Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0806.3194 · Optics Express

Optical properties of superconducting nanowire single-photon detectors

Vikas Anant, Andrew J. Kerman, Eric A. Dauler, Joel K. W. Yang, Kristine M. Rosfjord, Karl K. Berggren

Published Jul 3, 2008• 167 citations
arXivHTMLPDF

Abstract

We measured the optical absorptance of superconducting nanowire single photon detectors. We found that 200-nm-pitch, 50%-fill-factor devices had an average absorptance of 21% for normally-incident front-illumination of 1.55-microm-wavelength light polarized parallel to the nanowires, and only 10% for perpendicularly-polarized light. We also measured devices with lower fill-factors and narrower wires that were five times more sensitive to parallel-polarized photons than perpendicular-polarized photons. We developed a numerical model that predicts the absorptance of our structures. We also used our measurements, coupled with measurements of device detection efficiencies, to determine the probability of photon detection after an absorption event. We found that, remarkably, absorbed parallel-polarized photons were more likely to result in detection events than perpendicular-polarized photons, and we present a hypothesis that qualitatively explains this result. Finally, we also determined the enhancement of device detection efficiency and absorptance due to the inclusion of an integrated optical cavity over a range of wavelengths (700-1700 nm) on a number of devices, and found good agreement with our numerical model.

DOI
10.1364/oe.16.010750

Related papers

Impedance model for the polarization-dependent optical absorption of superconducting single-photon detectors

E. F. C. Driessen, Floris Braakman, Elisabeth Reiger +3 more

We measured the single-photon detection efficiency of NbN superconducting single-photon detectors as a function of the polarization state of the incident light for different wavelengths in the range from 488 nm to 1550 nm. The polarization contrast varies from ~5% at 488 nm to ~30% at 1550 nm, in good agreement with numerical calculations. We use an optical-impedance model to describe the absorption for polarization parallel to the wires of the detector. For the extremely lossy NbN material, the absorption can be kept constant by keeping the product of layer thickness and filling factor constant. As a consequence, the maximum possible absorption is independent of filling factor. By illuminating the detector through the substrate, an absorption efficiency of ~70% can be reached for a detector on Si or GaAs, without the need for an optical cavity.

arXiv:0901.4922•The European Physical Journal Applied Physics•May 13, 2009•51 citations

Design of a polarization-insensitive superconducting nanowire single photon detector with high detection efficiency

Fan Zheng, Ruiying Xu, Guanghao Zhu +5 more

Superconducting nanowire single photon detectors (SNSPDs) deliver superior performance over their competitors in the near-infrared regime. However, these detectors have an intrinsic polarization dependence on the incident wave because of their one-dimensional meander structure. In this paper, we propose an approach to eliminate the polarization sensitivity of SNSPDs by using near-field optics to increase the absorption of SNSPDs under transverse magnetic (TM) illumination. In addition, an optical cavity is added to our SNSPD to obtain nearly perfect absorption of the incident wave. Numerical simulations show that the maximum absorption of a designed SNSPD can reach 96% at 1550 nm, and indicate that the absorption difference between transverse electric (TE) and TM polarization is less than 0.5% across a wavelength window of 300 nm. Our work provides the first demonstration of the possibility of designing a polarization-insensitive and highly efficient SNSPD without performing device symmetry improvements.

Scientific Reports•Mar 7, 2016•37 citations

Superconducting nanowire single-photon detector in an optical cavity for front-side illumination

Burm Baek, Jeffrey A. Stern, Sae Woo Nam

We have integrated superconducting nanowire single-photon detectors (SNSPDs) with an optical cavity design for front-side illumination. Our optical cavity design increases the coupling efficiency of light to the nanowire detector and enables straightforward proximity fiber-coupling for a multichannel detector system. Using a confocal optical scanning technique, we measured a significantly enhanced optical absorptance of 73% in comparison with 20% in a typical bare nanowire device at 1550 nm and 3 K. Our method of fabrication of these devices on a silicon wafer and the local optical absorptance measurement are important steps toward developing next-generation SNSPD technology.

