Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0710.4457 · Physical Review A

Superluminal group velocity in a birefringent crystal

Tore Gunnar Halvorsen, Jon Magne Leinaas

Published Feb 6, 2008• 2 citations
arXivHTMLPDF

Abstract

We examine the effect of superluminal signal propagation through a birefringent crystal, where the effect is not due to absorption or reflection, but to the filtration of a special polarization component. We first examine the effect by a stationary phase analysis, with results consistent with those of an earlier analysis of the system. We supplement this analysis by considering the transit of a Gaussian wave and find bounds for the validity of the stationary phase result. The propagation of the Gaussian wave is illustrated by figures.

DOI
10.1103/physreva.77.023808

Related papers

Experimental demonstration of "fast light" in an absorptionless, non-reflective system using the birefringence of a photonic crystal

D.R. SoIIi, Colin F. McCormick, Claus Ropers +3 more

This study investigates the first experimental observation of faster-than-c group velocities in a passive system with neither absorption nor reflection. The investigation shows that superluminal and even negative group velocities can exist because of interference, instead of absorption or reflection. Results suggest that causal superluminal propagation can potentially be observed in any system in which input energy can escape into other modes. These results also demonstrate a particularly unusual application of the amplitude-phase Kramers-Kronig (K-K) relations; for the system being described, an infinitesimal adjustment of parameters radically affects the validity of the K-K transformation between amplitude and phase.

European Quantum Electronics Conference (EQEC)•Nov 15, 2004•0 citations

Is `Superluminal' Light Propagation Possible in Dispersive Media?

Chen Kai, Ling-An Wu, Shi Yan-Hua

In a dispersive medium, different monochromatic modes of light have different phase velocities. Under special circumstances, a superposition of these modes results in an interesting effect wherein the group velocity (the velocity at which the peak of the wavepacket propagates) could be greater than c or even negative although the phase velocities of the modes are all less than c . Can this superluminal group velocity be used for information transfer? We show here that the `superluminal' effect is due to a coherent optical wave superposition effect. Whatever the velocity of the `peak', the whole pulse cannot travel with a speed greater than the fastest phase velocity of its component modes. Thus the maximum speed for information transfer, which involves the sending of a finite pulse, cannot be greater than the maximum phase velocity in the medium.

Chinese Physics Letters•May 1, 2004•3 citations

Direct Measurement of Superluminal Group Velocity and Signal Velocity in an Optical Fiber

Nicolas Brunner, Valerio Scarani, Mark Wegmüller +2 more

We present an easy way of observing superluminal group velocities using a birefringent optical fiber and other standard devices. In the theoretical analysis, we show that the optical properties of the setup can be described using the notion of "weak value." The experiment shows that the group velocity can indeed exceed c in the fiber; and we report the first direct observation of the so-called "signal velocity," the speed at which information propagates and that cannot exceed c.

arXiv:quant-ph/0407155•Physical Review Letters•Nov 11, 2004•211 citations

THE STATIONARY PHASE CONDITION APPLICABILITY TO THE STUDY OF TUNNEL EFFECT

Alex E. Bernardini

Some recent theoretical studies tended to employ analytically-continuous gaussian, or infinite-bandwidth step pulses to examine tunneling process. The stationary phase method is often employed to this aim. However, gaussian functions do not have a well-defined front, such that their speed of propagation becomes ambiguous. Also, infinite bandwidth signals cannot propagate through any real physical medium (whose transfer function is therefore finite) without pulse distortion, which also leads to ambiguities in determining propagation velocity during the tunneling process. In this manuscript, we appoint some incompatibilities with the application of the method of stationary phase in deriving tunneling times which, eventually, can ruin the superluminal interpretation of transition times.

arXiv:quant-ph/0510065•Modern Physics Letters B•Aug 10, 2005•2 citations

Transition between superluminal and subluminal light propagation in photorefractive Bi12SiO20 crystals

Fang Bo, Guoquan Zhang, Jingjun Xu

We demonstrated superluminal light propagation with a negative group velocity of -5.7 m/s in a photorefractive Bi 12SiO20 crystal by using the dispersive phase coupling effect in a nondegenerate two-wave mixing process. To the best of our knowledge, this is the first experimental demonstration of superluminal light propagation at room temperature in solids by using a classical wave mixing technique. In addition, we showed the tunability of the group velocity of light between the negative (superluminal light) and the positive (subluminal light) by simply tuning the experimental conditions such as the frequency of the coupling beam, the incident intensity, and the externally applied electric fields.

