Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0707.0602 · Physical Review A

Limitations of the modulation method to smooth wire-guide roughness

Isabelle Bouchoule, Jean-Baptiste Trebbia, Carlos L. Garrido Alzar

Published Feb 27, 2008• 18 citations
arXivHTMLPDF

Abstract

It was recently demonstrated that wire-guide roughness can be suppressed by modulating the wire currents so that the atoms experience a time-averaged potential without roughness [Trebbia et al., Phys. Rev. Lett. 98, 263201 (2007)]. In this paper, we theoretically study the limitations of this technique. At low modulation frequency, we show that the longitudinal potential modulation produces heating of the cloud, and we compute the heating rate. We also give a quantum derivation of the rough conservative potential associated with the micromotion of the atoms. At large modulation frequency, we compute the loss rate due to nonadiabatic spin flip and show that it presents resonances at multiple modulation frequencies. These studies show that the modulation technique works for a wide range of experimental parameters. We also give conditions to realize radio-frequency evaporative cooling in such a modulated trap.

DOI
10.1103/physreva.77.023624

Related papers

Roughness Suppression via Rapid Current Modulation on an Atom Chip

Jean-Baptiste Trebbia, Carlos L. Garrido Alzar, R. Cornelussen +2 more

We present a method to suppress the roughness of the potential of a wire-based, magnetic atom guide: modulating the wire current at a few tens of kHz, the potential roughness, which is proportional to the wire current, averages to zero. Using ultracold 87Rb clouds, we show experimentally that modulation reduces the roughness by at least a factor five without measurable heating or atom loss. This roughness suppression results in a dramatic reduction of the damping of center-of-mass oscillations.

arXiv:quant-ph/0701207•Physical Review Letters•Jun 25, 2007•68 citations

Roughness suppression in an AC atom chip

Jean-Baptiste Trebbia, Carlos L. Garrido Alzar, Ronald Cornelussen +2 more

We present a method to suppress the potential roughness of a wire-based, magnetic atom guide: modulating the wire current at a few tens of kHz, the potential roughness, which is proportional to the wire current, averages to zero. Using ultra-cold $^{87}{\\rm Rb}$ clouds, we show experimentally that modulation reduces the roughness by at least of a factor five without measurable heating or atom loss. This roughness suppression results in a dramatic reduction of the damping of center of mass oscillations.

•Jan 1, 2007•0 citations

Potential roughness suppression in a RF AC Zeeman atom chip trap

William Miyahira, S. Aubin

Trapping and manipulating ultracold atoms through the use of atom chips offers the ability to engineer complex electromagnetic field geometries in a compact form factor. One of the primary limitations hindering their use is trap potential roughness which arises as a result of defects in the atom chip wires when atoms are brought close to the chip. This roughness can play a limiting role in atom interferometry and strong 1D confinement experiments. We present an initial experimental demonstration of atom chip potential roughness suppression using radio-frequency (RF) AC Zeeman (ACZ) potentials on an atom chip. Using ∼20 MHz RF magnetic near-fields from the chip to target intra-manifold transitions in the 87Rb ground state, we trap atoms in a spindependent ACZ potential. We compare the axial trapping potential for atoms in comparable 2-wire DC and AC Zeeman traps and show evidence of roughness suppression in the AC trap.

Optical and Quantum Sensing and Precision Metrology II•Mar 13, 2024•0 citations

Suppression of potential roughness in atom-chip ac Zeeman traps

Shuangli Du, Austin R. Ziltz, William Miyahira +1 more

We present several toy models for predicting the character and strength of the roughness of ac Zeeman trapping potentials generated by imperfections in wire traces on an atom chip. An ac Zeeman trapping potential is generated by targeting a microwave or rf magnetic field at hyperfine or Zeeman ground-state transitions, respectively, while a dc Zeeman trap uses a static magnetic field to manipulate an atom via its magnetic moment. We find that an ac Zeeman trap suppresses potential roughness by several orders of magnitude with respect to a comparable dc Zeeman trap. This suppression stems from the inherent differences between an atom's response to dc and ac (namely rf and microwave) magnetic fields, in concert with how the ac skin effect smooths out a current distribution disturbed by a conductivity variation. For chip wires fabricated by evaporation, we find that an ac Zeeman trap for $^{87}\mathrm{Rb}$ atoms, located $100\phantom{\rule{4pt}{0ex}}\ensuremath{\mu}\mathrm{m}$ from the chip and operating on a 6.8 GHz hyperfine transition, is expected to suppress potential roughness by a factor of $4\ifmmode\times\else\texttimes\fi{}{10}^{5}$ compared with a similar dc Zeeman trap. For a comparable ac Zeeman trap operating on a 10 MHz Zeeman transition, the suppression is $2\ifmmode\times\else\texttimes\fi{}{10}^{4}$. Conversely, the ac skin effect also slightly exacerbates potential roughness, in ac Zeeman traps, from defects in the sidewall of a wire trace.