Applied Physics Letters•Nov 9, 2009•39 citations

Design of a low-filling-factor and polarization-sensitive superconducting nanowire single photon detector with high detection efficiency

Dezhi Li, Rongzhen Jiao

We designed a low-filling-factor and polarization-sensitive superconducting nanowire single photon detector (SNSPD), which can achieve a high absorption efficiency and counting rate simultaneously. Numerical simulations show that high absorption efficiency can be achieved by low-filling-factor SNSPDs with a silicon slot and silver reflector. The absorptance of the NbN nanowire for a transverse magnetic (TM) wave at the wavelength of 1550 nm can be 84.4% when the filling factor is only 16.5%, and the corresponding polarization extinction ratio (PER) is 562.9; the absorptance of the NbN nanowire for a transverse electric (TE) wave can be 67.0% when the filling factor is only 11.7%, and the PER is 7.4.

Photonics Research•Jul 15, 2019•18 citations

Characterization of optical absorptance in superconducting nanowire single-photon detectors

Taro Yamashita, Shigehito Miki, Hirotaka Terai +1 more

We present a numerical simulation of the optical absorptance for the superconducting nanowire single-photon detectors (SNSPDs or SSPDs) designed with various layouts by using finite-element analysis software. The simulation results reveal that the electric field concentrated in the superconducting nanowire is enhanced by reducing the filling factor, and the degree of the enhancement becomes larger for thicker nanowires. Due to the large enhancement of the electric field in the nanowire with a double-side cavity structure, the high optical absorptance can be achieved even for the low-filling-factor layout by tuning the device design, which leads to the realization of SSPDs with high system detection efficiency and high counting rate.

IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2013•0 citations

Development and Evaluation of Superconducting Nanowire Single-Photon Detectors for 900-1100 nm Photon Detection

Fumihiro China, Shigehito Miki, Masahiro Yabuno +2 more

Superconducting nanowire single-photon detectors(SSPDs or SNSPDs) can detect single photons in a wide spectrum range from ultraviolet to mid-infrared wavelengths. We developed SSPDs for the light wavelength of 900-1100 nm, where it is difficult to achieve high detection efficiency by either Si or InGaAs avalanche photodiodes. We designed and fabricated the SSPD with non-periodic dielectric multilayers (DMLs) composed of SiO2 and TiO2 to enhance the optical absorptance in the wavelength range of 900-1100 nm. We measured the detection efficiency (DE) in the wavelength range of 800-1360 nm using a supercontinuum light source and found that the wavelength dependence of DE was in good agreement with the simulated spectrum of the optical absorptance of the nanowire device on the designed DML. The highest system DE was 81.0% for the wavelength of 980 nm.

