Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0810.5016

Quantum Measurements with Dynamically Bistable System

M. I. Dykman

Published Oct 28, 2008• 0 citations
arXivHTMLPDF

Abstract

Periodically modulated nonlinear oscillators often display bistability of forced vibrations. This bistability can be used for new types of quantum measurements. They are based on switching between coexisting vibrational states. Since switching is accompanied by a large change of the amplitude and phase of forced vibrations, the measurements are highly sensitive. Quantum and classical noise plays dual role. It imposes a limitation on sensitivity in the familiar regime of a bifurcation amplifier. On the other hand, it makes it possible to use a bistable modulated oscillator in a new regime of a balanced dynamical bridge. We discuss the switching probabilities and show that they display scaling with control parameters. The critical exponents are found for different types of bifurcations and for different types of noise.

DOI
10.48550/arxiv.0810.5016

Related papers

Bifurcation Oscillator as an Advanced Sensor for Quantum State Control

D. S. Pashin, M. V. Bastrakova, Сатанин Аркадий Михайлович +1 more

We study bifurcation behavior of a high-quality (high-Q) Josephson oscillator coupled to a superconducting qubit. It is shown that the probability of capture into the state of dynamic equilibrium is sensitive to qubit states. On this basis we present a new measurement method for the superposition state of a qubit due to its influence on transition probabilities between oscillator levels located in the energy region near the classical separatrix. The quantum-mechanical behavior of a bifurcation oscillator is also studied, which makes it possible to understand the mechanism of "entanglement" of oscillator and qubit states during the measurement process. The optimal parameters of the driving current and the state of the oscillator are found for performing one-qubit gates with the required precision, when the influence on the qubit from measurement back-action is minimal. A measurement protocol for state populations of the qubit entangled with the oscillator is presented.

Sensors•Aug 31, 2022•3 citations

Measurement-induced phase transitions and bistability in quantum–classical hybrids

Ding Jian, Temesgen Desta Leta, Huang Shuyao

Abstract This paper introduces a novel mathematical framework for analyzing bifurcations in quantum–classical hybrid systems, bridging quantum information science with classical nonlinear dynamics. Our approach integrates noncommutative bifurcation theory, quantum center manifold reduction, and measurement-induced transition analysis to provide rigorous mathematical results supported by detailed numerical examples. The proposed model captures bidirectional quantum–classical interactions through coupled differential equations, where quantum measurement backaction and entanglement play fundamental roles in modifying bifurcation behavior. We demonstrate significant advances in understanding quantum–classical interplay, with promising applications in quantum sensing, control, and synchronization. Our method is general and applicable to various nonlinear systems as verified by our numerical examples.

Physica Scripta•Mar 4, 2026•0 citations

Optical bistability switching with external noise

E. Arimondo, Didier Dangoisse, Leone Fronzoni +2 more

In an optically bistable system the switching time, i.e., the time required to switch the system between the off and on states, is a sensitive measure of noise and fluctuations. For a control parameter close to the threshold of the bistable operation, the critical slowing down takes place and large fluctuations in the switching times are originated.

International Laser Science Conference•Jan 1, 1986•1 citation

Quantum tunneling effect on switching rates of bistable driven system

N. S. Maslova, Evgeny V. Anikin, Vladimir N. Mantsevich +2 more

Abstract The influence of quantum tunneling effects on the bistability of nonlinear resonantly driven oscillators in the presence of external noise is analyzed by means of the generalized Fokker–Planck equation in quasi-energy space. Two time scales responsible for different stages of bistable system relaxation have been revealed. It was found that quantum tunneling effects could strongly change the switching rates between different stable states and considerably enhance occupation of the stable state with higher amplitude. It was also revealed that tunneling between nearly degenerate quasi-energy states and resonant multi-photon transitions between the genuine eigenstates of the nonlinear oscillator are just similar effects.

Laser Physics Letters•Mar 29, 2019•3 citations

Quantum analog of bifurcation and switching effects in a nonlinear Josephson oscillator

D. S. Pashin, M. V. Bastrakova, Сатанин Аркадий Михайлович +1 more

We theoretically study a nonlinear Josephson oscillator (Josephson junction) in the effective potential, which form is a result of a driving current. We first consider the phase dynamics in the classical regime and then explore the problem in the quantum regime by solving the energy eigenvalue problem. Here we are going to pay special attention to the study of the effects of switching between the states of a nonlinear oscillator separated by a separatrix. For this purpose, we consider controlling the oscillator with a "two-color" current. In the classical view, the first high-frequency current component brings the oscillator to the bifurcation point. A second modulated high-frequency component produces a programmed system switching. A similar scenario is considered in the quantum regime.

