Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0806.0942 · Europhysics Letters (EPL)

Photon and polariton fluctuations in arrays of QED-cavities

Davide Rossini, Rosario Fazio, Giuseppe E. Santoro

Published Aug 1, 2008• 25 citations
arXivHTMLPDF

Abstract

We propose to detect the Mott insulator-superfluid quantum phase transition in an array of coupled cavities by studying the polariton and photon fluctuations in a block of linear dimension M (in units of the lattice constant of the array). We explicitly show this for a one-dimensional array; the analysis can be however extended to higher dimensions. In the Mott phase polariton fluctuations are independent of the block size. In the superfluid phase they grow logarithmically with M , the prefactor being related to the compressibility of the system. In the case of photon fluctuations, the critical behaviour is encoded in the subleading scaling with the block dimension, while the leading behaviour is linear in M and non-critical. Our results have been obtained by means of the density matrix renormalization group numerical algorithm.

DOI
10.1209/0295-5075/83/47011

Related papers

Phase diagram of a QED-cavity array coupled via a N-type level scheme

Jiasen Jin, Rosario Fazio, Davide Rossini

We study the zero-temperature phase diagram of a one-dimensional array of QED cavities where, besides the single-photon hopping, an additional coupling between neighboring cavities is mediated by an N -type four-level system. By varying the relative strength of the various couplings, the array is shown to exhibit a variety of quantum phases including a polaritonic Mott insulator, a density-wave and a superfluid phase. Our results have been obtained by means of numerical density-matrix renormalization group calculations. The phase diagram was obtained by analyzing the energy gaps for the polaritons, as well as through a study of two-point correlation functions.

arXiv:1503.03146•EPJ Quantum Technology•Feb 20, 2015•1 citation

Mott-Insulating and Glassy Phases of Polaritons in 1D Arrays of Coupled Cavities

Davide Rossini, Rosario Fazio

By means of analytical and numerical methods we analyze the phase diagram of polaritons in one-dimensional coupled cavities. We locate the phase boundary, discuss the behavior of the polariton compressibility and visibility fringes across the critical point, and find a nontrivial scaling of the phase boundary as a function of the number of atoms inside each cavity. We also predict the emergence of a polaritonic glassy phase when the number of atoms fluctuates from cavity to cavity.

arXiv:0705.1062•Physical Review Letters•Oct 29, 2007•201 citations

Quantum Fluctuations, Temperature, and Detuning Effects in Solid-Light Systems

Markus Aichhorn, Martin Hohenadler, Charles Tahan +1 more

The superfluid to Mott insulator transition in cavity polariton arrays is analyzed using the variational cluster approach, taking into account quantum fluctuations exactly on finite length scales. Phase diagrams in one and two dimensions exhibit important non-mean-field features. Single-particle excitation spectra in the Mott phase are dominated by particle and hole bands separated by a Mott gap. In contrast to Bose-Hubbard models, detuning allows for changing the nature of the bosonic particles from quasilocalized excitons to polaritons to weakly interacting photons. The Mott state with density one exists up to temperatures T/g > or = 0.03, implying experimentally accessible temperatures for realistic cavity couplings g.

arXiv:0803.3963•Physical Review Letters•May 29, 2008•84 citations

Quantum Phase Transition in Strongly-Correlated Cavity Polaritons

Jian Yang Xue, Kangjun Seo, Lin Tian +1 more

We study the quantum critical behavior in a multiconnected Jaynes-Cummings lattice using the density-matrix renormalization group method, where cavity polaritons exhibit a Mott-insulator-to-superfluid phase transition. We calculate the phase boundaries and the quantum critical points.

Asia Communications and Photonics Conference•Oct 1, 2018•0 citations

Superfluid–Mott-insulator quantum phase transition in a cavity optomagnonic system

Qian Cao, Lei Tan, Wu‐Ming Liu

The emerging hybrid cavity optomagnonic system is a very promising quantum information processing platform for its strong or ultrastrong photon-magnon interaction on the scale of micrometers in the experiment. In this paper, the superfluid--Mott-insulator quantum phase transition in a two-dimensional cavity optomagnonic array system has been studied based on this characteristic. The analytical solution of the critical hopping rate is obtained by the mean-field approach, second-order perturbation theory, and Landau second-order phase transition theory. The numerical results show that the increasing coupling strength and the positive detunings of the photon and the magnon favor the coherence and then the stable areas of Mott lobes are compressed correspondingly. Moreover, the analytical results agree with the numerical ones when the total excitation number is lower. Finally, an effective repulsive potential is constructed to exhibit the corresponding mechanism. The results obtained here provide an experimentally feasible scheme for characterizing the quantum phase transitions in a cavity optomagnonic array system, which will offer valuable insight for quantum simulations.