Physical Review A•May 31, 2022•4 citations

Trapping and cooling of rf-dressed atoms in a quadrupole magnetic field

Olivier Morizot, Carlos L. Garrido Alzar, Paul-Éric Pottie +2 more

We observe the spontaneous evaporation of atoms confined in a bubble-like radio frequency (rf)-dressed trap (Zobay and Garraway 2001 Phys. Rev. Lett. 86 1195; 2004 Phys. Rev. A 69 023605). The atoms are confined in a quadrupole magnetic trap and are dressed by a linearly polarized rf field. The evaporation is related to the presence of holes in the trap, at the positions where the rf coupling vanishes, due to its vectorial character. The final temperature results from a competition between residual heating and evaporation efficiency, which is controlled via the height of the holes with respect to the bottom of the trap. The experimental data are modelled by a Monte Carlo simulation predicting a small increase in phase-space density limited by the heating rate. This increase was within the phase-space density determination uncertainty of the experiment.

arXiv:0709.2841•Journal of Physics B Atomic Molecular and Optical Physics•Oct 2, 2007•25 citations

Long, high -gradient magnetic atom guide and progress towards an atom laser.

Spencer E. Olson

The continuous injection and propagation of a cold atomic beam in a 1.7 m long high-gradient (up to 2.7 kG/cm) magnetic guide is demonstrated. Continuous injection is accomplished by side-loading a magnetic guide with atoms from a sequence of two modified magneto-optical traps. In the high-gradient portion of the guide, the guided atomic beam has a transverse temperature of 420 muK +/- 40 muK, a longitudinal temperature of 1 mK, and an average velocity of order 1 m/s. Essential for the characterization of this steady-state atomic beam, imaging methods compatible with the high field-gradients associated with this magnetic guide have been investigated and developed. By utilizing a probe laser tuned to an open transition, the fluorescence yield per atom is largely fixed throughout the trap volume, independent of the trapping field. This enables a reliable conversion of fluorescence images into atomic-density profiles. Using a fixed radio-frequency (nurf) current coupled directly onto the guide wires, continuous and selective removal of atoms with a transverse energy exceeding hnurf is demonstrated. This removal scheme is the essence of an rf filter, where the number of modes occupied by the atomic flow is reduced. Through sufficient rf-filtering, a near-single-mode guided atomic beam should be achievable, enabling basic atom-interferometric experiments. The extension of this fixed-frequency removal of atoms for continuous position-resolved evaporative cooling in a long magnetic guide is outlined. Employing an innovative gridless technique for performing Direct Simulation of rarefied gas dynamics via Monte Carlo (DSMC), the evaporative cooling process in a guided atomic beam has been simulated. Both fixed-frequency as well as variable-frequency evaporative cooling layouts have been explored and the results of these simulations are presented. The implementation of this gridless technique is presented and its benefits are briefly outlined. In parallel with the development of a continuous-wave atom laser, tools suited to manipulate cold atomic beams in atom guides have been explored. An atomic guide with a tunable aspect ratio, using rf-dressed state potentials, is presented.