Optics Express•Jan 1, 2005•20 citations

Superluminal (but causal) propagation of wave packets in transparent media with inverted atomic populations

R. Y. Chiao

The propagation of limited-bandwidth signals, such as Gaussian wave packets, tuned to a transparent spectral region far below the resonance of an inverted two-level atomic medium, can be superluminal, i.e., with phase, group, and energy velocities all exceeding the vacuum speed of light c. Causality is not violated, however. Little distortion and gain can accompany this propagation.

Physical Review A•Jul 1, 1993•249 citations
We examine the effect of superluminal signal propagation through a birefringent crystal, where the effect is not due to absorption or reflection, but to the filtration of a special polarization component. We first examine the effect by a stationary phase analysis, with results consistent with those of an earlier analysis of the system. We supplement this analysis by considering the transit of a Gaussian wave and find bounds for the validity of the stationary phase result. The propagation of the Gaussian wave is illustrated by figures.
This study investigates the first experimental observation of faster-than-c group velocities in a passive system with neither absorption nor reflection. The investigation shows that superluminal and even negative group velocities can exist because of interference, instead of absorption or reflection. Results suggest that causal superluminal propagation can potentially be observed in any system in which input energy can escape into other modes. These results also demonstrate a particularly unusual application of the amplitude-phase Kramers-Kronig (K-K) relations; for the system being described, an infinitesimal adjustment of parameters radically affects the validity of the K-K transformation between amplitude and phase.
In a dispersive medium, different monochromatic modes of light have different phase velocities. Under special circumstances, a superposition of these modes results in an interesting effect wherein the group velocity (the velocity at which the peak of the wavepacket propagates) could be greater than c or even negative although the phase velocities of the modes are all less than c . Can this superluminal group velocity be used for information transfer? We show here that the `superluminal' effect is due to a coherent optical wave superposition effect. Whatever the velocity of the `peak', the whole pulse cannot travel with a speed greater than the fastest phase velocity of its component modes. Thus the maximum speed for information transfer, which involves the sending of a finite pulse, cannot be greater than the maximum phase velocity in the medium.
We present an easy way of observing superluminal group velocities using a birefringent optical fiber and other standard devices. In the theoretical analysis, we show that the optical properties of the setup can be described using the notion of "weak value." The experiment shows that the group velocity can indeed exceed c in the fiber; and we report the first direct observation of the so-called "signal velocity," the speed at which information propagates and that cannot exceed c.
Some recent theoretical studies tended to employ analytically-continuous gaussian, or infinite-bandwidth step pulses to examine tunneling process. The stationary phase method is often employed to this aim. However, gaussian functions do not have a well-defined front, such that their speed of propagation becomes ambiguous. Also, infinite bandwidth signals cannot propagate through any real physical medium (whose transfer function is therefore finite) without pulse distortion, which also leads to ambiguities in determining propagation velocity during the tunneling process. In this manuscript, we appoint some incompatibilities with the application of the method of stationary phase in deriving tunneling times which, eventually, can ruin the superluminal interpretation of transition times.
We demonstrated superluminal light propagation with a negative group velocity of -5.7 m/s in a photorefractive Bi 12SiO20 crystal by using the dispersive phase coupling effect in a nondegenerate two-wave mixing process. To the best of our knowledge, this is the first experimental demonstration of superluminal light propagation at room temperature in solids by using a classical wave mixing technique. In addition, we showed the tunability of the group velocity of light between the negative (superluminal light) and the positive (subluminal light) by simply tuning the experimental conditions such as the frequency of the coupling beam, the incident intensity, and the externally applied electric fields.