arXiv:2201.08086•Physical Review A•Apr 5, 2022•8 citations

Quantum phase transitions in a linear cavity QED array

Shamailov, Samira

In this thesis we investigate the Mott-insulator to superfluid quantum phase transition in a one-dimensional chain of cavity quantum electrodynamics (cavity QED) systems described by the Jaynes-Cummings-Hubbard model. The phase transition has been predicted and studied theoretically rather intensively in recent years, but no experiments have been reported. A direct observation of the transition requires a complex entangled state of a large number of photons to be prepared and remain stable for the duration of the measurements on the system. When it comes to photons, however, there is no known reliable way of preparing the state. Our goal is to find out whether it is at all possible to observe the phase transition in a cavity QED system, and if it is, find a way to do so. I consider two main approaches: (1) cooling to the ground state before a photon can escape, and (2) looking for signs of the transition in the evolution following a quantum quench. I show that the first idea is impossible (within the limits of my imagination) while the second contains no relevant information. In fact, I rule out a large number of open-system ideas along the usual drive-and-decay lines. I then conclude that observation of the phase transition in our system of interest is not possible (as far as I can see), basing this claim on logical exclusion of all options. I also develop and describe in detail the well-known Density Matrix Renormalization Group algorithms for simulating one-dimensional many-body systems. I provide detailed technical guidance, allowing the reader to easily write their own codes.

•Jan 1, 2011•0 citations
We propose to detect the Mott insulator-superfluid quantum phase transition in an array of coupled cavities by studying the polariton and photon fluctuations in a block of linear dimension M (in units of the lattice constant of the array). We explicitly show this for a one-dimensional array; the analysis can be however extended to higher dimensions. In the Mott phase polariton fluctuations are independent of the block size. In the superfluid phase they grow logarithmically with M , the prefactor being related to the compressibility of the system. In the case of photon fluctuations, the critical behaviour is encoded in the subleading scaling with the block dimension, while the leading behaviour is linear in M and non-critical. Our results have been obtained by means of the density matrix renormalization group numerical algorithm.
We study the zero-temperature phase diagram of a one-dimensional array of QED cavities where, besides the single-photon hopping, an additional coupling between neighboring cavities is mediated by an N -type four-level system. By varying the relative strength of the various couplings, the array is shown to exhibit a variety of quantum phases including a polaritonic Mott insulator, a density-wave and a superfluid phase. Our results have been obtained by means of numerical density-matrix renormalization group calculations. The phase diagram was obtained by analyzing the energy gaps for the polaritons, as well as through a study of two-point correlation functions.
The superfluid to Mott insulator transition in cavity polariton arrays is analyzed using the variational cluster approach, taking into account quantum fluctuations exactly on finite length scales. Phase diagrams in one and two dimensions exhibit important non-mean-field features. Single-particle excitation spectra in the Mott phase are dominated by particle and hole bands separated by a Mott gap. In contrast to Bose-Hubbard models, detuning allows for changing the nature of the bosonic particles from quasilocalized excitons to polaritons to weakly interacting photons. The Mott state with density one exists up to temperatures T/g > or = 0.03, implying experimentally accessible temperatures for realistic cavity couplings g.
The emerging hybrid cavity optomagnonic system is a very promising quantum information processing platform for its strong or ultrastrong photon-magnon interaction on the scale of micrometers in the experiment. In this paper, the superfluid--Mott-insulator quantum phase transition in a two-dimensional cavity optomagnonic array system has been studied based on this characteristic. The analytical solution of the critical hopping rate is obtained by the mean-field approach, second-order perturbation theory, and Landau second-order phase transition theory. The numerical results show that the increasing coupling strength and the positive detunings of the photon and the magnon favor the coherence and then the stable areas of Mott lobes are compressed correspondingly. Moreover, the analytical results agree with the numerical ones when the total excitation number is lower. Finally, an effective repulsive potential is constructed to exhibit the corresponding mechanism. The results obtained here provide an experimentally feasible scheme for characterizing the quantum phase transitions in a cavity optomagnonic array system, which will offer valuable insight for quantum simulations.
In this thesis we investigate the Mott-insulator to superfluid quantum phase transition in a one-dimensional chain of cavity quantum electrodynamics (cavity QED) systems described by the Jaynes-Cummings-Hubbard model. The phase transition has been predicted and studied theoretically rather intensively in recent years, but no experiments have been reported. A direct observation of the transition requires a complex entangled state of a large number of photons to be prepared and remain stable for the duration of the measurements on the system. When it comes to photons, however, there is no known reliable way of preparing the state. Our goal is to find out whether it is at all possible to observe the phase transition in a cavity QED system, and if it is, find a way to do so. I consider two main approaches: (1) cooling to the ground state before a photon can escape, and (2) looking for signs of the transition in the evolution following a quantum quench. I show that the first idea is impossible (within the limits of my imagination) while the second contains no relevant information. In fact, I rule out a large number of open-system ideas along the usual drive-and-decay lines. I then conclude that observation of the phase transition in our system of interest is not possible (as far as I can see), basing this claim on logical exclusion of all options. I also develop and describe in detail the well-known Density Matrix Renormalization Group algorithms for simulating one-dimensional many-body systems. I provide detailed technical guidance, allowing the reader to easily write their own codes.