IEICE Transactions on Electronics•Apr 30, 2020•0 citations
We measured the optical absorptance of superconducting nanowire single photon detectors. We found that 200-nm-pitch, 50%-fill-factor devices had an average absorptance of 21% for normally-incident front-illumination of 1.55-microm-wavelength light polarized parallel to the nanowires, and only 10% for perpendicularly-polarized light. We also measured devices with lower fill-factors and narrower wires that were five times more sensitive to parallel-polarized photons than perpendicular-polarized photons. We developed a numerical model that predicts the absorptance of our structures. We also used our measurements, coupled with measurements of device detection efficiencies, to determine the probability of photon detection after an absorption event. We found that, remarkably, absorbed parallel-polarized photons were more likely to result in detection events than perpendicular-polarized photons, and we present a hypothesis that qualitatively explains this result. Finally, we also determined the enhancement of device detection efficiency and absorptance due to the inclusion of an integrated optical cavity over a range of wavelengths (700-1700 nm) on a number of devices, and found good agreement with our numerical model.
We measured the single-photon detection efficiency of NbN superconducting single-photon detectors as a function of the polarization state of the incident light for different wavelengths in the range from 488 nm to 1550 nm. The polarization contrast varies from ~5% at 488 nm to ~30% at 1550 nm, in good agreement with numerical calculations. We use an optical-impedance model to describe the absorption for polarization parallel to the wires of the detector. For the extremely lossy NbN material, the absorption can be kept constant by keeping the product of layer thickness and filling factor constant. As a consequence, the maximum possible absorption is independent of filling factor. By illuminating the detector through the substrate, an absorption efficiency of ~70% can be reached for a detector on Si or GaAs, without the need for an optical cavity.
Superconducting nanowire single photon detectors (SNSPDs) deliver superior performance over their competitors in the near-infrared regime. However, these detectors have an intrinsic polarization dependence on the incident wave because of their one-dimensional meander structure. In this paper, we propose an approach to eliminate the polarization sensitivity of SNSPDs by using near-field optics to increase the absorption of SNSPDs under transverse magnetic (TM) illumination. In addition, an optical cavity is added to our SNSPD to obtain nearly perfect absorption of the incident wave. Numerical simulations show that the maximum absorption of a designed SNSPD can reach 96% at 1550 nm, and indicate that the absorption difference between transverse electric (TE) and TM polarization is less than 0.5% across a wavelength window of 300 nm. Our work provides the first demonstration of the possibility of designing a polarization-insensitive and highly efficient SNSPD without performing device symmetry improvements.
We have integrated superconducting nanowire single-photon detectors (SNSPDs) with an optical cavity design for front-side illumination. Our optical cavity design increases the coupling efficiency of light to the nanowire detector and enables straightforward proximity fiber-coupling for a multichannel detector system. Using a confocal optical scanning technique, we measured a significantly enhanced optical absorptance of 73% in comparison with 20% in a typical bare nanowire device at 1550 nm and 3 K. Our method of fabrication of these devices on a silicon wafer and the local optical absorptance measurement are important steps toward developing next-generation SNSPD technology.
We designed a low-filling-factor and polarization-sensitive superconducting nanowire single photon detector (SNSPD), which can achieve a high absorption efficiency and counting rate simultaneously. Numerical simulations show that high absorption efficiency can be achieved by low-filling-factor SNSPDs with a silicon slot and silver reflector. The absorptance of the NbN nanowire for a transverse magnetic (TM) wave at the wavelength of 1550 nm can be 84.4% when the filling factor is only 16.5%, and the corresponding polarization extinction ratio (PER) is 562.9; the absorptance of the NbN nanowire for a transverse electric (TE) wave can be 67.0% when the filling factor is only 11.7%, and the PER is 7.4.
We present a numerical simulation of the optical absorptance for the superconducting nanowire single-photon detectors (SNSPDs or SSPDs) designed with various layouts by using finite-element analysis software. The simulation results reveal that the electric field concentrated in the superconducting nanowire is enhanced by reducing the filling factor, and the degree of the enhancement becomes larger for thicker nanowires. Due to the large enhancement of the electric field in the nanowire with a double-side cavity structure, the high optical absorptance can be achieved even for the low-filling-factor layout by tuning the device design, which leads to the realization of SSPDs with high system detection efficiency and high counting rate.
Superconducting nanowire single-photon detectors(SSPDs or SNSPDs) can detect single photons in a wide spectrum range from ultraviolet to mid-infrared wavelengths. We developed SSPDs for the light wavelength of 900-1100 nm, where it is difficult to achieve high detection efficiency by either Si or InGaAs avalanche photodiodes. We designed and fabricated the SSPD with non-periodic dielectric multilayers (DMLs) composed of SiO2 and TiO2 to enhance the optical absorptance in the wavelength range of 900-1100 nm. We measured the detection efficiency (DE) in the wavelength range of 800-1360 nm using a supercontinuum light source and found that the wavelength dependence of DE was in good agreement with the simulated spectrum of the optical absorptance of the nanowire device on the designed DML. The highest system DE was 81.0% for the wavelength of 980 nm.