AIP conference proceedings•Jan 1, 2020•2 citations

The emergence of chaos in continuously monitored open quantum systems

Jessica K. Eastman

This thesis makes a unique contribution to the field of quantum chaos by theoretically demonstrating the effect that measurement has on the emergence of chaos from the quantum world and demonstrating a means to control the onset of chaos in the quantum system using adaptive measurements. Here we investigate how the choice of the continuous measurement strategy for an open quantum system affects the emergence of chaos in the transition from the quantum limit to the classical limit when the system is dissipative. We consider two models in our research. The Duffing oscillator is classically chaotic and also dissipative( ie. an open quantum system), whereas the driven top is classically a closed system; adding dissipation via continuous measurement therefore changes the behaviour in from the classical limit. The first half of this thesis presents the investigation of a dissipative system whose classical limit is chaotic. We explore the emergence of chaos from the open quantum system that is continuously monitored and investigate the dependence on the choice of monitoring by changing a single parameter in a homodyne measurement scheme, effectively changing the information gained by the measurement. We show that the emergence of chaos in the regime where quantum effects are still present can be determined solely by changing the measurement parameter. This is a result of the interplay between the quantum interference effects induced by the nonlinear dynamics and the localisation and decoherence that occurs due to the measurement. We also investigate the case where the classical limit is regular for the Duffing oscillator, and demonstrate the semiclassical effect of chaos induced by the measurement back-action. A certain choice of measurement leads to a noise which drives the system to large spread in the dimensionless position enabling a non-classical transition mechanism that is classically forbidden, inducing chaos in the system. These results are verified by the numerical calculation of the maximal Lyapunov exponent in the quantum regime. The second part of this thesis investigates the possibility of controlling the degree of chaos with quantum control. We design an effective control scheme to control the degree of chaos using the measurement dependency of the state. We propose an adaptive measurement scheme which changes the homodyne measurement angle in real time depending on the direction of the state's interference fringes in phase space. This is done using the knowledge gained by the measurement signal. We show that this control scheme can enhance or suppress chaos. By enhancing the degree of chaos we are also able to push the onset of chaos further into the quantum regime than was possible before. By suppressing chaos we generate highly non-classical states and regular motion. The feasibility of experimentally realising this control technique is discussed in detail. The final section of this thesis considers a chaotic system that is not dissipative in the classical limit: the driven top. We investigate the effect that opening the quantum system to decoherence has on the degree of chaos when we continuously measure the system. We demonstrate that the presence of decoherence suppresses the chaos and alters the dynamics of the quantum system. This is seen to worsen as the strength of the measurement is increased unless a particular measurement is chosen that perfectly cancels out the decoherence resulting in the Hamiltonian evolution in addition to noise from the measurement. These results are verified by the separation time between classical and quantum dynamics.

