations
We discuss cooling of a nanomechanical resonator to its mechanical ground state by coupling it to a collective system of two interacting flux qubits. We find that the collectivity crucially improves cooling by two mechanisms. First, cooling transitions proceed via subradiant Dicke states, and the reduced linewidth of these subradiant states suppresses both the scattering and the environmental contribution to the final phonon number. Second, detrimental carrier excitations without change in the motion of the resonator are suppressed by collective energy shifts.
Ground state cooling of a nanomechanical resonator coupled to a superconducting flux qubit is discussed. By inducing quantum interference to cancel unwanted heating excitations, ground state cooling becomes possible in the nonresolved regime. The qubit is modeled as a three-level system in Lambda configuration, and the driving fluxes are applied such that the qubit absorption spectrum exhibits electromagnetically induced transparency, thereby canceling the unwanted excitations. As our scheme allows the application of strong cooling fields, fast and efficient cooling can be achieved.
We analyze the cooling of a mechanical resonator coupled to an ensemble of interacting two-level systems via an open quantum systems approach. Using an exact analytical result, we find optimal cooling occurs when the phonon mode is critically coupled $(\ensuremath{\gamma}\ensuremath{\sim}g)$ to the two-level system ensemble. Typical systems operate in suboptimal cooling regimes due to the intrinsic parameter mismatch $(\ensuremath{\gamma}\ensuremath{\gg}g)$ between the dissipative decay rate $\ensuremath{\gamma}$ and the coupling factor ggg. To overcome this obstacle, we show that carefully engineering the coupling parameters through the strain profile of the mechanical resonator allows phonon cooling to proceed through the dark (subradiant) entangled states of an interacting ensemble, thereby resulting in optimal phonon cooling. Our results provide an avenue for ground-state cooling and should be accessible for experimental demonstrations.
In this paper, we present a scheme for ground-state cooling of a flexural mode of a nanomechanical beam incorporated in a loop-shaped Cooper-pair box (CPB) circuit. Via the Lorentz force coupling of the beam motion to circulating CPB-circuit currents, energy is transferred to the CPB qubit which acts as a dissipative two-level system. The cooling process is driven by a detuned gate voltage drive acting on the CPB. We analyze the cooling force spectrum and present analytical expressions for the cooling rate and final occupation number for a wide parameter regime. In particular, we find that cooling is optimized in a strong drive regime, and we present the necessary conditions for ground-state cooling.
We propose and study an active cooling mechanism for the nanomechanical resonator (NAMR) based on periodical coupling to a Cooper pair box (CPB), which is implemented by a designed series of magnetic flux pluses threading through the CPB. When the initial phonon number of the NAMR is not too large, this cooling protocol is efficient in decreasing the phonon number by 2 to 3 orders of magnitude. Our proposal is theoretically universal in cooling various boson systems of a single mode. It can be specifically generalized to prepare the nonclassical state of the NAMR.
The coupled dynamics of a nanomechanical resonator and superconducting quantum circuits are studied in three experiments, in the context of studying the quantum limit for force detection and quantum physics of macroscopic objects. In the first experiment, the dispersive mechanical resonance shift from the interaction with a Cooper-pair box qubit is studied. The measured coupling strength is large enough to satisfy one of the conditions required to perform many of the proposed quantum nanomechanical measurements. The resonance shift also probes the microwave-driven response of the qubit, showing Rabi oscillation and Landau-Zener tunneling, proving the coherent dynamics of the qubit. Second, the parametric excitation of nanomechanical motion is studied via experiments with a driven qubit. Degenerate parametric amplification and oscillation are demonstrated, with a new observation of nonlinear dissipation. The squeezing of the back-action noise from the detection amplifier is also observed, up to 4dB. It is the first demonstration using a qubit as an auxiliary system to modify the nanomechanical dynamics, showing a possible route for generation of nanomechanical quantum states. Finally, back-action cooling of nanomechanical motion has been investigated, which is implemented by capacitively coupling a high-Q coplanar waveguide microwave resonator to a nanomechanical resonator. The thermal state with 7.5 mechanical quanta on average is reached, a result that is ultimately limited due to increased bath heating with microwave power. The heating is consistent with a model based on two-level systems resonantly coupled to the nanomechanical mode. This additional heating suggests future efforts to improve coupling and for reducing two-level system density in materials employed to reach the motional ground state via back-action cooling.
We propose an application of a single Cooper pair box (Josephson qubit) for active cooling of nanomechanical resonators. Latest experiments with Josephson qubits demonstrated that long coherence time of the order of microsecond can be achieved in special symmetry points. Here we show that this level of coherence is sufficient to perform an analog of the well known in quantum optics ``laser'' cooling of a nanomechanical resonator capacitively coupled to the qubit. By applying an ac driving to the qubit or the resonator, resonators with frequency of order 100 MHz and quality factors higher than 103{10}^{3}103 can be efficiently cooled down to their ground state, while lower-frequency resonators can be cooled down to micro-Kelvin temperatures. We also consider an alternative setup where dc-voltage-induced Josephson oscillations play the role of the ac driving and show that cooling is possible in this case as well.