•Jan 1, 2006•0 citations
It was recently demonstrated that wire-guide roughness can be suppressed by modulating the wire currents so that the atoms experience a time-averaged potential without roughness [Trebbia et al., Phys. Rev. Lett. 98, 263201 (2007)]. In this paper, we theoretically study the limitations of this technique. At low modulation frequency, we show that the longitudinal potential modulation produces heating of the cloud, and we compute the heating rate. We also give a quantum derivation of the rough conservative potential associated with the micromotion of the atoms. At large modulation frequency, we compute the loss rate due to nonadiabatic spin flip and show that it presents resonances at multiple modulation frequencies. These studies show that the modulation technique works for a wide range of experimental parameters. We also give conditions to realize radio-frequency evaporative cooling in such a modulated trap.
We present a method to suppress the potential roughness of a wire-based, magnetic atom guide: modulating the wire current at a few tens of kHz, the potential roughness, which is proportional to the wire current, averages to zero. Using ultra-cold 87rmRb^{87}{\\rm Rb}87rmRb clouds, we show experimentally that modulation reduces the roughness by at least of a factor five without measurable heating or atom loss. This roughness suppression results in a dramatic reduction of the damping of center of mass oscillations.
Trapping and manipulating ultracold atoms through the use of atom chips offers the ability to engineer complex electromagnetic field geometries in a compact form factor. One of the primary limitations hindering their use is trap potential roughness which arises as a result of defects in the atom chip wires when atoms are brought close to the chip. This roughness can play a limiting role in atom interferometry and strong 1D confinement experiments. We present an initial experimental demonstration of atom chip potential roughness suppression using radio-frequency (RF) AC Zeeman (ACZ) potentials on an atom chip. Using ∼20 MHz RF magnetic near-fields from the chip to target intra-manifold transitions in the 87Rb ground state, we trap atoms in a spindependent ACZ potential. We compare the axial trapping potential for atoms in comparable 2-wire DC and AC Zeeman traps and show evidence of roughness suppression in the AC trap.
We present several toy models for predicting the character and strength of the roughness of ac Zeeman trapping potentials generated by imperfections in wire traces on an atom chip. An ac Zeeman trapping potential is generated by targeting a microwave or rf magnetic field at hyperfine or Zeeman ground-state transitions, respectively, while a dc Zeeman trap uses a static magnetic field to manipulate an atom via its magnetic moment. We find that an ac Zeeman trap suppresses potential roughness by several orders of magnitude with respect to a comparable dc Zeeman trap. This suppression stems from the inherent differences between an atom's response to dc and ac (namely rf and microwave) magnetic fields, in concert with how the ac skin effect smooths out a current distribution disturbed by a conductivity variation. For chip wires fabricated by evaporation, we find that an ac Zeeman trap for 87Rb^{87}\mathrm{Rb}87Rb atoms, located $100\phantom{\rule{4pt}{0ex}}\ensuremath{\mu}\mathrm{m}$ from the chip and operating on a 6.8 GHz hyperfine transition, is expected to suppress potential roughness by a factor of $4\ifmmode\times\else\texttimes\fi{}{10}^{5}$ compared with a similar dc Zeeman trap. For a comparable ac Zeeman trap operating on a 10 MHz Zeeman transition, the suppression is $2\ifmmode\times\else\texttimes\fi{}{10}^{4}$. Conversely, the ac skin effect also slightly exacerbates potential roughness, in ac Zeeman traps, from defects in the sidewall of a wire trace.
We observe the spontaneous evaporation of atoms confined in a bubble-like radio frequency (rf)-dressed trap (Zobay and Garraway 2001 Phys. Rev. Lett. 86 1195; 2004 Phys. Rev. A 69 023605). The atoms are confined in a quadrupole magnetic trap and are dressed by a linearly polarized rf field. The evaporation is related to the presence of holes in the trap, at the positions where the rf coupling vanishes, due to its vectorial character. The final temperature results from a competition between residual heating and evaporation efficiency, which is controlled via the height of the holes with respect to the bottom of the trap. The experimental data are modelled by a Monte Carlo simulation predicting a small increase in phase-space density limited by the heating rate. This increase was within the phase-space density determination uncertainty of the experiment.
The continuous injection and propagation of a cold atomic beam in a 1.7 m long high-gradient (up to 2.7 kG/cm) magnetic guide is demonstrated. Continuous injection is accomplished by side-loading a magnetic guide with atoms from a sequence of two modified magneto-optical traps. In the high-gradient portion of the guide, the guided atomic beam has a transverse temperature of 420 muK +/- 40 muK, a longitudinal temperature of 1 mK, and an average velocity of order 1 m/s. Essential for the characterization of this steady-state atomic beam, imaging methods compatible with the high field-gradients associated with this magnetic guide have been investigated and developed. By utilizing a probe laser tuned to an open transition, the fluorescence yield per atom is largely fixed throughout the trap volume, independent of the trapping field. This enables a reliable conversion of fluorescence images into atomic-density profiles. Using a fixed radio-frequency (nurf) current coupled directly onto the guide wires, continuous and selective removal of atoms with a transverse energy exceeding hnurf is demonstrated. This removal scheme is the essence of an rf filter, where the number of modes occupied by the atomic flow is reduced. Through sufficient rf-filtering, a near-single-mode guided atomic beam should be achievable, enabling basic atom-interferometric experiments. The extension of this fixed-frequency removal of atoms for continuous position-resolved evaporative cooling in a long magnetic guide is outlined. Employing an innovative gridless technique for performing Direct Simulation of rarefied gas dynamics via Monte Carlo (DSMC), the evaporative cooling process in a guided atomic beam has been simulated. Both fixed-frequency as well as variable-frequency evaporative cooling layouts have been explored and the results of these simulations are presented. The implementation of this gridless technique is presented and its benefits are briefly outlined. In parallel with the development of a continuous-wave atom laser, tools suited to manipulate cold atomic beams in atom guides have been explored. An atomic guide with a tunable aspect ratio, using rf-dressed state potentials, is presented.