•Jan 1, 2020•0 citations
Periodically modulated nonlinear oscillators often display bistability of forced vibrations. This bistability can be used for new types of quantum measurements. They are based on switching between coexisting vibrational states. Since switching is accompanied by a large change of the amplitude and phase of forced vibrations, the measurements are highly sensitive. Quantum and classical noise plays dual role. It imposes a limitation on sensitivity in the familiar regime of a bifurcation amplifier. On the other hand, it makes it possible to use a bistable modulated oscillator in a new regime of a balanced dynamical bridge. We discuss the switching probabilities and show that they display scaling with control parameters. The critical exponents are found for different types of bifurcations and for different types of noise.
We study bifurcation behavior of a high-quality (high-Q) Josephson oscillator coupled to a superconducting qubit. It is shown that the probability of capture into the state of dynamic equilibrium is sensitive to qubit states. On this basis we present a new measurement method for the superposition state of a qubit due to its influence on transition probabilities between oscillator levels located in the energy region near the classical separatrix. The quantum-mechanical behavior of a bifurcation oscillator is also studied, which makes it possible to understand the mechanism of "entanglement" of oscillator and qubit states during the measurement process. The optimal parameters of the driving current and the state of the oscillator are found for performing one-qubit gates with the required precision, when the influence on the qubit from measurement back-action is minimal. A measurement protocol for state populations of the qubit entangled with the oscillator is presented.
Abstract This paper introduces a novel mathematical framework for analyzing bifurcations in quantum–classical hybrid systems, bridging quantum information science with classical nonlinear dynamics. Our approach integrates noncommutative bifurcation theory, quantum center manifold reduction, and measurement-induced transition analysis to provide rigorous mathematical results supported by detailed numerical examples. The proposed model captures bidirectional quantum–classical interactions through coupled differential equations, where quantum measurement backaction and entanglement play fundamental roles in modifying bifurcation behavior. We demonstrate significant advances in understanding quantum–classical interplay, with promising applications in quantum sensing, control, and synchronization. Our method is general and applicable to various nonlinear systems as verified by our numerical examples.
Abstract The influence of quantum tunneling effects on the bistability of nonlinear resonantly driven oscillators in the presence of external noise is analyzed by means of the generalized Fokker–Planck equation in quasi-energy space. Two time scales responsible for different stages of bistable system relaxation have been revealed. It was found that quantum tunneling effects could strongly change the switching rates between different stable states and considerably enhance occupation of the stable state with higher amplitude. It was also revealed that tunneling between nearly degenerate quasi-energy states and resonant multi-photon transitions between the genuine eigenstates of the nonlinear oscillator are just similar effects.
We theoretically study a nonlinear Josephson oscillator (Josephson junction) in the effective potential, which form is a result of a driving current. We first consider the phase dynamics in the classical regime and then explore the problem in the quantum regime by solving the energy eigenvalue problem. Here we are going to pay special attention to the study of the effects of switching between the states of a nonlinear oscillator separated by a separatrix. For this purpose, we consider controlling the oscillator with a "two-color" current. In the classical view, the first high-frequency current component brings the oscillator to the bifurcation point. A second modulated high-frequency component produces a programmed system switching. A similar scenario is considered in the quantum regime.
This thesis makes a unique contribution to the field of quantum chaos by theoretically demonstrating the effect that measurement has on the emergence of chaos from the quantum world and demonstrating a means to control the onset of chaos in the quantum system using adaptive measurements. Here we investigate how the choice of the continuous measurement strategy for an open quantum system affects the emergence of chaos in the transition from the quantum limit to the classical limit when the system is dissipative. We consider two models in our research. The Duffing oscillator is classically chaotic and also dissipative( ie. an open quantum system), whereas the driven top is classically a closed system; adding dissipation via continuous measurement therefore changes the behaviour in from the classical limit. The first half of this thesis presents the investigation of a dissipative system whose classical limit is chaotic. We explore the emergence of chaos from the open quantum system that is continuously monitored and investigate the dependence on the choice of monitoring by changing a single parameter in a homodyne measurement scheme, effectively changing the information gained by the measurement. We show that the emergence of chaos in the regime where quantum effects are still present can be determined solely by changing the measurement parameter. This is a result of the interplay between the quantum interference effects induced by the nonlinear dynamics and the localisation and decoherence that occurs due to the measurement. We also investigate the case where the classical limit is regular for the Duffing oscillator, and demonstrate the semiclassical effect of chaos induced by the measurement back-action. A certain choice of measurement leads to a noise which drives the system to large spread in the dimensionless position enabling a non-classical transition mechanism that is classically forbidden, inducing chaos in the system. These results are verified by the numerical calculation of the maximal Lyapunov exponent in the quantum regime. The second part of this thesis investigates the possibility of controlling the degree of chaos with quantum control. We design an effective control scheme to control the degree of chaos using the measurement dependency of the state. We propose an adaptive measurement scheme which changes the homodyne measurement angle in real time depending on the direction of the state's interference fringes in phase space. This is done using the knowledge gained by the measurement signal. We show that this control scheme can enhance or suppress chaos. By enhancing the degree of chaos we are also able to push the onset of chaos further into the quantum regime than was possible before. By suppressing chaos we generate highly non-classical states and regular motion. The feasibility of experimentally realising this control technique is discussed in detail. The final section of this thesis considers a chaotic system that is not dissipative in the classical limit: the driven top. We investigate the effect that opening the quantum system to decoherence has on the degree of chaos when we continuously measure the system. We demonstrate that the presence of decoherence suppresses the chaos and alters the dynamics of the quantum system. This is seen to worsen as the strength of the measurement is increased unless a particular measurement is chosen that perfectly cancels out the decoherence resulting in the Hamiltonian evolution in addition to noise from the measurement. These results are verified by the separation time between classical and quantum dynamics.