Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0907.3904 · Physical Review Letters

Localization of Metal-Induced Gap States at the Metal-Insulator Interface: Origin of Flux Noise in SQUIDs and Superconducting Qubits

Sangkook Choi, D. H. Lee, Steven G. Louie, John L. Clarke

Published Nov 3, 2009• 101 citations
arXivHTMLPDF

Abstract

The origin of magnetic flux noise in superconducting quantum interference devices with a power spectrum scaling as 1/f (f is frequency) has been a puzzle for over 20 years. This noise limits the decoherence time of superconducting qubits. A consensus has emerged that the noise arises from fluctuating spins of localized electrons with an areal density of 5x10(17) m(-2). We show that, in the presence of potential disorder at the metal-insulator interface, some of the metal-induced gap states become localized and produce local moments. A modest level of disorder yields the observed areal density.

DOI
10.1103/physrevlett.103.197001

Related papers

Magnetic flux noise in superconducting qubits and the gap states continuum

Dominik Szczęśniak, Sabre Kais

In the present study we investigate the selected local aspects of the metal-induced gap states (MIGSs) at the disordered metal-insulator interface, that were previously proposed to produce magnetic moments responsible for the magnetic flux noise in some of the superconducting qubit modalities. Our analysis attempts to supplement the available studies and provide new theoretical contribution toward their validation. In particular, we explicitly discuss the behavior of the MIGSs in the momentum space as a function of the onsite energy deviation, that mimics random potential disorder at the interface in the local approximation. It is found, that when the difference between the characteristic electronic potentials in the insulator increases, the corresponding MIGSs become more localized. This effect is associated with the increasing degree of the potential disorder that was earlier observed to produce highly localized MIGSs in the superconducting qubits. At the same time, the presented findings show that the disorder-induced localization of the MIGSs can be related directly to the decay characteristics of these states as well as to the bulk electronic properties of the insulator. As a result, our study reinforces plausibility of the previous corresponding investigations on the origin of the flux noise, but also allows to draw future directions toward their better verification.

arXiv:2003.04885•Scientific Reports•Jan 19, 2021•6 citations

Noise in superconducting qubits and spin glasses

Clare C. Yu, Zhi Chen

Flux noise in superconducting quantum interference devices (SQUIDs) is produced by spins on the surface of metals. We have modeled these with Monte Carlo simulations of 2D and 3D Ising spin glasses that produce magnetization noise SMconsistent with flux noise. The frequency dependence of the magnetization noise goes as 1/fαwhere the exponent a varies slightly with temperature. In 3D the noise power spectrum in the order parameter q goes as 1/ f1.4at Tc. The low frequency noise in both q and the magnetization is a maximum at Tc.

International Conference on Noise and Fluctuations•Jun 1, 2013•0 citations

Model for 1 / f Flux Noise in SQUIDs and Qubits

R. H. Koch, David Peter Divincenzo, John L. Clarke

We propose a model for 1/f flux noise in superconducting devices (f is frequency). The noise is generated by the magnetic moments of electrons in defect states which they occupy for a wide distribution of times before escaping. A trapped electron occupies one of the two Kramers-degenerate ground states, between which the transition rate is negligible at low temperature. As a result, the magnetic moment orientation is locked. Simulations of the noise produced by randomly oriented defects with a density of 5x10(17) m(-2) yield 1/f noise magnitudes in good agreement with experiments.

arXiv:cond-mat/0702025•Physical Review Letters•Jun 27, 2007•211 citations

Possible Origin of Low-Frequency Magnetic Flux Noise in Superconducting Devices

Mengli Yao, Xiong Xu, Min Li +1 more

The magnetic flux noise caused by surface spin fluctuations in superconducting quantum interference devices (SQUIDs) limits their development. In this work, we report that different adsorbents such as H, O 2, NO, and NO 2 that adsorb on the surfaces of Mg-based and Pb-based SQUIDs, respectively, producing large local magnetic moments ranging from 0.7–1.6 μ B, with energy barriers for thermal spin fluctuation as low as 10–30 mK. Moreover, we observe that the presence of H atoms on the surface of MgO can cause the coadsorption of other molecules, which generates additional spin sources. Monte Carlo simulations of the weakly coupled spin on a two-dimensional square lattice produce a low-frequency flux noise spectrum. We suggest eliminating the surface magnetism by coating the surface with monolayer indium phosphide or protecting the surface from other molecules by nonmagnetic preoccupants with a larger adsorption energy. The work provides important physical insights and feasible strategies for reducing magnetic noise sources in superconducting circuits.

The Journal of Physical Chemistry Letters•Feb 13, 2023•3 citations

Flux Noise due to Spins in SQUIDs

S. LaForest

Superconducting Quantum Interference Devices (SQUIDs) are currently being used as flux qubits and read-out detectors in a variety of solid-state quantum computer architectures. The main limitation of SQUID qubits is that they have a coherence time of the order of 10 us, due to the presence of intrinsic flux noise that is not yet fully understood. The origin of flux noise is currently believed to be related to spin impurities present in the materials and interfaces that form the device. Here we present a novel numerical method that enables calculations of the flux produced by spin impurities even when they are located quite close to the SQUID wire. We show that the SQUID will be particularly sensitive to spins located at its wire edges, generating flux shifts of up to 4 nano flux quanta, much higher than previous calculations based on the software package FastHenry. This shows that spin impurities in a particular region along the wire's surface play a much more important role in producing flux noise than other spin impurities located elsewhere in the device.

•Jan 1, 2013•0 citations

Flux noise in superconducting circuits: Electron versus nuclear spins

S. LaForest, Rogério de Sousa

Superconducting Quantum Interference Devices (SQUIDs) and other superconducting circuits are limited by intrinsic flux noise with spectral density $1/f^{\alpha}$ with $\alpha<1$ whose origin is believed to be due to spin impurities. Here we present a theory of flux noise that takes into account the vectorial nature of the coupling of spins to superconducting wires. We present explicit numerical calculations of the flux noise power (spectral density integrated over all frequencies) for electron impurities and lattice nuclear spins under several different assumptions. The noise power is shown to be dominated by surface electron spins near the wire edges, with bulk lattice nuclear spins contributing $\sim 5$% of the noise power in aluminum and niobium wires. We consider the role of electron spin phase transitions, showing that the spin-spin correlation length (describing e.g. the average size of ferromagnetic spin clusters) greatly impacts the scaling of flux noise with wire geometry. Remarkably, flux noise power is exactly equal to zero when the spins are polarized along the flux vector direction, forming what we call a poloidal state. Flux noise is non-zero for other spin textures, but gets reduced in the presence of correlated ferromagnetic fluctuations between the top and bottom wire surfaces, where the flux vectors are antiparallel. This demonstrates that engineering spin textures and/or inter-surface correlation provides a method to reduce flux noise in superconducting devices.

•Jan 15, 2015•0 citations
The origin of magnetic flux noise in superconducting quantum interference devices with a power spectrum scaling as 1/f (f is frequency) has been a puzzle for over 20 years. This noise limits the decoherence time of superconducting qubits. A consensus has emerged that the noise arises from fluctuating spins of localized electrons with an areal density of 5x10(17) m(-2). We show that, in the presence of potential disorder at the metal-insulator interface, some of the metal-induced gap states become localized and produce local moments. A modest level of disorder yields the observed areal density.
In the present study we investigate the selected local aspects of the metal-induced gap states (MIGSs) at the disordered metal-insulator interface, that were previously proposed to produce magnetic moments responsible for the magnetic flux noise in some of the superconducting qubit modalities. Our analysis attempts to supplement the available studies and provide new theoretical contribution toward their validation. In particular, we explicitly discuss the behavior of the MIGSs in the momentum space as a function of the onsite energy deviation, that mimics random potential disorder at the interface in the local approximation. It is found, that when the difference between the characteristic electronic potentials in the insulator increases, the corresponding MIGSs become more localized. This effect is associated with the increasing degree of the potential disorder that was earlier observed to produce highly localized MIGSs in the superconducting qubits. At the same time, the presented findings show that the disorder-induced localization of the MIGSs can be related directly to the decay characteristics of these states as well as to the bulk electronic properties of the insulator. As a result, our study reinforces plausibility of the previous corresponding investigations on the origin of the flux noise, but also allows to draw future directions toward their better verification.
Flux noise in superconducting quantum interference devices (SQUIDs) is produced by spins on the surface of metals. We have modeled these with Monte Carlo simulations of 2D and 3D Ising spin glasses that produce magnetization noise SMconsistent with flux noise. The frequency dependence of the magnetization noise goes as 1/fαwhere the exponent a varies slightly with temperature. In 3D the noise power spectrum in the order parameter q goes as 1/ f1.4at Tc. The low frequency noise in both q and the magnetization is a maximum at Tc.
We propose a model for 1/f flux noise in superconducting devices (f is frequency). The noise is generated by the magnetic moments of electrons in defect states which they occupy for a wide distribution of times before escaping. A trapped electron occupies one of the two Kramers-degenerate ground states, between which the transition rate is negligible at low temperature. As a result, the magnetic moment orientation is locked. Simulations of the noise produced by randomly oriented defects with a density of 5x10(17) m(-2) yield 1/f noise magnitudes in good agreement with experiments.
The magnetic flux noise caused by surface spin fluctuations in superconducting quantum interference devices (SQUIDs) limits their development. In this work, we report that different adsorbents such as H, O 2, NO, and NO 2 that adsorb on the surfaces of Mg-based and Pb-based SQUIDs, respectively, producing large local magnetic moments ranging from 0.7–1.6 μ B, with energy barriers for thermal spin fluctuation as low as 10–30 mK. Moreover, we observe that the presence of H atoms on the surface of MgO can cause the coadsorption of other molecules, which generates additional spin sources. Monte Carlo simulations of the weakly coupled spin on a two-dimensional square lattice produce a low-frequency flux noise spectrum. We suggest eliminating the surface magnetism by coating the surface with monolayer indium phosphide or protecting the surface from other molecules by nonmagnetic preoccupants with a larger adsorption energy. The work provides important physical insights and feasible strategies for reducing magnetic noise sources in superconducting circuits.
Superconducting Quantum Interference Devices (SQUIDs) are currently being used as flux qubits and read-out detectors in a variety of solid-state quantum computer architectures. The main limitation of SQUID qubits is that they have a coherence time of the order of 10 us, due to the presence of intrinsic flux noise that is not yet fully understood. The origin of flux noise is currently believed to be related to spin impurities present in the materials and interfaces that form the device. Here we present a novel numerical method that enables calculations of the flux produced by spin impurities even when they are located quite close to the SQUID wire. We show that the SQUID will be particularly sensitive to spins located at its wire edges, generating flux shifts of up to 4 nano flux quanta, much higher than previous calculations based on the software package FastHenry. This shows that spin impurities in a particular region along the wire's surface play a much more important role in producing flux noise than other spin impurities located elsewhere in the device.
Superconducting Quantum Interference Devices (SQUIDs) and other superconducting circuits are limited by intrinsic flux noise with spectral density 1/fα1/f^{\alpha}1/fα with α<1\alpha<1α<1 whose origin is believed to be due to spin impurities. Here we present a theory of flux noise that takes into account the vectorial nature of the coupling of spins to superconducting wires. We present explicit numerical calculations of the flux noise power (spectral density integrated over all frequencies) for electron impurities and lattice nuclear spins under several different assumptions. The noise power is shown to be dominated by surface electron spins near the wire edges, with bulk lattice nuclear spins contributing ∼5\sim 5∼5% of the noise power in aluminum and niobium wires. We consider the role of electron spin phase transitions, showing that the spin-spin correlation length (describing e.g. the average size of ferromagnetic spin clusters) greatly impacts the scaling of flux noise with wire geometry. Remarkably, flux noise power is exactly equal to zero when the spins are polarized along the flux vector direction, forming what we call a poloidal state. Flux noise is non-zero for other spin textures, but gets reduced in the presence of correlated ferromagnetic fluctuations between the top and bottom wire surfaces, where the flux vectors are antiparallel. This demonstrates that engineering spin textures and/or inter-surface correlation provides a method to reduce flux noise in superconducting devices.